The effect of deformation stress on the consolidating of titanium powder strips obtained by symmetrical and asymmetrical rolling is analyzed. It is determined, that the strength of green strips after asymmetrical rolling is substantially higher than that of conventional strips: for low and medium deformation stress (by a factor of 3–5) and for high deformation stress (by a factor of >10). The repeated rolling improves the mechanical properties of sintered strips. Titanium powder strips produced through optimal asymmetrical rolling possess better mechanical properties than conventional titanium strips.
Similar content being viewed by others
References
V. P. Katashinskii and G. A. Vinogradov, “Investigation into the compactability of metal powders during rolling,” Powder Metall. Metal. Ceram., 4, No. 5, 356–361 (1965).
G. A. Vinogradov and V. P. Katashinskii, “Study of specific pressure during the rolling of metal powders,” Powder Metall. Metal. Ceram., 2, No. 3, 198–203 (1963).
K. A. Gogaev, G. Ya. Kalutskii, and V. S. Voropaev, “Asymmetric rolling of metal powders. I. Compactability of metal powders in asymmetric rolling,” Powder Metall. Metal. Ceram., 48, No. 3, 36–42 (2009).
K. A. Gogaev, V. A. Nazarenko, V. S. Voropaev, et al., “Mechanical properties of powder titanium at different production stages. V. Properties of a titanium strip produced by powder rolling,” Powder Metall. Metal. Ceram., 48, No. 11, 652–658 (2009).
K. A. Gogaev, V. S. Voropaev, Yu. N. Podrezov, et al., “Production of titanium powder sheets by asymmetric rolling,” Powder Metall. Metal. Ceram., 51, No. 9, 509–517 (2013).
V. S. Voropaev, “The effect of mismatch value in asymmetric rolling of powders on the diagram of the total normal contact stress,” Tekhnol. Sistemy, No. 4, 28–30 (2012).
K. A. Gogaev, G. Ya. Kalutskii, and V. S. Voropaev, “Asymmetric rolling of metal powders. II. Angular parameters of asymmetric rolling,” Powder Metall. Metal. Ceram., 48, No. 5, 274–278 (2009).
G. A. Vinogradov and V. P. Katashinskii, Theory of Flat Rolling of Metallic Powders and Granules [in Russian], Metallurgiya, Moscow (1979), p. 224.
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Poroshkovaya Metallurgiya, Vol. 55, Nos. 11–12 (512), pp. 3–10, 2016.
Rights and permissions
About this article
Cite this article
Gogaev, K.A., Voropaev, V.S., Podrezov, Y.N. et al. The Effect of Compacting Rolling on the Properties of Titanium Powder Mill Products. Powder Metall Met Ceram 55, 633–639 (2017). https://doi.org/10.1007/s11106-017-9849-9
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11106-017-9849-9