Abstract
Large uncertainty exists in soil testing due to the randomness in sampling and system errors, especially in tests on frozen soils. In order to reduce the randomness and improve the test accuracy, the sample preparation method is improved to obtain more homogeneous samples. The standard Chinese sand is used as the soil. An environmental material test apparatus with three-point temperature control was used. Four temperatures and four confining pressures are used for the triaxial compression tests, which makes 16 combinations. For each combination, five repeat tests were carried out to examine the scattering of the mechanical properties of the frozen sand. It is found that under a certain confining pressure, the scattering increased with the increase in temperature and vice versa. Under a certain combination of temperature at −0.5 °C and confining pressure of 10 MPa, the stress–strain curves are so different that similarity in the curves does not exist. This phenomenon is not scattering because sample randomness or system errors cannot explain it any more and is therefore called variability. It is attributed to pressure melting, pressure crush of soil particles as well as severe phase changes caused by small temperature variations. The difference in the test results is considered as an inherent feature of frozen soils. Strength and strain energy are used, along with temperature and confining pressure to analyze the cause of variability. This work shows that further work must be carried out to develop an optimum testing program in order to make a reasonable analysis for engineering constructions in which frozen soils are involved.
Similar content being viewed by others
References
Baker TH, Konrad JM (1985) Effect of sample preparation on the strength of artificially frozen sand. In: Proceedings of the 4th international symposium on ground freezing, Sapporo, Japan, vol 2. pp 171–176
Bragg RA, Andersland OB (1981) Strain rate, temperature, and sample size effects on compression and tensile properties of frozen soil. Eng Geol 18:35–46
Chamberlain E, Groves C, Perham R (1972) The mechanical behavior of frozen earth materials under high pressure triaxial test conditions. Geotechnique 22(3):469–483
Einstein HH, Bächer GB (1982) Probabilistic and statistical methods in engineering geology. I. Problem statement and introduction to solution. Rock Mech Supp 12:47–61
Kulhawy FH (1992) On evaluation of static soil properties. In: Seed RB, Boulanger RW (eds) Stability and performance of slopes and embankments II (GPS 31), Am Soc Civil Eng, pp 95–115
Lai YM, Li SY, Qi JL, Gao ZH, Chang XX (2008) Strength distributions of warm frozen clay and its stochastic damage constitutive model. Cold Reg Sci Technol 53(2):200–215
Li QZ, Lai YM, Xu XT, Yang YG, Chang XX (2010) Triaxial strength distributive of warm frozen soil and its damage statistical constitutive model. J Glaciol Geocryol 32(6):1235–1241
Li SY, Lai YM, Zhang SJ, Liu DR (2009) An improved statistical damage constitutive model for warm frozen clay based on Mohr–Coulomb criterion. Cold Reg Sci Technol 57(2–3):154–159
Lumb P (1969) Safety factors and the probability distribution of soil strength. Can Geotech J 7(3):225–242
Ma W, Wu ZW, Zhang LX, Chang XX (1999) Analyses of process on the strength decrease in frozen soils under high confining pressures. Cold Reg Sci Technol 29(1):1–7
Miura S, Toki S (1982) A sample preparation method and its effect on static and cyclic deformation strength properties of sand. Soils Found 22(1):61–77
Parameswaran VR (1980) Deformation behaviour and strength of frozen sand. Can Geotech J 17(1):74–88
Parameswaran VR, Jones SJ (1981) Triaxial testing of frozen sand. J Glaciol 27(95):147–155
Phoon KK, Kulhawy FH (1999) Characterization of geotechnical variability. Can Geotech J 4(36):612–624
Phoon KK, Kulhawy FH (1999) Evaluation of geotechnical property variability. Can Geotech J 4(36):625–639
Qi JL, Ma W (2007) A new criterion for strength of frozen sand under quick triaxial compression considering effect of confining pressure. Acta Geotech 2(3):221–226
Qi JL, Zhang JM, Yao XX, Hu W, Fang LL (2009) Analysis of settlements of constructions in permafrost regions. Rock Soil Mech 30(Supp. 2):1–8 (in Chinese)
Ting JM, Martin RT, Ladd C (1983) Mechanisms of strength for frozen sand. J Geotech Eng 109(10):1286–1302
Tsytovich NA (1985) The mechanics of frozen ground. Translated by Zhang CQ, Zhu YL, Science Press, Beijing
Wu ZW, Ma W (1994) Strength and Creep of Frozen Soil. Lanzhou University Press, pp 36–87 (in Chinese)
Yang YG, Lai YM, Li JB (2010) Laboratory investigation on the strength characteristic of frozen sand considering effect of confining pressure. Cold Reg Sci Technol 60(2010):245–250
Yang YG, Lai YM, Chang XX (2010) Laboratory and theoretical investigations on the deformation and strength behaviors of artificial frozen soil. Cold Reg Sci Technol 64(2010):39–45
Acknowledgments
This work is supported in part by the Importation and Development of High-Caliber Talents Project of Beijing Municipal Institutions granted to Dr. Jilin Qi (CIT&TCD20150101) and the National Natural Science Foundation of China (Nos. 41172253 and 41201064).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Ma, L., Qi, J., Yu, F. et al. Experimental study on variability in mechanical properties of a frozen sand as determined in triaxial compression tests. Acta Geotech. 11, 61–70 (2016). https://doi.org/10.1007/s11440-015-0391-y
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11440-015-0391-y