Skip to main content
Log in

Dynamic monitoring of bridges during static load tests: influence of the dynamics of trucks on the modal parameters of the bridge

  • Original Paper
  • Published:
Journal of Civil Structural Health Monitoring Aims and scope Submit manuscript

Abstract

This paper presents results of an extensive experimental campaign carried out during the construction phases of a base-isolated bridge across the Potenza river in central Italy. The structure is constituted by a half-through steel arch bridge composed by two coupled weathering steel tubular arches sustained by thirty couples of hangers and by two approaching viaducts. The bridge has a continuous twin-girder steel–concrete composite deck. During construction, impact load tests were carried out on hangers as well as on other tie elements to estimate their tension force from the relevant resonance frequencies. During the proof test, relative displacements occurred between the upper and lower plates of the seismic isolators are measured for different loading conditions. In addition, ambient vibration tests are performed during the final static load tests to investigate the bridge dynamics subjected to different loading conditions. Comparisons of test results with the numerical predicted values contributed to evaluate the consistency between the design and the real structure at different construction stages. Dynamic identification tests contributed to identify the significance of the truck–bridge interaction in the interpretation of the bridge dynamics evaluated experimentally.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15

Similar content being viewed by others

References

  1. Lantsoght EOL, van der Veen C, de Boer A, Hordijk DA (2017) State-of-the-art on load testing of concrete bridges. Eng Struct 150:2131–2241

    Article  Google Scholar 

  2. Dall’Asta A, Ragni L, Zona A, Nardini L, Salvatore W (2016) Design and experimental analysis of an externally prestressed steel and concrete footbridge equipped with vibration mitigation devices. J Bridge Eng 21(8):C5015001

    Article  Google Scholar 

  3. EN-1990, EC0 (1990) Basis of structural design. European Community for Standardization, Brussels

    Google Scholar 

  4. EN1992-2 (2005) Eurocode 2: design of concrete structures—Part 2: concrete bridges—design and detailing rules. European Community for Standardization, Brussels

    Google Scholar 

  5. EN1993-2 (2006) Eurocode 3: design of steel structures—Part 2: steel bridges. European Community for Standardization, Brussels

    Google Scholar 

  6. AASHTO (2011) The manual for bridge evaluation. American Association of State Highway and Transportation Officials, Washington

    Google Scholar 

  7. Research Institute of Roads and Bridges (2008) The rules for road bridges proof loadings. RIRB, Warsaw (in Polish)

    Google Scholar 

  8. Ministerio de Fomento Direccion General de Carreteras (1999) Recomendaciones para la realización de pruebas de carga de repectión en punetes de carretera. Ministerio de Fomento, Madrid

    Google Scholar 

  9. SIA (2011) Existing structures—bases for examination and interventions SIA 505 269:2011, SIA Schweizerischer Ingenieur und Architecktenverein. Zurich (in German)

  10. D.M.14.01.2008, Approvazione delle nuove norme tecniche per le costruzioni, Ministero delle Infrastrutture, G.U. n.29, 04.02.2008 (in Italian)

  11. D.M.17.01.2018, Aggiornamento delle « Norme Tecniche per le Costruzioni » , Ministero delle Infrastrutture e dei Trasporti, G.U. n.42, 20.02.2018 (in Italian)

  12. Circolare 21.01.2019, n.7, Istruzioni per l’applicazione dell’ « Aggiornamento delle “Norme tecniche per le costruzioni” » , di cui al D.M. 17 gennaio 2018. Consiglio Superiore dei Lavori Pubblici, G.U.—supplemento ordinario n.5, 11.02.2019 (in Italian)

  13. Clemente P, Marulo F, Lecce L, Bifulco A (1998) Experimental modal analysis of the Garigliano cable-stayed bridge. Soil Dyn Earthq Eng 17(7–8):485–493

    Article  Google Scholar 

  14. Gara Fabrizio, Regni Marco, Roia Davide, Carbonari Sandro, Dezi Francesca (2019) Evidence of coupled soil-structure interaction and site response in continuous viaducts from ambient vibration tests. Soil Dyn Earthq Eng 120:408–422

    Article  Google Scholar 

  15. Conte JP, He X, Moaveni B, Masri SF, Caffrey JP, Wahbeh M, Tasbihgoo F, Elgamal DH, Whang A (2008) Dynamic testing of Alfred Zampa memorial bridge. J Struct Eng 134(6):1006–1015

    Article  Google Scholar 

  16. Zonta D, Glisic B, Adriaenssens S (2014) Value of information: impact of monitoring on decision-making. Struct Control Health Monit 21(7):1043–1056

    Article  Google Scholar 

  17. Cabboi A, Magalhães F, Gentile C, Cunha Á (2017) Automated modal identification and tracking: application to an iron arch bridge. Struct Control Health Monit 24(1):e1854

    Article  Google Scholar 

  18. Rainieri C, Gargaro D, Fabbrocino G, Maddaloni G, Di Sarno L, Prota A, Manfredi G (2018) Shaking table tests for the experimental verification of the effectiveness of an automated modal parameter monitoring system for existing bridges in seismic areas. Struct Control Health Monit 25(7):e2165

    Article  Google Scholar 

  19. Cunha Á, Caetano E, Magalhães F, Moutinho C (2018) Dynamic identification and continuous dynamic monitoring of bridges: different applications along bridges life cycle. Struct Infrastruct Eng 14(4):445–467

    Article  Google Scholar 

  20. Cao WJ, Koha CG, Smith IFC (2019) Enhancing static-load-test identification of bridges using dynamic data. Eng Struct 186:410–420

    Article  Google Scholar 

  21. Bayraktar A, Türker T, Tadla J, Kurşun A, Erdiş A (2017) Static and dynamic field load testing of the long span Nissibi cable-stayed bridge. Soil Dyn Earthq Eng 94:136–157

    Article  Google Scholar 

  22. Cantero D, Gonzales A, Obrien E (2011) Comparison of bridge dynamic amplifications due to articulated 5-axle trucks and large cranes. Baltic J Road Bridge Eng 6(1):39–47

    Article  Google Scholar 

  23. Brady SP, O’Brien EJ (2006) Effect of vehicle velocity on the dynamic amplification of two vehicles crossing a simply supported bridge. J Bridge Eng 11(2):250–256

    Article  Google Scholar 

  24. Lak MA, Degrande G, Lombaert G (2011) The effect of road unevenness on the dynamic vehicle response and ground-borne vibrations due to road traffic. Soil Dyn Earthq Eng 31(10):1357–1377

    Article  Google Scholar 

  25. Cantero D, Hester D, Brownjohn J (2017) Evolution of bridge frequencies and modes of vibration during truck. Eng Struct 152:452–464

    Article  Google Scholar 

  26. Paraskeva TS, Dimitrakopoulos EG, Zeng Q (2017) Dynamic vehicle-bridge interaction under simultaneous vertical earthquake excitation. Bull Earthq Eng 15:71–95

    Article  Google Scholar 

  27. Kameshwar S, Padgett JE (2018) Effect of vehicle bridge interaction on seismic response and fragility of bridges. Earthq Eng Struct Dyn 47:697–713

    Article  Google Scholar 

  28. Tsai MH (2008) Transverse earthquake response analysis of a seismically isolated regular bridge with partial restraint. Eng Struct 30(2):393–403

    Article  Google Scholar 

  29. Tubaldi E, Dall’Asta A (2012) Transverse free vibrations of continuous bridges with abutment restraint. Earthq Eng Struct Dyn 41(9):1319–1340. https://doi.org/10.1002/eqe.1190. ISSN: 0098-8847, eISSN: 1096-9845

    Article  Google Scholar 

  30. Tubaldi E, Dall’Asta A, Dezi L (2015) Seismic response analysis of continuous multispan bridges with partial isolation. Shock Vib 2015:1–15. https://doi.org/10.1155/2015/183756

    Article  Google Scholar 

  31. Tubaldi E, Dall’Asta A (2011) A design method for seismically isolated bridges with abutment restraint. Eng Struct 33(3):786–795. ISSN: 0141-0296

  32. Tubaldi E, Dall’Asta A, Dezi L (2013) Reduced formulation for post-elastic seismic response of dual-load path bridges/ Eng Struct 51:178–187. https://doi.org/10.1016/j.engstruct.2011.12.026. ISSN: 0141-0296

    Article  Google Scholar 

  33. National Instruments (1997) LabVIEW signal processing course manual. National Instruments Corporate Headquarters

  34. Cantieni R (2005) Experimental methods used in system identification of civil engineering structures. In: Proceedings of the 1st international operational modal analysis conference, Copenhagen, Denmark, pp 249–260 (2005)

  35. Juang J-N (1994) Applied system identification. Prentice-Hall, Englewood Cliffs

    MATH  Google Scholar 

  36. Van Overschee P, De Moor B (1996) Subspace identification for linear systems: theory, implementation, applications. Kluwer Academic Publishers, Dordrecht

    Book  Google Scholar 

  37. Allemang RJ, Brown DL (1982) A correlation coefficient for modal vector analysis. In; Proceedings of the 1st International Modal Analysis Conference, Bethel, CT, USA, pp 110–115

  38. SAP2000 advanced (2009) (v15.0.0) Static and dynamic finite element analysis of structures. CSI Computer & Structures, Inc, Berkeley

  39. Buckingham E (1914) On physically similar systems; illustrations of the use of dimensional equations. Phys Rev 4(4):345–376

    Article  Google Scholar 

  40. Den Hartog JP (1956) Mechanical vibrations. McGrow-Hill, New York

    MATH  Google Scholar 

  41. El Madany MM (1988) Design and optimization of truck suspensions using covariance analysis. Comput Struct 8(2):241–246

    Google Scholar 

  42. Peeters B, Olofsson M, Nilsson P (2007) Test-based dynamic characterizing of a complete truck by Operational Modal Analysis. In: Proceedings of IOMAC 2007, the international operational modal analysis conference, Copenhagen, Denmark, 1–2 May 2007

  43. Peeters B, Servaye, JS, De Cock J (2008) Truck applications of operational modal analysis. In: Conference proceedings of the society for experimental mechanics series, 26th conference and exposition on structural dynamics 2008, IMAC-XXVI; Orlando, FL, USA; 4–7 Feb 2008

  44. Swaminathan B, Sharma B, Allemang RJ, Chauhan S (2008) Modal studies on a truck frame and suspension. In: 23rd international conference on noise and vibration engineering, ISMA 2008, vol 5, Leuven, Belgium; 15–17 Sept 2008, pp 2593–2608

Download references

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Andrea Dall’Asta.

Additional information

Publisher's Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Gara, F., Nicoletti, V., Carbonari, S. et al. Dynamic monitoring of bridges during static load tests: influence of the dynamics of trucks on the modal parameters of the bridge. J Civil Struct Health Monit 10, 197–217 (2020). https://doi.org/10.1007/s13349-019-00376-1

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s13349-019-00376-1

Keywords

Navigation