References
N. Yoshinaga: Ph.D. Thesis, Ghent Univ., Ghent, Belgium, 1999.
S. Okada, S. Satoh, T. Kato, and T. Takasaki: Proc. Symp. on High Strength Sheet Steels for Automotive Industry, R. Pradhan, ed., ISS, Warrendale, PA, 1994, pp. 33–38.
K. Seto, K. Okua, and K. Sakata: Proc. Symp. on High Strength Sheet Steels for Automotive Industry, R. Pradhan, ed., ISS, Warrendale, PA, 1994, pp. 201–08.
K. Sakata, K. Okuda, K. Seto, and T. Obara: Tetsu-To-Hagané, 1997, vol. 83, pp. 593–600.
W.C. Jeong and K. Cho: J. Kor. Inst. Met. Mater., 1999, vol. 37, pp. 672–79.
N. Yoshinaga, K. Ushioda, and O. Akisue: proc. Symp. on High Strength Sheet Steels for Automotive Industry, R. Pradhan, ed., ISS, Warrendale, PA, 1994, pp. 149–58.
T. Matsumoto, S. Hamanaka, T. Yamada, and T. Tanaka: Int. Forum for Physical Metallurgy of IF Steels, ISIJ, Tokyo, 1994, pp. 269–73.
Bainite Committee of Iron and Steel Institute of Japan, Atlas for Bainitic Microstructures, T. Araki et al., eds., ISIJ, Tokyo, 1992.
G. Krauss and S.W. Thompson: Iron Steel Inst. Jpn. Int., 1995, vol. 35, pp. 937–45.
Author information
Authors and Affiliations
Additional information
This research was supported by research grants CUD2003 from the Catholic University of Daegu in 2003.
Rights and permissions
About this article
Cite this article
Jeong, W.C. Microstructural aspects of quasi-polygonal and granular bainitic ferrites in an ultra-low-carbon interstitial-free high-strength steel. Metall Mater Trans A 34, 2025–2026 (2003). https://doi.org/10.1007/s11661-003-0167-0
Received:
Issue Date:
DOI: https://doi.org/10.1007/s11661-003-0167-0