Skip to main content
SpringerLink
Log in

Morphology and mechanical properties of nanocrystalline Cu/Ag alloy

  • Original Paper
  • Published:
Journal of Materials Science Aims and scope Submit manuscript

Abstract

Hybrid Monte Carlo/molecular dynamics (MD) simulations are conducted to study the microstructures of nanocrystalline (nc) Cu/Ag alloys with various Ag concentrations. When the Ag concentration is below 50 Ag atoms/nm2, an increase in Ag concentration leads to a gradual growth of monolayer grain boundary (GB) complexions into nanolayer complexions. Above the concentration of 50 Ag atoms/nm2, wetting layers with a bulk crystalline phase are observed. The effects of Ag on mechanical properties and deformation mechanisms of nc Cu/Ag alloys are investigated in MD simulations of uniaxial tension. GB sliding resistance is found to first increase and then decrease with an increase in Ag concentration. Surprisingly, we also find that the dislocation density decreases monotonically with an increase in Ag concentration, which suggests that the grain interiors are softened by the introduction of Ag dopants at GBs. In addition, there is a critical Ag concentration that maximizes flow stress of nc Cu/Ag alloys. The flow stress, GB sliding resistance, and the intragranular dislocation densities become less sensitive to Ag dopants when the grain diameter increases from 5 to 40 nm.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6

Similar content being viewed by others

References

  1. Sakai Y, Inoue K, Asano T, Wada H, Maeda H (1991) Development of high-strength, high-conductivity Cu–Ag alloys for high-field pulsed magnet use. Appl Phys Lett 59:2965–2967

    Article  Google Scholar 

  2. Koch CC (2003) Optimization of strength and ductility in nanocrystalline and ultrafine grained metals. Scr Mater 49:657–662

    Article  Google Scholar 

  3. Meyers MA, Mishra A, Benson DJ (2006) Mechanical properties of nanocrystalline materials. Prog Mater Sci 51:427–556

    Article  Google Scholar 

  4. Lu L, Sui ML, Lu K (2000) Superplastic extensibility of nanocrystalline copper at room temperature. Science 287:1463–1466

    Article  Google Scholar 

  5. Schiotz J, Jacobsen KW (2003) A maximum in the strength of nanocrystalline copper. Science 301:1357–1359

    Article  Google Scholar 

  6. Schiotz J, Di Tolla FD, Jacobsen W (1998) Softening of nanocrystalline metals at very small grain sizes. Nature 391:561–563

    Article  Google Scholar 

  7. Li A, Szlufarska I (2015) How grain size controls friction and wear in nanocrystalline metals. Phys Rev B 92:075418-1–075418-8

    Google Scholar 

  8. Song JS, Ahn JH, Kim HS, Hong SI (2001) Comparison of microstructure and strength in wire-drawn and rolled Cu-9 Fe-1.2 Ag filamentary microcomposite. J Mater Sci 36:5881–5884. doi:10.1023/A:1012976610114

    Article  Google Scholar 

  9. Seydei MKP, Suthanthiraraj SA (1993) Structural, thermal and transport studies on Ag1−xCuxI(0.05 ≤ x ≤ 0.25) solid electrolyte. J Mater Sci 28:3519–3522. doi:10.1007/BF01159832

    Article  Google Scholar 

  10. Kozlova O, Voytovych R, Protsenko P, Eustathopoulos N (2010) Non-reactive versus dissolutive wetting of Ag–Cu alloys on Cu substrates. J Mater Sci 45:2099–2105. doi:10.1007/s10853-009-3924-7

    Article  Google Scholar 

  11. Bao G, Xu Y, Huang L, Lu X, Zhang L, Fang Y, Meng L, Liu J (2016) Strengthening effect of Ag precipitates in Cu–Ag alloys: a quantitative approach. Mater Res Lett 4:37–42

    Article  Google Scholar 

  12. Vo NQ, Schafer J, Averback RS, Albe K, Ashkenazya Y, Bellon P (2011) Reaching theoretical strengths in nanocrystalline Cu by grain boundary doping. Scr Mater 65:660–663

    Article  Google Scholar 

  13. Chookajorn T, Murdoch HA, Schuh CA (2012) Design of stable nanocrystalline alloys. Science 337:951–954

    Article  Google Scholar 

  14. Tian YZ, Zhang ZF (2009) Microstructures and tensile deformation behavior of Cu–16 wt% Ag binary alloy. Mater Sci Eng A 508:209–213

    Article  Google Scholar 

  15. Shu S, Zhang X, Bellon P, Averback RS (2016) Non-equilibrium grain boundary wetting in Cu–Ag alloys containing W nanoparticles. Mater Res Lett 1:22–26

    Article  Google Scholar 

  16. Kingstedt OT, Eftink BP, Robertson IM, Lambros J (2016) Inelastic strain recovery of a dynamically deformed unidirectional Ag-Cu eutectic alloy. Acta Mater 113:293–300

    Article  Google Scholar 

  17. Eftink BP, Li A, Szlufarska I, Mara NA, Robertson IM (2016) Deformation response of Ag-Cu interfaces investigated by in situ and ex situ TEM straining (in preparation)

  18. Eftink BP, Li A, Szlufarska I, Robertson IM (2016) Interface mediated mechanisms of plastic strain recovery in a Ag-Cu alloy. Acta Mater 117:111–121

    Article  Google Scholar 

  19. Plimpton S (1995) Fast parallel algorithms for short-range molecular dynamics. J Comput Phys 117:1–19

    Article  Google Scholar 

  20. Mishin Y, Mehl MJ, Papaconstantopoulos DA, Voter AF, Kress JD (2001) Structural stability and lattice defects in copper: ab initio, tight-binding, and embedded-atom calculations. Phys Rev B 63:224106-1–224106-16

    Article  Google Scholar 

  21. Williams PL, Mishin Y, Hamilton JC (2006) An embedded-atom potential for the Cu–Ag system. Modell Simul Mater Sci Eng 14:817–833

    Article  Google Scholar 

  22. Youssef KM, Scattergood RO, Murty KL, Koch CC (2004) Ultratough nanocrystalline copper with a narrow grain size distribution. Appl Phys Lett 85:925–931

    Article  Google Scholar 

  23. Sadigh B, Erhart P, Stukowski A, Caro A, Martinez E, Zepeda-Ruiz L (2012) Scalable parallel Monte Carlo algorithm for atomistic simulations of precipitation in alloys. Phys Rev B 85:184203-1–184203-11

    Article  Google Scholar 

  24. Stukowski A, Albe K (2010) Extracting dislocations and non-dislocation crystal defects from atomistic simulation data. Modell Simul Mater Sci Eng 18:085001-1–085001-13

    Google Scholar 

  25. Honeycutt JD, Andersen HC (1987) Molecular dynamics study of melting and freezing of small Lennard-Jones clusters. J Phys Chem 91:4950–4963

    Article  Google Scholar 

  26. Falk ML, Langer JS (1998) Dynamics of viscoplastic deformation in amorphous solids. Phys Rev E 57:7192–7205

    Article  Google Scholar 

  27. Cantwell PR, Tang M, Dillon SJ, Luo J, Rohrer GS, Harmer MP (2014) Grain boundary complexions. Acta Mater 62:1–48

    Article  Google Scholar 

  28. Zheng SJ, Wang J, Carpenter JS, Mook WM, Dickerson PO, Mara NA, Beyerlein IJ (2014) Plastic instability mechanisms in bimetallic nanolayered composites. Acta Mater 79:282–291

    Article  Google Scholar 

  29. Tian YZ, Zhang ZF (2012) Bulk eutectic Cu-Ag alloys with abundant twin boundaries. Scr Mater 66:65–68

    Article  Google Scholar 

  30. Swygenhoven HV, Derlet PM (2001) Grain-boundary sliding in nanocrystalline fcc metals. Phys Rev B 64:224105-1–224105-9

    Google Scholar 

  31. Mo Y, Stone D, Szlufarska I (2011) Strength of ultrananocrystalline diamond controlled by friction of buried interfaces. J Phys D 44:405401-1–405401-10

    Article  Google Scholar 

  32. Kumar KS, Swygenhoven HV, Suresh S (2003) Mechanical behavior of nanocrystalline metals and alloys. Acta Mater 51:5743–5774

    Article  Google Scholar 

  33. Kocks UF (1970) The relation between polycrystal deformation and single crystal deformation. Metall Trans 1:1121–1143

    Google Scholar 

  34. Firstov SA, Rogul OA, Shut OA (2009) Transition from microstructures to nanostructures and ultimate hardening. Funct Mater 16:364–373

    Google Scholar 

  35. Conrad H, Feuerstein S, Rice L (1967) Effects of grain size on the dislocation density and flow stress of niobium. Mater Sci Eng 2:157–158

    Article  Google Scholar 

Download references

Acknowledgements

The authors gratefully acknowledge the financial support from Army Research Office Grant No. W911NF-12-1-0548.

Author information

Authors and Affiliations

  1. Materials Science Program, University of Wisconsin, Madison, WI, USA

    Ao Li & Izabela Szlufarska

  2. Department of Materials Science and Engineering, University of Wisconsin, Madison, WI, USA

    Izabela Szlufarska

Authors
  1. Ao Li
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. Izabela Szlufarska
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to Izabela Szlufarska.

Ethics declarations

Conflict of interest

The authors declare that they have no conflict of interest.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Li, A., Szlufarska, I. Morphology and mechanical properties of nanocrystalline Cu/Ag alloy. J Mater Sci 52, 4555–4567 (2017). https://doi.org/10.1007/s10853-016-0700-3

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10853-016-0700-3

Keywords

Search

Navigation