Abstract
Corrosion of steel bars in concrete is a major problem reducing concrete structure lifetime that must be considered in the design of structures. Many parameters involved in corrosion propagation contain different uncertainties; therefore, probabilistic analysis should be performed. In this paper, we proposed a reliability analysis method for RC frames subjected to simultaneous corrosion and static loads. It consists of the analysis of an arbitrary 2D frame at each time step to take into account the steel bars mass loss due to corrosion. We calculated instantaneous load-bearing capacity of elements. Analysis outputs would be extracted, and the probability of failure and reliability index could be calculated in each time step. Moreover, we conducted the sensitivity analysis for some parameters. It is shown that various parameters such as cover thickness, dimensions, strength of materials and reinforcements how could improve vulnerability of concrete structure subjected to corrosion. We obtained outputs based on various corrosion models proposed by different researchers. Obtained results were compared with one another, and they have good agreement with experimental results in the literature. Proposed method shows that corrosion process could decrease strength of structural elements significantly.
Similar content being viewed by others
References
Bertolini L., Elsener B., Pedeferri P., Polder R.: Corrosion of Steel in Concrete. Wiley-VCH, Weinheim (2004)
Broomfield J.: Corrosion of Steel in Concrete: Understanding, Investigation and Repair. Taylor & Francis, London (1997)
Matthews, S.; Jacobs, J.: Concrete Structure Management - Owners’ Guide to Good Practice. Digest G 510, HIS BRE Press, Carston, Watford (2009)
Kashani M., Crewe A., Alexander N.: Nonlinear stress–strain behaviour of corrosion-damaged reinforcing bars including inelastic buckling. Eng. Struct. 48, 417–429 (2013)
Rothwell G.: Corrosion monitoring: some techniques and applications. NDT Int. 11(3), 108–111 (1978)
Song, G.; Shayan, A.: Corrosion of Steel in Concrete: Causes, Detection and Prediction, review report no. 4. ARR Transport Research Ltd, Bentley (1998)
Gaon J., Wu J., Li J., Zhao X.: Monitoring of corrosion in reinforced concrete structure using Bragg grating sensing. NDT&E Int. 44, 202–205 (2011)
Tuutti K.: Corrosion of Steel in Concrete. Swedish Cement and Concrete, Stochkolm (1982)
Crank J.: The Mathematics of Diffusion. The Clarendon Press, Oxford (1956)
Cady P., Weyers R.: Deterioration rates of concrete bridge. J. Transp. Eng. 110(1), 34–45 (1984)
Takewaka K., Matsumoto S.: Quality and cover thickness of concrete based on the estimation of chloride penetration in marine environments. ACI Spec. Publ. 109, 381–400 (1988)
Bazant, Z.: Physical model for steel corrosion in sea structures: applications. J. Struct. Div. 105(6), 1155–1166 (1979)
Bazant, Z.: Physical model for steel corrosion in sea structures: theory. J. Struct. Div. 105(6), 1137–1153 (1979)
Morinaga, S.: Prediction of Service Lives of Reinforced Concrete Buildings Based on Rate of Corrosion of Reinforcing Steel. Special Report of the Institute of Technology, Skimiza Corporation, Japan (1989)
Liu, Y.: Modeling the Time-to-Corrosion Cracking of the Cover Concrete in Chloride Contaminated Reinforced Concrete Structures. State University, Blacksburg (1996)
Alonso, C.; Andrade, C.; Gonzalez, J.: Relation between resistivity and corrosion rate of reinforcements in carbonated mortar made with several cement types. Cem. Concr. Res. 18(5), 687–698 (1988)
Vu K., Stewart M.: Structural reliability of concrete bridges including improved chloride-induced corrosion models. Struct. Saf. 22, 313–333 (2000)
Ahmad S., Bhattacharjee B.: Empirical modelling of indicators of chloride-induced rebar corrosion. J. Struct. Eng. 27(3), 195–207 (2000)
Liu T., Weyers R.: Modeling the dynamic corrosion process in chloride contaminated concrete structures. Cem. Concr. Res. 28(3), 365–379 (1998)
Ghods, P.; Isgor, O.; Pour-Ghaz, M.: Experimental verification and application of a practical corrosion model for uniformly depassivated steel in concrete. Mater. Struct. 41(7), 1211–1223 (2008)
Yu B., Yang L., Wua M., Li B.: Practical model for predicting corrosion rate of steel reinforcement in concrete structures. Constr. Build. Mater. 54, 385–401 (2014)
Melchers R.E., Li C.Q., Lawanwisut W.: Probabilistic modeling of structural deterioration of reinforced concrete beams under saline environment corrosion. Struct. Saf. 30, 447–460 (2008)
Jiang J., Yuan Y.: Prediction model for the time-varying corrosion rate of rebar based on micro-environment in concrete. Constr. Build. Mater. 35, 625–632 (2012)
Thoft-Christensen, P.; Jensen, F.M.; Middleton, C.; Blackmore, A.: Assessment of the reliability of concrete slab bridges. In: 7th IFIP WG 7.5 Working Conference, Boulder, CO, USA, April 2–4, pp. 321–328 (1996)
Enright M., Frangopol D.: Probabilistic analysis of resistance degradation of reinforced concrete bridge beams under corrosion. Eng. Struct. 20(11), 960–971 (1998)
Stewart M., Rosowsky D.: Time-dependent reliability of deteriorating reinforced concrete bridge decks. Struct. Saf. 20, 91–109 (1998)
Marsh P., Frangopol D.: Reinforced concrete bridge deck reliability model incorporating temporal and spatial variations of probabilistic corrosion rate sensor data. Reliab. Eng. Syst. Saf. 93(3), 394–409 (2008)
Papakonstantinou K., Shinozuka M.: Probabilistic model for steel corrosion in reinforced concrete structures of large dimensions considering crack effects. Eng. Struct. 57, 306–326 (2013)
Hoffman, P.C.; Weyers, R.E.: Predicting critical chloride levels in concrete bridge decks. Structural safety and reliability. In: Proceedings of the ICOSSAR ’93, Rotterdam, pp. 957–959 (1994)
Lentz, A.; Faber, M.H.; Johnson, T.: Half-cell potential measurements for condition assessment. In: 1st International Conference on Bridge Maintenance, Safety and Reliability, July 14–17, Barcelona, Spain, pp. 365-366 (2002)
Li C., Lawanwisut W., Zheng J., Kijawatworawet W.: Crack width due to corroded bar in reinforced concrete structures. Int. J. Mater. Struct. Reliab. 3(2), 87–94 (2005)
Melchers R.E., Li C.Q.: Phenomenological modelling of corrosion loss of steel reinforcement in marine environments. ACI Mater. J. 103(1), 25–32 (2006)
Standard, C.S.A. “A23.3-04” Design of concrete structures, Canadian Standard Association, Ontario (2004)
Lounis, Z.; Mirza, M.S.: Reliability-based service life prediction of deteriorating concrete structures. In: Proceedings of the 3rd International Conference on Concrete Under Severe Conditions, Vancouver, BC, Canada, pp. 965–972 (2001)
Al-Sulaimani G.J., Kaleemullah M., Basunbul I.A.R.: Influence of corrosion and cracking on bond behavior and strength of reinforced concrete members. ACI Struct. J. 87(2), 220–231 (1990)
El Maaddawy T., Soudki K., Topper T.: Long-term performance of corrosion damaged reinforced concrete beams. ACI Struct. J. 102(5), 649–659 (2005)
Azad A.K., Ahmad S., Azher S.A.: Residual strength of corrosion-damaged reinforced concrete beams. ACI Mater. J. 104(1), 40–47 (2007)
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Tarighat, A., Zehtab, B. Structural Reliability of Reinforced Concrete Beams/Columns Under Simultaneous Static Loads and Steel Reinforcement Corrosion. Arab J Sci Eng 41, 3945–3958 (2016). https://doi.org/10.1007/s13369-016-2033-6
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s13369-016-2033-6