Abstract
The transient temperature profiles of a Helical oscillating heat pipe (HOHP), the heat transfer profiles of the HOHP, and the heat transfer profiles of a HOHP heat exchanger during start-up operation from a numerical model and from an experiment were studied. This article presents the details of a calculation for the HOHP, in which the HOHP has a domain consisting of a pipe wall and a vapor core. The governing equation at the pipe wall and the vapor core of the HOHP was solved by a numerical method. The numerical solution for the transient model in this study was obtained using a finite difference method, and the finite difference method used in this study was the Clank-Nicolson method. The temperature at the pipe wall of the HOHP, the heat transfer of the HOHP, and the heat transfer of the HOHP heat exchanger were plotted as functions of time. The results show that the transient temperature distributions at the pipe wall of the HOHP from the numerical model were successfully compared with the results from the experimental data, which utilizes the concept of temperature distributions during transient operation. The steady state temperature profiles were obtained as a steady temperature was input into the outer wall at the evaporator section of the HOHP. This study also found that the transient heat transfer profiles of the HOHP from the numerical model were successfully compared with the results from the experimental data, which utilizes the concept of heat transfer increments in the HOHP during transient operation. Moreover, it was also found that the transient heat transfer profiles of the HOHP heat exchanger from the numerical model were successfully compared with the results from the experimental data. Therefore, it can be concluded that the numerically validated temperature distributions of the HOHP, the heat transfer of the HOHP, and the heat transfer of the HOHP heat exchanger were successfully simulated in this model.
Similar content being viewed by others
References
F. Akbaridoust, M. Rakhsha, A. Abbassi and M. Saffar-Avval, Experimental and numerical investigation of nanofluid heat transfer in helically coiled tubes at constant wall temperature using dispersion model, International Journal of Heat and Mass Transfer, 58 (2013) 480–491.
T. J. Huttl and R. Friedrich, Influence of curvature and torsion on turbulent flow in helically coiled pipe, International Journal of Heat and Fluid Flow, 21 (2000) 345–353.
M. R. H. Nobari and A. Malvandi, Torsion and curvature effects on fluid flow in a helical annulus, International Journal of Non-Linear Mechanics, 57 (2013) 90–101.
H. Saffari and R. Moosavi, Numerical study of the influence of geometrical characteristics of a vertical helical coil on a bubbly flow, Journal of Applied Mechanics and Technical Physics, 55 (6) (2014) 957–969.
P. C. Mukesh Kumar, K. Palanisamy, J. Kumar, R. Tamilarasan and S. Sendhilnathan, CFD analysis of heat transfer and pressure drop in helically coiled heat exchangers using Al2O3 /water nanofluid, Journal of Mechanical Science and Technology, 29 (2) (2015) 697–705.
M. R. H. Nobari, B. Shiniyan and M. Mirzaei, Mixed convection in a vertical helical annular pipe, International Journal of Heat and Mass Transfer, 73 (2014) 468–482.
D. Colorado-Garrido, E. Santoyo-Castelazo, J. A. Hernandez, O. Garcia-Valladares, J. Siqueiros and D. Juarez-Romero, Heat transfer of a helical double-pipe vertical evaporator: Theoretical analysis and experimental validation, Applied Energy, 86 (2009) 1144–1153.
S. Y. Wu, S. J. Chen, Y. R. Li and L. J. Li, Numerical investigation of turbulent flow, heat transfer and entropy generation in a helical coiled tube with larger curvature ratio, Heat Mass Transfer, 45 (2009) 569–578.
S. Y. Wu, S. J. Chen, L. Xiao and Y. R. Li, Numerical investigation on developing laminar forced convective heat transfer and entropy generation in an annular helicoidal tube, Journal of Mechanical Science and Technology, 25 (6) (2011) 1439–1447.
G. P. Devanahalli, J. R. Timothy and G. S. Vijaya Raghavan, Natural convection heat transfer from helical coiled tubes, International Journal of Thermal Sciences, 43 (2004) 359–365.
J. S. Jayakumar, S. M. Mahajani, J. C. Mandal, K. N. Iyer and P. K. Vijayan, CFD analysis of single-phase flows inside helically coiled tubes, Computers and Chemical Engineering, 34 (2010) 430–446.
N. Pipatpaiboon, S. Rittidech, H. Huchaiyaphum, W. Dangton and P. Meena, Effect of working temperature on heat transfer characteristic of helix oscillating heat pipe (HOHP), Fourth International Conference Science, Technology and Innovation for Sustainable Well-Being, 10-12 August, Thailand (2012).
M. Germano, On the effect of torsion on a helical pipe flow, Journal of Fluid Mechanics, 125 (1982) 1–8.
P. Sakulchangsatjatai, P. Terdtoon, T. Wongratanaphisan, P. Kamonpet and M. Murakami, Operation modeling of closedend and closed-loop oscillating heat pipes at normal operating condition, Applied Thermal Engineering, 24 (2004) 995–1008.
Y. Sriudom, S. Rittidech and T. Chompookham, The helical oscillating heat pipe: flow pattern behavior study, Advances in Mechanical Engineering, 7 (1) (2015) 1–11.
S. H. Noie, Investigation of thermal performance of an airto-air thermosyphon heat exchanger using e-NTU method, Applied Thermal Engineering, 26 (2006) 559–567.
A. Hasan, Going below the wet-bulb temperature by indirect evaporative cooling: Analysis using a modified e-NTU method, Applied Energy, 89 (2012) 237–245.
W. M. Kays and A. L. London, Compact heat exchangers, McGraw-Hill, New York, USA (1984).
N. M. Phu and N. T. M. Trinh, Modelling and experimental validation for off-design performance of the helical heatexchanger with LMTD correction taken into account, Journal of Mechanical Science and Technology, 30 (7) (2016) 3357–3364.
F. P. Incropera, D. P. Dewitt, T. L. Bergman and A. S. Lavine, Fundamentals of heat and mass transfer, Sixth edition, John Wiley & Sons (Asia) Pte. Ltd. (2007).
S. Boothaisong, S. Ritidech, T. Chompookham, M. Thongmoon, Y. Ding and Y. Li, Three-dimensional transient mathematical model to predict the heat transfer of a heat pipe, Advances in Mechanical Engineering, 7 (2) (2015) 1–11.
Author information
Authors and Affiliations
Corresponding author
Additional information
Recommended by Associate Editor Ji Hwan Jeong
Narin Siriwan received his B.Eng. degree in Mechanical Engineering (Energy) from Mahasarakham University, Thailand, in 2011. He received his M. Eng. degree in Mechanical Engineering from Mahasarakham University, Thailand, in 2013. Narin Siriwan is currently a Ph.D. student in Mechanical Engineering at Mahasarakham University, Thailand.
Teerapat Chompookham has been a lecturer at the Faculty of Engineering at Mahasarakham University, Thailand since 2011. He received his D.Eng. (Mechanical Engineering) from King Mongkut’s Institute of Technology Ladkrabang (KMITL), Thailand in 2011. Dr. Teerapat’s research interests are focused on solar air heater technology, heat pipe technology, and energy conservation.
Yolong Ding is currently a Professor at the School of Chemical Engineering at the University of Birmingham in the United Kingdom. Dr. Yulong’s research interests include energy materials and energy processes, and he is currently focusing on developing novel technologies for electrical and thermal energy storage at different scales.
Sampan Rittidech received his Ph.D. degree in Mechanical Engineering from Chiang Mai University, Thailand, in 2002. Dr. Sampan Rittidech is currently a Professor at the Faculty of Engineering at Mahasarakham University, Thailand. Dr. Sampan’s research interests include heat transfer, heat pipes, and heat exchangers.
Rights and permissions
About this article
Cite this article
Siriwan, N., Chompookham, T., Ding, Y. et al. Heat transfer predictions for helical oscillating heat pipe heat exchanger: Transient condition. J Mech Sci Technol 31, 3553–3562 (2017). https://doi.org/10.1007/s12206-017-0642-y
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12206-017-0642-y