Abstract
Described are the physical and chemical properties of the methyl esters of two uncommon fatty acids: vernolic acid, containing an epoxy group, and crepenynic acid, containing a triple bond. The incorporation of an epoxy or alkyne group into the fatty acid structure is shown to greatly affect the properties compared to conventional unsaturated fatty acids. The methyl esters have been characterized and compared with ordinary fatty acid methyl esters (i.e., methyl oleate and linoleate) with respect to spectroscopic characterization [1H nuclear magnetic resonance (NMR)], 13C NMR, and Fourier transform infrared), rheological properties, and oxidative reactivity (using chemiluminescence). Both methyl vernoleate and methyl crepenynate could successfully be produced by transesterification under basic conditions without reaction of the epoxy or alkyne groups. Rheological measurements showed that the methyl esters had a significantly lower viscosity compared to their triglyceride analogs. Smaller differences were seen when comparing the different methyl esters where methyl vernoleate had the highest viscosity due to the presence of the more polar oxirane group. Very large differences were found with respect to the oxidation rate of the different methyl esters. Methyl crepenynate was shown to oxidize extremely rapidly, whereas methyl vernoleate was very stable toward oxidation.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Derksen, J.T.P., F.P. Cuperus, and P. Kolster, Renewable Resources in Coatings Technology: A Review, Prog. Org. Coat. 27:45–53 (1996).
Overeem, A., G.J.H. Buisman, J.T.P. Derksen, F.P. Cuperus, L. Molhoek, W. Grisnich, and C. Goemans, Seed Oils Rich in Linolenic Acid as Renewable Feedstock for Environment-Friendly Crosslinkers in Powder Coatings, Ind. Crop. Prod. 10:157–165 (1999).
Wicks, Z.W., Drying Oils, in Encyclopedia of Polymer Science and Engineering, edited by John Wiley & Sons, Inc., New York, 1986, pp. 203–214.
Solomon, D.H., The Chemistry of Organic Film Formers, 2nd edn., Robert E. Krieger Publishing Co., Malabar, Florida, 1982.
Hare, C.H., Protective Coatings, Fundamentals of Chemistry and Composition, Technology Publishing Company, Pittsburgh, 1998, pp. 129–135.
Crivello, J.V., and R. Narayan, Epoxidized Triglycerides as Renewable Monomers in Photoinitiated Cationic Polymerization, Chem. Mat. 4:692–699 (1992).
Thames, S.F., and H. Yu, Cationic UV-Cured Coatings of Epoxide-Containing Vegetable Oils, Surf. Coat. Technol. 115:208–214 (1999).
Stoffer, J.O., P.P. Lu, L.R. Dharani, and R.A. Babcock, Fiber Reinforced Composites from Epoxidized Soybean Oil, Abstr. Pap. Am. Chem. Soc. 40:599–600 (1999).
Muturi, P., D.Q. Wang, and S. Dirlikov, Epoxidized Vegetable-Oils as Reactive Diluents. 1. Comparison of Vernonia, Epoxidized Soybean, and Epoxidized Linseed Oils, Prog. Org. Coat. 25:85–94 (1994).
Lee, M., M. Lenman, A. Banas, M. Bafor, S. Singh, M. Schweizer, R. Nilsson, C. Liljenberg, A. Dahlqvist, P.O. Gummeson, S. Sjodahl, A. Green, and S. Stymne, Identification of Non-heme Diiron Proteins That Catalyze Triple Bond and Epoxy Group Formation, Science 280:915–918 (1998).
Lazzari, M., and O. Chiantore, Drying and Oxidative Degradation of Linseed Oil, Polym. Degrad. Stabil. 65:303–313 (1999).
Matisova-Rychla, L., and J. Rychly, Inherent Relations of Chemiluminescence and Thermooxidation of Polymers, in Polymer Durability, edited by R.L. Clough, N.C. Billingham, and K.T. Gillen, American Chemical Society, Washington, 1996, pp. 175–193.
Author information
Authors and Affiliations
Corresponding author
About this article
Cite this article
Samuelsson, J., Johansson, M. A study of fatty acid methyl esters with epoxy or alkyne functionalities. J Amer Oil Chem Soc 78, 1191–1196 (2001). https://doi.org/10.1007/s11745-001-0412-y
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/s11745-001-0412-y