Abstract
Natural gas fuel, as an alternative energy source of transportation, has been used widely since it has an advantage of low emission levels. However, new technologies are required in order to meet the reinforced emission regulations. For this purpose, research into the development of hydrogen-compressed natural gas (HCNG) blend engine was carried out to evaluate its feasibility and emission characteristics. The Engine Research Department at the Korea Institute of Machinery and Materials carried out a large number of tests based on various parameter changes that could affect the performance and emission of HCNG engine in different operating conditions. An earlier stage of the research project focused on the lean combustion of a HCNG engine for heavy duty vehicles to meet the EURO-VI standards. An 11-L/6-cylinder CNG engine was used for the test. The effects of the excess air ratio change were assessed based on various content ratios of hydrogen in the natural gas fuel. In the later part of the HCNG research, a stoichiometric mixture operation was suggested to meet reinforced emission regulation without requiring a De-NOx system. Additionally, an exhaust gas recirculation (EGR) system was introduced for the purpose of improving thermal efficiency and durability. The optimal operating conditions were selected to achieve the best thermal efficiency to meet the required emission levels. In this paper, we demonstrate that a HCNG engine can achieve a significant decrease in NOx emissions, as compared to that of a CNG engine, while meeting the requirements of the EURO-VI standards during a transient mode cycle test. EGR can suppress the weakness of stoichiometric mixture combustion strategy, such as the deterioration of the durability and thermal efficiency, while the emission level can be lowered with the use of a three-way catalyst. The possibility of further reduction of emissions and CO2 with EGR was evaluated to access practical application of a HCNG engine in the field. From that evaluation, the HCNG engine with stoichiometric mixture operation for heavy duty vehicles was developed. The emission levels of HCNG engine were 50 % lower when compared to the EURO-VI standards with a greater than 10 % decrease in CO2 compared to that of a natural gas engine.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Benz, M., Hoffmann, K., Weirich, M. and Herrmann, H. O. (2014). The new euro V Inatural gas engine for Mercedes-Benz medium duty commercial vehicles. 35th Int. Vienna Motor Symp.
Collier, K., Mulligan, N., Shin, D. and Brandon, S. (2005). Emission results from the new development of a dedicated hydrogen–Enriched natural gas heavy duty engine. SAE Paper No. 2005-01-0235.
Cummins Westport (2015). http://www.cumminswstport.com/models
Dickinson, R. R., Battye, D. L., Linton, V. M., Ashman, P. J. and Nathan, G. J. (2010). Alternative carriers for remote renewable energy sources using existing CNG infrastructure. Int. J. Hydrogen Energy 35, 3, 1321–1329.
Hupperich, P. and Dürnholz, M. (1996). Exhaust emissions of diesel, gasoline and natural gas fuelled vehicles. SAE Paper No. 960857.
Karim, G. A., Wierzba, I. and Al-Alousi, Y. (1996). Methane-hydrogen mixtures as fuels. Int. J. Hydrogen Energy, 21, 7, 625–631.
Kukkonen, C. and Shelef, M. (1994). Hydrogen as an alternative automotive fuel. SAE Paper No. 940766.
Lee, S., Park, C., Park, S. and Kim, C. (2014). Comparison of the effects of EGR and lean burn on an SI engine fueled by hydrogen-enriched low calorific gas. Int. J. Hydrogen Energy 39, 2, 1086–1095.
Lim, G., Lee, S., Park, C., Choi, Y. and Kim, C. (2013a). Effects of compression ratio on performance and emission characteristics of heavy-duty SI engine fueled with HCNG. Int. J. Hydrogen Energy 38, 11, 4831–4838.
Lim, G., Lee, S., Park, C., Choi, Y. and Kim, C. (2013b). Knock and emission characteristics of heavy-duty HCNG engine with modified compression ratios. SAE Paper No. 2013-01-0845.
Lim, G., Lee, S., Park, C., Choi, Y. and Kim, C. (2014). Effect of ignition timing retard strategy on NOx reduction in hydrogen-compressed natural gas blend engine with increased compression ratio. Int. J. Hydrogen Energy 39, 5, 2399–2408.
Noble, A. (2016). EURO 7 ENGINEERING-Next Generation Engines, www.transportengineer.org.uk
Park, C., Kim, C. and Choi, Y. (2012a). Power output characteristics of hydrogen-natural gas blend fuel engine at different compression ratios. Int. J. Hydrogen Energy 37, 10, 8681–8687.
Park, C., Kim, C., Choi, Y. and Lee, J. (2013a). Operating strategy for exhaust gas reduction and performance improvement in a heavy-duty hydrogen-natural gas blend engine. Energy, 50, 262–269.
Park, C., Kim, C., Choi, Y., Won, S. and Yasuo, M. (2011). The influences of hydrogen on the performance and emission characteristics of a heavy duty natural gas engine. Int. J. Hydrogen Energy 36, 5, 3739–3745.
Park, C., Kim, C., Lim, G., Lee, S. and Choi, Y. (2014). Effects of compression ratio and valve overlap on feasibility of HCNG engines for heavy-duty vehicles. SAE Paper No. 2014-01-1338.
Park, C., Lee, S., Lim, G., Choi, Y. and Kim, C. (2013b). Effect of mixer type on cylinder-to-cylinder variation and performance in hydrogen-natural gas blend fuel engine. Int. J. Hydrogen Energy 38, 11, 4809–4815.
Park, C., Lim, G., Lee, S., Kim, C. and Choi, Y. (2013c). Effects of the ignition timing retard and the compression ratio on the full-load performance and the emissions characteristics of a heavy-duty engine fueled by hydrogen–natural-gas blends. Proc. Institution of Mechanical Engineers, Part D: J. Automobile Engineering 227, 9, 1295–1302.
Park, C., Won, S., Kim, C. and Choi, Y. (2012b). Effect of mixing CO2 with natural gas–hydrogen blends on combustion in heavy-duty spark ignition engine. Fuel, 102, 299–304.
Park, C. W., Kim, C. G., Choi, Y., Lee, S. Y., Lee, S. W., Yi, U. H. and Lee, J. H. (2016). Development of hydrogencompressed natural gas blend engine for heavy duty vechcles. Proc. FISITA 2016, BEXCO, Korea.
Saanum, I., Bysveen, M., Tunestål, P. and Johansson, B. (2007). Lean burn versus stoichiometric operation with EGR and 3-way catalyst of an engine fueled with natural gas and hydrogen enriched natural gas. SAE Paper No. 2007-01-0015.
Sluder, C. S. (2014). Relentless progress: Emissions regulations and the road ahead. Proc. CRC Advanced Fuel and Engine Efficiency Workshop.
Author information
Authors and Affiliations
Corresponding author
Additional information
This paper was modified from the original paper presented in FISITA World Automotive Congress 2016, and recommended by the Scientific & Technical Committee for journal publication.
Rights and permissions
About this article
Cite this article
Park, C.W., Kim, C.G., Choi, Y. et al. Development of hydrogen-compressed natural gas blend engine for heavy duty vehicles. Int.J Automot. Technol. 18, 1061–1066 (2017). https://doi.org/10.1007/s12239-017-0103-8
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12239-017-0103-8