Skip to main content
SpringerLink
Log in

The effect of opacifier properties on thermal conductivity of vacuum insulation panel with fumed silica

  • Published:
Journal of Thermal Analysis and Calorimetry Aims and scope Submit manuscript

Abstract

The reduction of radiation heat transfer in VIPs is an important issue. In VIPs, the radiation heat transfer is reduced by the use of opacifier. However, the amount of opacifier also significantly affects the cost of VIP. In this study, the effect of different types and sizes of opacifiers on VIP thermal conductivity was investigated. For this purpose, 6 VIP samples containing different opacifiers (SiC, graphite and calcium aluminate in 3 different grain sizes) were produced. Fumed silica, glass fiber and opacifier were used as fillers in VIP cores at 65%, 20% and 15% (by mass), respectively. VIP samples were vacuumed up to 0.1 Pa, and their thermal conductivity coefficients were measured according to TS EN 12667 standard. In addition, transmittance ratios (%T) of fumed silica, glass fiber, opacifiers and core samples were measured by FTIR spectrophotometer and the mass extinction coefficients of each sample were calculated. The silicon carbide (F1000) as the opacifier (e: 399 m2 kg−1) and the graphite-containing core among the VIP core samples (e: 149 m2 kg−1) exhibited the highest mass absorption coefficient. In addition, the thermal conductivity of the core samples without barrier was measured under 1 Pa vacuum and then the radiation conductivities were calculated from the obtained data. F800 type SiC significantly reduced radiation heat transfer, while the solid conduction of the core was increased due to its relatively coarse grain size. VIP sample with SiC (F1200) provided the lowest thermal conductivity at 0.1 Pa (3.94 mW mK−1). As a result, F1200 type SiC was found to be the most efficient type of opacifier among the investigated opacifiers.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8

Similar content being viewed by others

References

  1. Simmler H, Brunner S, Heinemann U, Schwab H, Kumaran K, Mukhopad-hyaya Ph, Quénard D, Sallée H, Noller K, Kücükpinar-Niarchos E, Stramm C, Tenpierik MJ, Cauberg JJM, Erb M. Vacuum insulation panels. Study on VIP components and panels for service life prediction in building applications (Subtask A). Final report for the IEA/ECBCS Annex 39 HiPTI-project (high performance thermal insulation for buildings and building systems); 2005.

  2. Fantucci S, et al. Analysis of the temperature dependence of the thermal conductivity in vacuum insulation panels. Energy Build. 2019;183:64–74. https://doi.org/10.1016/j.enbuild.2018.10.002.

    Article  Google Scholar 

  3. Fricke J, Heinemann U, Ebert HP. Vacuum insulation panels-from research to market. Vacuum. 2008;82:680–90. https://doi.org/10.1016/j.vacuum.2007.10.014.

    Article  CAS  Google Scholar 

  4. Johansson P. Vacuum insulation panels in buildings literature review. Report in building physics, report 2012:1, Department of Civil and Environmental Engineering, Chalmers University of Technology, Gothenburg, Sweden.

  5. Wilson A. Environmental Building News. Brattleboro, Vermont, USA. BuildingGreen, Inc. This highly regarded monthly newsletter offers breaking news and in-depth analysis of green building issues, including occupant health, in a format that is accessible to general audiences while tailored to design and construction professionals; 2012.

  6. Thomson T. Polyurethanes as specialty chemicals: principles and applications. Boca Raton: CRC Press; 2004.

    Book  Google Scholar 

  7. Sheikholeslami M, Sadoughi M. Mesoscopic method for MHD nanofluid flow inside a porous cavity considering various shapes of nanoparticle. Int J Heat Mass Transf. 2017;113:106–14. https://doi.org/10.1016/j.ijheatmasstransfer.2017.05.054.

    Article  CAS  Google Scholar 

  8. Sheikholeslami M, Sadoughi M. Simulation of CuO–water nanofluid heat transfer enhancement in presence of melting surface. Int J Heat Mass Transf. 2018;116:909–19. https://doi.org/10.1016/j.ijheatmasstransfer.2017.09.086.

    Article  CAS  Google Scholar 

  9. Sheikholeslami M, Ellahi R. Three dimensional mesoscopic simulation of magnetic field effect on natural convection of nanofluid. Int J Heat Mass Transf. 2015;89:779–808. https://doi.org/10.1016/j.ijheatmasstransfer.2015.05.110.

    Article  CAS  Google Scholar 

  10. Sheikholeslami M. Numerical simulation of magnetic nanofluid natural convection in porous media. Phys Lett A. 2017;381:494–503. https://doi.org/10.1016/j.physleta.2016.11.042.

    Article  CAS  Google Scholar 

  11. Ebert HP, Fricke J. Influence of radiative transport on hot-wire thermalconductivity measurements. High Temp High Pressures. 1998;30:655–69.

    Article  CAS  Google Scholar 

  12. Fricke J, et al. Optimized materials and novel concepts for highly efficient insulants. In: Thermal conductivity 30: thermal expansion 18: joint conferences, August 29–September 2, 2009, Pittsburgh, Pennsylvania, USA, vol 30. Lancaster: DEStech Publications, Inc; 2010.

  13. Binz A, Moosmann A, Steinke G, Schonhardt U, Fregnan F, Simmler H, Brunner S, Ghazi K, Bundi R, Heinemann U, Schwab H, Cauberg JJM, Tenpierik MJ, Jóhannesson GA, Thorsell TI, Erb M, Nussbaumer B. Vacuum insulation in the building sector. Systems and applications (Subtask B): IEA/ECBCS Annex 39 High Performance Thermal Insulation (HiPTI); 2005.

  14. Alam M. Development of vacuum insulation panel with low cost core material. Ph.D. thesis, Department of Mechanical, Aerospace and Civil Engineering College of Engineering, Design and Physical Science Brunel University, London, 2015.

  15. Baltaş H, Çelik Ş, Cevik U, Yanmaz E. Measurement of mass attenuation coefficients and effective atomic numbers for MgB2 superconductor using X-ray energies. Radiat Meas. 2007;42(1):55–60. https://doi.org/10.1016/j.radmeas.2006.08.005.

    Article  CAS  Google Scholar 

  16. Modest MF. Radiative heat transfer. London: Academic Press; 2013.

    Book  Google Scholar 

  17. Fricke J. Materials research for the optimization of thermal insulation. High Temp High Pressure. 1993;25:379–90.

    CAS  Google Scholar 

  18. DIN EN 12667:200105. Thermal performance of building materials and products-determination of thermal resistance by means of guarded hot plate and heat flow meter methods.

  19. Baetens R, Jelle BP, Thue JV, Tenpierik MJ, Grynning S, Uvsløkk S, Gustavsen A. Vacuum insulation panels for building applications: a review and beyond. Energy Build. 2010;42(2):147–72. https://doi.org/10.1016/j.enbuild.2009.09.005.

    Article  Google Scholar 

  20. Bouquerel M, Duforestel T, Baillis D, Rusaouen G. Heat transfer modeling in vacuum insulation panels containing nanoporous silicas—a review. Energy Build. 2012;54:320–36. https://doi.org/10.1016/j.enbuild.2012.07.034.

    Article  Google Scholar 

  21. Alam M, Singh H, Brunner S, Naziris C. Experimental characterisation and evaluation of the thermo-physical properties of expanded perlite–fumed silica composite for effective vacuum insulation panel (VIP) core. Energy Build. 2014;69:442–50. https://doi.org/10.1016/j.enbuild.2013.11.027.

    Article  Google Scholar 

  22. Singh H, Geisler M, Menzel F. Experimental investigations into thermal trans- port phenomena in vacuum insulation panels (VIPs) using fumed silica cores. Energy Build. 2015;107:76–83. https://doi.org/10.1016/j.enbuild.2015.08.004.

    Article  Google Scholar 

  23. Demmharter M. Heat transport in evacuated perlite powder insulations and its application in long-term hot water storages. Master thesis, 54, Garching, 2011.

Download references

Acknowledgements

We would like to thank the Scientific and Technological Research Council of Turkey (TUBITAK) for supporting this project with the Project Number 213M740.

Author information

Authors and Affiliations

  1. Department of Construction Technology, Senirkent Vocational School, Isparta Applied Science of University, Isparta, Turkey

    Metin Davraz

  2. Department of Mechanical Engineering, Technology Faculty, Isparta Applied Science of University, Isparta, Turkey

    Murat Koru

  3. Department of Mechatronic Engineering, Technology Faculty, Isparta Applied Science of University, Isparta, Turkey

    Hilmi Cenk Bayrakçi

  4. Research and Development Center, Adel Kalemcilik Tic. ve San. A.S., Kocaeli, Turkey

    Yusuf Yusufoğlu

  5. Department of Mechanical Engineering, Engineering Faculty, Suleyman Demirel University, Isparta, Turkey

    Osman Ipek

Authors
  1. Metin Davraz
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. Murat Koru
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. Hilmi Cenk Bayrakçi
    View author publications

    You can also search for this author in PubMed Google Scholar

  4. Yusuf Yusufoğlu
    View author publications

    You can also search for this author in PubMed Google Scholar

  5. Osman Ipek
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to Murat Koru.

Additional information

Publisher's Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Davraz, M., Koru, M., Bayrakçi, H.C. et al. The effect of opacifier properties on thermal conductivity of vacuum insulation panel with fumed silica. J Therm Anal Calorim 142, 1377–1386 (2020). https://doi.org/10.1007/s10973-020-09277-8

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10973-020-09277-8

Keywords

Search

Navigation