Skip to main content

Advertisement

SpringerLink
Log in

Wireless Power Transfer and In-Vehicle Networking Integration for Energy-Efficient Electric Vehicles

  • Published:
Mobile Networks and Applications Aims and scope Submit manuscript

Abstract

This paper presents the wireless power transfer (WPT) technology based on inductive coupling and the design challenges of a hybrid energy harvester (EH) circuit as a promising solution to promote the energy efficiency of the electric vehicles (EVs). The design methodologies of ultra-low power (ULP) electronic module based on low leakage conditioning and processing device are detailed based on nanoscale transistor technology so that the WPT and hybrid EH can be implemented for self-powered devices in EVs. Moreover, in-vehicle network design verification based on a new power-aware behavioral model formulation and extraction for high-speed and ULP transceivers that enables the transient prediction of power and ground currents and voltages when multiple drivers are simultaneously switching for signal-power integrity evaluation. The derivation of the proposed model is based on the analysis and extension of the input/output buffer information specification (IBIS). The analysis of the previous IBIS and Mpilog modeling approaches is followed by a new model formulation along with a well-designed characterization and parametric extraction procedure.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Fig. 16
Fig. 17
Fig. 18
Fig. 19
Fig. 20
Fig. 21
Fig. 22

Similar content being viewed by others

References

  1. Vilathgamuwa DM, Sampath JPK (2015) Wireless power transfer (WPT) for electric vehicles (EVs)-present and future trends. Plug In Electric Vehicles in Smart Grids:33–60

  2. Covic GA, Boys JT (2013) Modern trends in inductive power transfer for transportation applications. IEEE J Emerg Sel Topics Power Electron 1(1):28–41

    Article  Google Scholar 

  3. Morais R, et al. (2008) Sun, wind and water flow as energy supply for small stationary data acquisition platforms. Comput Electron Agric 64:120–132

    Article  Google Scholar 

  4. Weddell A, et al. (2009) Modular plug-and-play power resources for energy-aware wireless sensor nodes. In: Proceedings of the SECON ’09 conference, pp 1–9

  5. Magno M, et al. (2012) Smart power unit with ultra low power radio trigger capabilities for wireless sensor networks. In: Proceedings DATE Conference, pp 75–80

  6. Gursoy M, Jahn S, Deutschmann B, Pelz G (2008) Analysis of conducted emissions in CAN bus systems with VHDL-AMS EMC Europe, pp 147–152

  7. Lu X, Wang P, Niyato D, Kim D, Han Z (2015) Wireless charging technologies: fundamentals, standards, and network applications. IEEE Commun Surv Tutorials:9

  8. Finkenzeller K (2004) RFID handbook: radio-frequency identification fundamentals and applications. Wiley

  9. Dghais W, Rodriguez J (2015) UTTB FDSOI back-gate biasing for low power and high-speed chip design, chapter, wireless internet, of the series lecture notes of the institute for computer sciences, social informatics and telecommunications engineering 146:113–121

  10. Birla S, Shukla KN, Pattanaik M, Singh RK (2010) Device and circuit design challenges for low leakage SRAM for ultra low power applications. Canadian Journal on Electrical & Electronics Engineering 1(7):156–167

    Google Scholar 

  11. Panda PR, Silpa BVN, Shrivastava A, Gummidipudi K (2010) Power-efficient system design, chapter 2. Springer, New York, pp 11–39

    Chapter  Google Scholar 

  12. Dghais W, Rodriguez J (2015) Empirical modelling of FDSOI CMOS inverter for signal/power integrity simulation. In: IEEE proceedings of the 2015 design, automation & test in Europe conference, Grenoble, France

  13. Dghais W, Alam M (2016) Wireless power transfer for energy-efficient electric vehicles. In: 1st EAI international conference on future intelligent vehicular technologies, Porto, Portugal

  14. Ye X, Jin Z, Hu X, Li Y, Lu Q (2013) Modeling and control strategy development of a parallel hybrid electric bus. Int J Automot Technol 14(6):971–85

    Article  Google Scholar 

  15. Dghais W, Rodriguez J (2016) New multiport I/O model for power-aware signal integrity analysis. IEEE Trans Compon Packag Manuf Technol

  16. Stievano S, Maio IA, Canavero FG (2004) Mpilog macromodeling via parametric identification of logic gates. IEEE Trans Adv Packag 27(1):15–23

    Article  Google Scholar 

  17. Dghais W, Bellamine FH (2016) Discrete controlled pre-driver FIR model for hybrid IBIS model AMS simulation. In: IEEE 20th IEEE workshop on signal and power integrity (SPI), p 2016

  18. I/O Buffer Information Specification Version 5.1, 2012 [online] Available: http://eda.org/pub/ibis/ver5.1/ver5-1.pdf

  19. Dghais W, Cunha TR, Pedro JC (2012) A mixed-domain behavioral model’s extraction for digital I/O buffers. In: 21st IEEE conference on electrical performance of electronic packaging and systems, EPEPS, Arizona

  20. Bailey A, Zahrani AA, Fu G, Di J, Smith SC (2008) Multi-threshold asynchronous circuit design for ultra-low power. J Low Power Electron 4:337–348

    Article  Google Scholar 

  21. Suvolta (2011) Body effect and body biasing, technology brief

Download references

Author information

Authors and Affiliations

  1. Department of Microelectronic, Institut Supérieur des Sciences Appliqués et de Technologie de Sousse, Université de Sousse, Sousse, Tunisia

    Wael Dghais

  2. Instituto de Telecomunicações, Campus Universitário de Santiago, 3810-193, Aveiro, Portugal

    Muhammad Alam

Authors
  1. Wael Dghais
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. Muhammad Alam
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to Wael Dghais.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Dghais, W., Alam, M. Wireless Power Transfer and In-Vehicle Networking Integration for Energy-Efficient Electric Vehicles. Mobile Netw Appl 23, 1151–1164 (2018). https://doi.org/10.1007/s11036-016-0779-4

Download citation

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11036-016-0779-4

Keywords

Search

Navigation