Abstract
One composite coating of Ni–P alloys containing MoS2 nanoparticles was prepared by electroless technique based on the better friction reduction ability of MoS2 and better anticorrosion property of electroless Ni–P alloys on carbon steel surfaces. Electrochemical method—that is, using Tafel polarization curves—was carried out in order to study the corrosion performance of the coating. The results indicate that the anticorrosion ability of the composite coating was decreased because of the addition of nano-MoS2 particles. The corrosional surfaces were studied and analyzed through scanning electron microscopy (SEM). The corrosion mechanism of the composite coatings was mainly ascribed to the formation of microcells around the nanosized MoS2 particles, and the active ion-like Cl− destroyed the surface film and induced the corrosion on the inside part of the coating. The friction coefficient of electroless composite coatings was measured by end-facing tribometer. It was found that the friction coefficient of the Ni–P–(nano-MoS2) composite coating decreased greatly compared with those of Ni–P electroless coatings.
References
Chen, CK, Feng, HM, Lin, HC, Hon, MH, “The Effect of Heat Treatment on the Microstructure of Electroless Ni–P Coatings Containing SiC Particles.” Thin Solid Films, 416 31–37 (2002)
Ramalho, A, Miranda, JC, “Friction and Wear of Electroless NiP and NiP + PTFE Coatings.” Wear, 259 828–834 (2005)
Rossi, S, Chini, F, Straffelini, G, LBonora, P and Stampali A, “Corrosion Protection of Electroless Nickel/PTFE, Phosphate/MoS2 and Bronze/PTFE Coatings Applied to Improve the Wear Resistance of Carbon Steel” Surf. Coat. Technol., 173 235–242 (2003)
Shoeib, MA, Mokhtar, SM, El-Ghaffar, MAA, “Mechanical and Corrosion Protection Properties of Electroless Nickel-Polymer Composite Coatings.” Met. Finish., 96 58–59 (1998)
Chen, WX, Tu, JP, Xu, ZD, Chen, WL, Zhang, XB, Cheng, DH, “Tribological Properties of Ni-P-Multi-Walled Carbon Nanotubes Electroless Composite Coating.” Mater. Lett., 57 1256–1260 (2003)
Wang, LY, Tu, JP, Chen, WX, Wang, YC, Liu, XK, Olk, C, Cheng, DH and Zhang, XB, “Friction and Wear Behavior of Electroless Ni-Based CNT Composite Coatings.” Wear, 254 1289–1293 (2003)
Chen, XH, Chen, CS, Xiao, HN, Cheng, FQ, Zhang, G and Yi, GJ, “Corrosion Behavior of Carbon Nanotubes-Ni Composite Coating.” Surf. Coat. Technol., 191 351–356 (2005)
Chen, WX, Tu, JP, Ma, XC, Xu, ZD, Chen, WL, Wang, JG, Cheng, DH, Xia, JB, Gan, HY, Jin, YX, Tenne, R, Rosenstveig, R, “Preparation and Tribological Properties of Ni-P Electroless Composite Coating Containing Inorganic Fullerene-Like WS2 Nanomaterials.” Acta Chim. Sin., 60 1722–1726 (2002)
Hu, XG, Cai, WJ, Xu, YF, Wan, JC, Sun, XJ, “Electroless Ni-P-(nano-MoS2) Composite Coatings and their Corrosion Properties.” Surf. Eng. (in press)
Hu, KH, Wang, YR,. Hu XG, Wo, HZ, “Preparation and Characterization of Nanosized Molybdenum Disulfide Particles by Thioacetamide.” Mater. Sci. Technol., 23 242–246 (2007)
Floyd, FL, Tatti, S, Provder, T, “Using DC Electrochemical Techniques to Assess the Relative Corrosiveness of Water-Based Coatings and their Ingredients.” J. Coat. Technol. Res., 4 111–129 (2007).
Acknowledgments
The authors wish to express their thanks to Professor J. B. He and Professors Y. C. Wu and Mr. L. Wang for their assistance in this work. The financial support by the State Laboratory of Solid Lubrication (Grant No. 0401) and Anhui Provincial Natural Science Foundation (Grant No. 070414152) is also acknowledged.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Hu, X., Jiang, P., Wan, J. et al. Study of corrosion and friction reduction of electroless Ni–P coating with molybdenum disulfide nanoparticles. J Coat Technol Res 6, 275–281 (2009). https://doi.org/10.1007/s11998-008-9131-7
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11998-008-9131-7