Abstract
Rosacea is a chronic multifactorial vascular skin disorder that affects about 10 percent of the general population. Metronidazole is an effective antibiotic in the treatment of moderate-tosevere rosacea. Metronidazole is a suitable drug in cases of resistance to tetracycline or erythromycin, but it has also been shown that oral metronidazole may increase the side effects (e.g., peripheral neuropathy). Oral metronidazole should not be used for more than three months, and hence topical metronidazole gel is the best therapeutic choice in rosacea (especially during pregnancy). This study examined the mechanical (adhesiveness, cohesiveness, extrudability, spreadability, homogeneity) and rheological (viscosity), skin irritant and drug release properties of different metronidazole gel formulations that contain anionic emulsifying wax, glycerin and lactic acid in different proportions. The release studies were conducted using Franz diffusion cells and Silastic membrane as a barrier. The results indicated that gel compressibility, hardness, and adhesiveness, are the factors that influence the ease of gel removal from the container, ease of gel application onto the mucosal membrane, and gel bioadhesion. The findings showed that there exists a strong negative correlation between the spreadability of a formulation and its cohesiveness, the spreadability of a formulation is inversely proportional to its cohesiveness. However, sorbitol solution (70%) concentration was not significantly correlated with drug release. In addition, drug release was significantly reduced as the concentration of anionic emulsifying wax increased and the concentration of lactic acid decreased. The maximum metronidazole release was achieved at a pH of 4–6. Data obtained from in vitro release studies were fitted to various kinetic models and high correlation was obtained in the Higuchi and first order models. The results showed that all the gel formulations showed good extrudability, viscosity, cohesiveness, homogeneity and spreadability.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Ahuja, A., Khar, R. K., and Ali, J., Mucoadhesive drug delivery systems. Drug Dev. Ind. Pharm., 23, 489–515 (1997).
Bhalla, V. H. and Deshpande, S. G., In Proceedings of International Symposium on innovation in Pharmaceutical Sciences and Technology, Sri, B. V. (Ed.). Patel Education Trust, pp. 74, (1990).
Choi, H. K., Jung, J. H., Ryu, J. M, Yoon, S. J., Oh, Y. K., and Kim, I. S., Trails of in-situ gelling and mucoadhesive acetaminophen liquid suppository. Int. J. Pharm., 165, 33–44 (1998).
Colombo, P., Catellani, P. L., Peppas N. A., Maggi L., and Conte, U., Swelling characteristics of hydrophilic matrices for controlled release. New dimensionless number to describe the swelling and release behavior. Int. J. Pharm., 88, 99–109 (1992).
Daniel, W. W., Biostatic: A foundation for analysis in the health sciences, 6th ed. John Wiely & Sons Inc., pp. 295–296, (1995).
DeMartine, M. L. and Cussler, E. L., Predicting subjective spreadability, viscosity, and stickiness. J. Pharm. Sci., 64, 976–982 (1975).
De Paula, I. C., Ortega, G. G., Bassani, V. L., and Petrovick, P. R., Development of ointment formulations prepared with achyrocline satureioides spray-dried extracts. Drug Dev. Ind. Pharm., 24, 235–241 (1998).
Fang, J. Y., Hwang, T. L., and Leu, Y. L., Effect of enhancers and retarders on percutaneous absorption of flurbiprofen from hydrogels. Int. J. Pharm., 250, 313–325 (2003).
Hadi, I. A., Ugriné, H. E., Farouk, A. M., and Shayoub, M., Formulation of polyethylene glycol ointment bases suitable for tropical and subtropical climates. I. Acta Pharm. Hung., 59, 137–142 (1989).
Hunt, G., Kearney, P., and Kellaway I. W., Mucoadhesive polymers in drug delivery systems, In Johnson, P., Lloyd Jones, J. G., and Ellis, H. (Eds.). Drug delivery systems. Fundamentals and Techniques. England, pp. 180–199, (1987).
Jones, D. S., Woolfson, A. D., and Brown A. F., Textural analysis and flow rheometry of novel, bioadhesive antimicrobial oral gels. Pharm. Res., 14, 450–457 (1997).
Keller, T., Zulliger, H. W., and Niederer, R., Simple model for measuring spreadability of suppository bases. Acta Pharm. Technol., 28, 277–286 (1982).
Korsmeyer, R. W., Gurny, R., Doelker E., Buri P., and Peppas, N. A., Mechanism of solute release from porous hydrophilic polymer. Int. J. Pharm., 15, 25–35 (1983).
Mikos, A. G. and Peppas, N. A., Bioadhesive analysis of controlled-release systems. IV. An experimental method for testing the adhesion of microparticles with mucus. J. Control. Release, 12, 31–37 (1990).
Miyachi, Y., Imamura, S., and Niwa, Y., Anti-oxidant action of metronidazole: a possible mechanism of action in rosacea. Br. J. Dermatol., 114, 231–234 (1986).
Nyman-Pantelidis, M., Nilsson, A., Wagner, Z. G., and Borgå, O., Pharmacokinetics and retrograde colonic spread of budesonide enemas in patients with distal ulcerative colitis. Aliment. Pharmacol. Ther., 8, 617–622 (1994).
Panigrahi, L., John, T., Shariff, A., Rani, S., and Hiremath, R., Formulation and evaluation of lincomycin HCL gels. Ind. J. Pharm. Sci., 59, 330–332 (1997).
Park, K. and Robinson, J. R., Bioadhesive polymers as platforms for oral-controlled drug delivery: method to study bioadhesion. Int. J. Pharm., 19, 107–127 (1984).
Rance, R. W., Studies of the factors controlling the action of hair sprays. I: The spreading of hair spray resin solutions on hair. J. Soc. Cosmet. Chem., 24, 501–522 (1973).
Raymond, C. R., Paul, J. Sh., Paul, J. W., Ray, R., Paul, Sh., and Paul, W., Hand book of pharmaceutical excipient, 4th Ed. Pharmaceutical press, London, pp. 35–37, (2004).
Ritger, P. L. and Peppas, N. A., A simple equation for description of solute release I. Fickian and non-fickian release from non-swellable devices in the form of slabs, spheres, cylinders, or discs. J. Control. Release, 5, 23–36 (1987).
Sande, M. A. and Mandell, G. L., Chemotherapy of microbial diseases. In Goodman, Gillman (ed). The pharmacological basis of therapeutics, 8th Ed. Maxwell Macmillan, New York, pp. 1018–1200, (1991).
Sanders, L. M., Kent, J. S., McRae, G. I., Vickery, B. H., Tice, T. R., and Lewis, D. H., Controlled release of luteinizing hormone releasing analogue from poly (D, L-Lactide-coglycolide) microspheres. Int. Pharm. Sci., 1, S385 (1999).
Vennat, B., Gross, D., Pouget, M. P., Pourrat, A., and Pourrat, H., Comparison of the physical stability of astringent hydrogels based on cellulose derivatives. Drug Dev. Ind. Pharm., 21, 559–570 (1995).
Waite, J. H., Marine adhesive proteins: natural composite thermosets. Int. J. Biol. Macromol., 12, 139–144 (1990).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Jelvehgari, M., Montazam, H. Evaluation of mechanical and rheological properties of metronidazole gel as local delivery system. Arch. Pharm. Res. 34, 931–940 (2011). https://doi.org/10.1007/s12272-011-0610-5
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12272-011-0610-5