Abstract
This research focuses on the measurement of the static and dynamic mechanical properties of ballistic gelatin. We present a simple, novel experimental setup for measuring the dynamic material properties of ballistic gelatin that includes the classic metallic incident and transmission bars as opposed to the polymeric Kolsky bars used by additional research groups. This method is mathematically validated, while providing sought out for stress–strain curves for three different ballistic gelatin concentrations. The results are then compared to two additional research groups, while being consistent with one and contradictory to the other. Finally, an empirical constitutive law is presented that is consistent with the results obtained through the experimental setup.
Similar content being viewed by others
References
Field JE, Walley SM, Proud WG, Goldrein HT, Siviour CR (2004) Review of experimental techniques for high rate deformation and shock studies. Int J Impact Eng 30(7):725–775
Ramesh KT (2008) “High rates and impact experiments”. In Springer Handbook of Experimental Solid Mechanics Part D, by William N., Jr. Sharpe, 929–960. Springer US
Hopkinson B (1914) A method of measuring the pressure produced in the detonation of high explosives or by the impact of bullets. Philos Trans R Soc (London) A 213:437–456
Kolsky H (1949) An investigation of the mechanical properties of materials at very high rates of loading. Proc Phys Soc Sect B 62(11):676–700
Kolsky H (1963) Stress waves in solids. Dover, Dover Publications
Chen W, Song B (2011) Split Hopkinson (Kolsky) Bar: Design, testing and applications. Springer
Sarvazyan AP (1975) Low-frequency acoustic characteristics of biological tissues. Mech Compos Mat 11(4):594–597
Lim AS, Lopatnikov SL, Wagner NJ, Gillespie JW (2010) An experimental investigation into the kinematics of a concentrated hard-sphere colloidal suspension during Hopkinson bar evaluation at high stresses. J Non-Newtonian Fluid Mech 165(19):1342–1350
Brown EN, Willms RB, Gray GT III, Rae PJ, Cady CM, Vecchio KS, Flowers J, Martinez MY (2007) Influence of molecular conformation on the constitutive response of polyethylene: a comparison of HDPE, UHMWPE, and PEX. Exp Mech 47(3):381–393
Cady CM, Gray GT III, Liu C, Lovato ML, Mukai T (2009) Compressive properties of a closed-cell aluminum foam as a function of strain rate and temperature. Mat Sci Eng: A 525(1):1–6
Chen W, Zhang B, Forrestal MJ (1999) A split Hopkinson bar technique for low-impedance materials. Exp Mech 39(2):81–85
Vecchio KS, Jiang F (2007) Improved pulse shaping to achieve constant strain rate and stress equilibrium in split-Hopkinson pressure bar testing. Metall Mat Trans A 38(11):2655–2665
Gray GT III, Blumenthal W (2000) “Split-Hopkinson pressure bar testing of soft materials”. In ASM handbook: Mechanical testing and evaluation, 8:462–474. ASM International
Cronin DS, Falzon C (2011) Characterization of 10% ballistic gelatin to evaluate temperature, aging and strain rate effects. Exp Mech 51(7):1197–1206
Kwon J, Subhash G (2010) Compressive strain rate sensitivity of ballistic gelatin. J Biomech 43(3):420–425
Salisbury CP, Cronin DS (2009) Mechanical properties of ballistic gelatin at high deformation rates. Exp Mech 49(6):829–840
Benatar A, Rittel D, Yarin AL (2003) Theoretical and experimental analysis of longitudinal wave propagation in cylindrical viscoelastic rods. J Mech Phys Solids 51(8):1413–1431
Zhao H, Gary G (1995) A three dimensional analytical solution of the longitudinal wave propagation in an infinite linear viscoelastic cylindrical bar. Application to experimental techniques. J Mech Phys Solids 43(8):1335–1348
Bloom OT (1925) Machine for testing jelly strength of glues, gelatins and the like. Washington, DC: U.S. Patent and Trademark Office. Patent U.S. Patent No. 1,540,979
Jussila J (2004) Preparing ballistic gelatine—review and proposal for a standard method. Forensic Sci Int 141(2):91–98
Scheidler M (2009) Viscoelastic models for nearly incompressible materials (No. ARL-TR-4992). Army Research Lab Aberdeen Proving Ground MD
Ishai O, Bodner SR (1970) Limits of linear viscoelasticity and yield of a filled and unfilled epoxy resin. J Rheol 14:253
Van Sligtenhorst C, Cronin DS, Wayne Brodland G (2006) High strain rate compressive properties of bovine muscle tissue determined using a split Hopkinson bar apparatus. J Biomech 39(10):1852–1858
Warren TL, Forrestal MJ (2010) Comments on the effect of radial inertia in the Kolsky bar test for an incompressible material. Exp Mech 50(8):1253–1255
Nishida E, Chen WW (2010) Inertia effects in the impact response of soft materials. Society for Experimental Mechanics, Providence, Rhode Island
Acknowledgments
The Technion Fund for the Development of Technologies Against Terroris kindly acknowledged for its support (grant 2014817). The authors are grateful to the experimental team of Plasan-Sasa for useful discussion regarding the Flexiforce sensors’setup.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Richler, D., Rittel, D. On the Testing of the Dynamic Mechanical Properties of Soft Gelatins. Exp Mech 54, 805–815 (2014). https://doi.org/10.1007/s11340-014-9848-4
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11340-014-9848-4