Abstract
Common availability of dough improvers permits the production of bread of good quality, but only modifications of the process may be used for the production of natural products. Dough from weak flour, after application of certain treatments, displays poorer baking properties; therefore, in our study, it is proposed to apply slow-speed mixing in two cycles. In the literature, there is a lack of comparisons of results of baking with the straight dough method (one-cycle mixing) with modified methods including the application of two equal cycles of dough mixing and two “incomplete” cycles, the first of which lasts twice as long as the second one [partial two-cycle mixing (PTCM)]. This study involved the determination of the quality properties of bread (loaf volume, specific weight, crust thickness, crumb whiteness, crumb hardness index, and crumb heterogeneity index) under the effect of process modifications, analyzing the effect of dough mixing time and resting time between the mixing cycles. The study included also regression equations describing the physical properties of bread. Based on the tests performed, it was noted that in the case of flour characterized by poor baking quality, the process effectiveness can be enhanced through the application of two incomplete mixing cycles (PTCM), with dough resting time in the range of 10–20 min. This treatment resulted breads with significantly greater loaf volume, lower specific weight, lower whiteness index, and hardness compared to breads baked using the straight dough method. It is not recommended to use two equal duration cycles of dough mixing.
Similar content being viewed by others
References
Alava, J. M., Millar, S. J., & Salmon, S. E. (2001). The determination of wheat breadmaking performance and bread dough mixing time by NIR spectroscopy for high speed mixers. Food Science and Technology Abstracts. Journal of Cereal Science, 33(1), 71–81.
Başaran, A., & Göçmen, D. (2003). The effects of low mixing temperature on dough rheology and bread properties. European Food Research and Technology, 217, 138–142.
Belton, P. S. (1999). On the elasticity of wheat gluten. Journal of Cereal Science, 29(2), 103–107.
Bourne, M. C. (1978). Texture profile analysis. Food Technology, 7, 62–66.
Calderón-Domínguez, G., Vera-Domínguez, M., Farrera-Rebollo, R., Arana-Errasquín, R., & Mora-Escobedo, R. (2004). Rheological changes of dough and bread prepared from a sweet dough: effect of temperature and mixing time. International Journal of Food Properties, 7, 165–174.
Calderón-Domínguez, G., Farrera-Rebollo, R., Arana-Errasquín, R., & Mora-Escobedo, R. (2005). The effect of varying the mixing formula on the quality of a yeast sweet bread and also on the process conditions, as studied by surface response methodology. International Journal of Food Science and Technology, 40, 157–164.
Cassut, V., Preston, K. R., & Kilborn, R. H. (1984). Effects of fermentation time, inherent flour strength, and salt level on extensigraph properties of full formula remix to-peak processed doughs. Cereal Chemistry, 61(5), 454–459.
Chen, W. Z., & Hoseney, R. C. (1995). Development of an objective method for dough stickiness. Lebensmittel-Wissenschaft und Technologie, 28, 467–473.
Chevallier, S., Zúñiga, R., & Le-Bail, A. (2012). Assessment of bread dough expansion during fermentation. Food and Bioprocess Technology, 5, 609–617.
Chhanwal, N., Tank, A., Raghavarao, K. S. M. S., & Anandharamakrishnan, C. (2012). Computational fluid dynamics (CFD) modeling for bread baking process—a review. Food and Bioprocess Technology, 5, 1157–1172.
Chiotellis, E., & Campbell, G. M. (2003). Proving of bread dough: II. Measurement of gas production and retention. Trans IChemE, 81(Part C), 207–216.
Clarke, C. I., Schober, T. J., Angst, E., & Arendt, E. K. (2003). Use of response surface methodology to investigate the effects of processing conditions on sourdough wheat bread quality. European Food Research and Technology, 217, 23–33.
Collar, C., Bollain, C., & Rosell, C. M. (2007). Rheological behaviour of formulated bread doughs during mixing and heating. Food Science and Technology International, 13(2), 99–107.
Ewart, J. A. D. (1977). Re-examination of the linear glutenin hypothesis. Journal of the Science of Food and Agriculture, 28, 191–199.
Fiszman, S. M., Salvador, A., & Varela, P. (2005). Methodological developments in bread staling assessment: application to enzyme-supplemented brown pan bread. European Food Research and Technology, 221, 616–623.
Gámbaro, A., Giménez, A., Ares, G., & Gilardi, V. (2006). Influence of enzymes on the texture of brown pan bread. Journal of Texture Studies, 37(3), 300–314.
Gómez, A., Ferrero, C., Calvelo, A., Añón, M. C., & Puppo, M. C. (2011). Effect of mixing time on structural and rheological properties of wheat flour dough for breadmaking. International Journal of Food Properties, 14(3), 583–598.
Hoseney, R. C. (1986). Principals of cereal science and technology, pp 205–206. St. Paul: Am. Assoc. Cereal Chemists.
ISO 2171:2007. Cereals, pulses and by-products—determination of ash yield by incineration. The International Organization for Standardization.
ISO 20483:2006. Cereals and pulses—determination of the nitrogen content and calculation of the crude protein content—Kjeldahl method. The International Organization for Standardization.
ISO 21415–1:2006. Wheat and wheat flour—gluten content—part 1. Determination of wet gluten by a manual method. The International Organization for Standardization.
ISO 3093:2009. Wheat, rye and their flours, durum wheat and durum wheat semolina—determination of the falling number according to Hagberg-Perten. The International Organization for Standardization.
ISO 5530–1:1997. Wheat flour—physical characteristics of doughs—part 1: determination of water absorption and rheological properties using a farinograph. The International Organization for Standardization.
Jahromi, S. H. R., Yazdi, F. T., Karimi, M., & Mortazavi, S. A. (2012). Optimization of dough mixing time and mixing speed to improve dough rheology and quality of Barbari bread using response surface methodology. (Persian) CAB Abstracts—Iranian Food Science & Technology Research Journal, 7(4), 280–289.
Jakubczyk, T., & Haber, T. (1983). Analysis of cereals and cereal products. Warsaw: SGGW-AR.
Kansou, K., Chiron, H., Della Valle, G., Ndiaye, A., Roussel, P., & Shehzad, A. (2012). Modelling wheat flour dough roofing behaviour: effects of mixing conditions on porosity and stability. Food and Bioprocess Technology. doi:10.1007/s11947-012-0854-1.
Kim, Y. R., Cornillon, P., Campanella, O. H., Stroshine, R. L., Lee, S., & Shim, J. Y. (2008). Small and large deformation rheology for hard wheat flour dough as influenced by mixing and resting. Journal of Food Science, 73(1), E1–E8.
Mehta, K. L., Scanlon, M. G., Sapirstein, H. D., & Page, J. H. (2009). Ultrasonic investigation of the effect of vegetable shortening and mixing time on the mechanical properties of bread dough. Journal of Food Science, 74(9), 455–461.
Mondal, A., & Datta, A. K. (2008). Bread baking—a review. Journal of Food Engineering, 86(4), 465–474.
Oliete, B., Gómez, M., Pando, V., & Fernández-Fernández, E. P. (2008). Caballero A & Ronda F (2008) Effect of nut paste enrichment on physical characteristics and consumer acceptability of bread. Food Science and Technology International, 14(3), 259–269.
Owens, G. (2001). Cereals processing technology. Chapter 10. Breadmaking (Cauvain S.P.). Cambridge: Woodhead Publishing Limited and CRC Press.
Roels, S. P., Cleemput, G., Vandewalla, M., Nys, M., & Delcour, J. A. (1993). Bread volume potential of variable quality flours with constant protein level as determined by factors governing mixing time and baking absorption level. Cereal Chemistry, 70(3), 318–323.
Rosell, C. M., Santos, E., & Collar, C. (2006). Mixing properties of fibre-enriched wheat bread doughs: a response surface methodology study. European Food Research and Technology, 223, 333–340.
Rosell, C. M., Santos, E., & Collar, C. (2010). Physical characterization of fiber-enriched bread doughs by dual mixing and temperature constraint using the Mixolab. European Food Research and Technology, 231, 535–544.
Rouille, J., Le Bail, A., & Corcoux, P. (2000). Influence of formulation and mixing conditions on breadmaking qualities of French frozen dough. Journal of Food Engineering, 43(4), 197–203.
Różyło, R. (2010). Influence of dough making parameters on physical properties of wheat bread. Acta Agrophysica, 16(1), 149–161.
Różyło, R. (2013). Determining the heterogeneity of wheat bread crumb texture baked using two different methods: new application. International Journal of Food Properties, 16(1), 154–167. doi:10.1080/10942912.2010.535189.
Różyło, R., & Laskowski, J. (2009). Comparison quality feature of wheat bread baked using straight and pre-fermented dough method. Żywność Nauka Technologia Jakość, 5(66), 83–95.
Różyło, R., & Laskowski, J. (2011). Breads, physical properties. In: Encyclopedia of agrophysics. Encyclopedia of Earth sciences series, edited by J. Gliński, J. Horabik, J, Lipiec, (91–93). The Netherlands: Springer, ISBN: 978-90-481-3584-4.
Różyło, R., Dziki, D., & Laskowski, J. (2010). The influence of flour gluten content on physical properties of bread baked from dough with different yield. Acta Agrophysica, 15(2), 383–394.
Różyło, R., Dziki, D., & Laskowski, J. (2011a). Influence of dough making conditions on fermentation process and physical properties of wheat bread. Acta Agrophysica, 18(1), 131–142.
Różyło, R., Laskowski, J., & Dziki, D. (2011b). Physical properties of wheat bread baked from dough with different parameters. Acta Agrophysica, 18(2), 421–430.
Shehzad, A., Chiron, H., Valle, G. D., Kansou, K., Ndiaye, A., & Reguerre, A. L. (2010). Porosity and stability of bread dough during proofing determined by video image analysis for different compositions and mixing conditions. Food Research International, 43(8), 1999–2005.
Singh, N., Bajaj, I. K., Singh, R. P., & Gujral, H. S. (2002a). Effect of different additives on mixograph and bread making properties of Indian wheat flour. Journal of Food Engineering, 56, 89–95.
Singh, N., Gujral, H. S., & Singh, J. (2002b). Effect of baking ingredients and mixing duration on dough development, gas release and bread making properties. Journal of Food Quality, 25, 305–315.
Tlapale-Valdivia, A. D., Chanona-Perez, J., Mora-Escobedo, R., Farrera-Rebollo, R. R., Gutierrez-Lopez, G. F., & Calderon-Dominguez, G. (2010). Dough and crumb grain changes during mixing and fermentation and their relation with extension properties and bread quality of yeasted sweet dough. International Journal of Food Science and Technology, 45(3), 530–539.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Różyło, R. Effect of Process Modifications in Two Cycles of Dough Mixing on Physical Properties of Wheat Bread Baked from Weak Flour. Food Bioprocess Technol 7, 774–783 (2014). https://doi.org/10.1007/s11947-013-1100-1
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11947-013-1100-1