Abstract
In this paper the prediction of tool wear on carbide uncoated tools was taken into account. In particular, two different tool wear models based on the diffusion mechanism and on the abrasion mechanism were considered. The calibration of the utilized models was done using the results obtained by experimental analysis performed on an orthogonally machined AISI 1020 tube. Once the calibration was executed, numerical simulations, for both the utilized tool wear models, were simultaneously performed with the aim to test the capability of the proposed numerical procedure. The comparison between the two tool wear mechanisms for predicting the flank tool wear is discussed in the paper.
This is a preview of subscription content, log in via an institution to check access.
References
M.C. Shaw, Metal Cutting Principles (2nd Ed.), Oxford Science Publications (2005).
V.P. Astakhov, The assessment of cutting tool wear, International Journal of Machine Tools & Manufacture, 44 (2004) 637–647.
L. Filice, F. Micari, L. Settineri, D. Umbrello, On the finite element simulation of thermal phenomena in machining processes, Advanced Methods in Material Forming, (2007) 263–278.
H. Takeyama, T. Murata, Basic investigations on tool wear, Trans. of the ASME - J. Eng. Ind., 85 (1963) 33–38.
E. Usui, T. Shirakahi and T. Kitagawa, Analytical Prediction of Cutting Tool Wear, Wear, 100 (1984) 129–151.
E. Rabinowicz, L. A. Dunn and P. G. Russell, A study of abrasive wear under three-body conditions, Wear, 4 (1961) 345.
L. Filice, D. Umbrello, F. Micari, L. Settineri, Wear modelling in mild steel orthogonal cutting when using uncoated carbide tools, Wear, 262/5–6 (2007) 545–554.
Suhas V. Patankar, Numerical Heat Transfer and Fluid Flow, Hemisphere Publishing Corporation (1980).
T. Matsumura, T. Obikawa, T. Shirakashi and E. Usui, Automonus Turning Operation Planning with Predicting Tool Wear and Surface Roughness, In: Transactions of the North American Manufacturing Institution of SME, 21 (1993) 359–366.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Umbrello, D., Filice, L., Micari, F. et al. Prediction of Tool Wear Progress in Machining of Carbon Steel using different Tool Wear Mechanismsl. Int J Mater Form 1 (Suppl 1), 571–574 (2008). https://doi.org/10.1007/s12289-008-0320-9
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12289-008-0320-9