A method is proposed for calculating the profile of the rolls of a rotary rolling mill with the use of the 3D-modeling program Autodesk Inventor. The universality of the method is shown for calculating the geometry of rotary rolling within broad ranges of values for the parameters that characterize the mutual position of the axes of the rolls and the semifinished product being rolled.
Similar content being viewed by others
References
Yu. M. Mironov, “Geometric parameters of rotary rolling,” Symp. UkrNITI, Metallurgizdat, Moscow (1962), No. 6, pp. 37–46.
S.M. Gorbatyuk, “Design of rotary rolling mills,” Stal, No. 12, 54–57 (1999).
S. M. Gorbatyuk and L. V. Sedykh, “Improving the durability of rolling-mill rolls,” Metallurg, No. 5, 54–56 (2010).
S. M. Gorbatyuk, A. A. Kamenev, E. Z. Tuktarov, and A. A. Manakov, “Small vacuum-type rotary rolling mill MAMP-10,” Progressive Technologies for Plastic Deformation: Symposium, IRIAS, Moscow (2009), pp. 369–378.
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Metallurg, No. 8, pp. 32–34, August, 2011.
Rights and permissions
About this article
Cite this article
Gorbatyuk, S.M., Osadchii, V.A. & Tuktarov, E.Z. Calculation of the geometric parameters of rotary rolling by using the automated design system autodesk inventor. Metallurgist 55, 543–546 (2011). https://doi.org/10.1007/s11015-011-9465-8
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11015-011-9465-8