Abstract
The present work shows the suitability of using industrial fluting papers as raw material for the development of four different substrates, enzymatically refined and/or containing cellulose nanofibers (CNF) in bulk. These four substrates were deeply studied and treated with different coating formulations, containing CNF, polyvinyl alcohol (PVA), native starch and alkyl ketene dimer, with the purpose of evaluating the benefits of using fiber-based packaging paper with improved mechanical, physical and barrier properties. The results showed that if CNF are coated in combination with PVA the tensile properties of paper can be significantly improved, as well as the grease resistance, whereas the air permeability and water vapor transmission rate decrease. The obtained papers present interesting vapor and air barrier properties, at the same time that unconceivable limits of breaking length are achieved (6.44 km). In addition, when a second layer of alkyl ketene dimer was coated on both sides of paper, the water contact angle was significantly improved, being higher than 115°. Overall, the present work shows the feasibility of recycled fibers for the production of high value-added papers that can be used for packaging purposes due to their improved barrier and mechanical properties, and contributes therefore for the bio-based circular economy.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Allaoui S, Aboura Z, Benzeggagh ML (2009) Effects of the environmental conditions on the mechanical behaviour of the corrugated cardboard. Compos Sci Technol 69:104–110. https://doi.org/10.1016/j.compscitech.2007.10.058
Aulin C, Gällstedt M, Lindström T (2010) Oxygen and oil barrier properties of microfibrillated cellulose films and coatings. Cellulose 17:559–574. https://doi.org/10.1007/s10570-009-9393-y
Balea A, Blanco Á, Monte MC et al (2016) Effect of bleached eucalyptus and pine cellulose nanofibers on the physico-mechanical properties of cartonboard. BioResources 11:8123–8138
Biricik Y, Atik C (2012) Effect of cellulase treatment of long fiber fraction on strength properties of recycled corrugated medium. Afr J Biotechnol 11:12199–12205. https://doi.org/10.5897/AJB12.506
Boufi S, González I, Delgado-Aguilar M et al (2016) Nanofibrillated cellulose as an additive in papermaking process: a review. Carbohydr Polym 154:151–166. https://doi.org/10.1016/j.carbpol.2016.07.117
CEPI (2011) The forest fibre industry: 2050 roadmap to a low-carbon bio-economy. 1–46. Available at: http://www.unfoldthefuture.eu/
CEPI (2016) Key statistics 2015. Available at: http://www.cepi.org/statistics/keystatistics2015
COST (2014) Memorandum of understanding COST FP1405—ActinPak. 1–29. Available at: http://www.actinpak.eu/
De Marco JL, Felix CR (2007) Purification and characterization of a β-glucanase produced by Trichoderma harzianum showing biocontrol potential. Braz Arch Biol Technol 50:21–29. https://doi.org/10.1590/S1516-89132007000100003
Delgado-Aguilar M, González I, Tarrés Q et al (2015a) Approaching a low-cost production of cellulose nanofibers for papermaking applications. BioResources 10:5345–5355. https://doi.org/10.15376/biores.10.3.5330-5344
Delgado-Aguilar M, Tarrés Q, Pèlach MÀ et al (2015b) Are cellulose nanofibers a solution for a more circular economy of paper products? Environ Sci Technol 49:12206–12213. https://doi.org/10.1021/acs.est.5b02676
Delgado-Aguilar M, Tarrés Q, Puig J et al (2015c) Enzymatic refining and cellulose nanofiber addition in papermaking processes from recycled and deinked. BioResources 4:5730–5743
Espinosa E, Tarrés Q, Delgado-Aguilar M et al (2016) Suitability of wheat straw semichemical pulp for the fabrication of lignocellulosic nanofibres and their application to papermaking slurries. Cellulose 23:837–852. https://doi.org/10.1007/s10570-015-0807-8
González I, Alcala M, Arbat G et al (2013) Suitability of rapeseed chemithermomechanical pulp as raw material in papermaking. BioResources 8:1697–1708. https://doi.org/10.15376/biores.8.2.1697-1708
Henriksson M, Henriksson G, Berglund LA, Lindström T (2007) An environmentally friendly method for enzyme-assisted preparation of microfibrillated cellulose (MFC) nanofibers. Eur Polym J 43:3434–3441. https://doi.org/10.1016/j.eurpolymj.2007.05.038
Hii C, Gregersen Ø, Chinga-Carrasco G, Eriksen Ø (2012) The effect of MFC on the pressability and paper properties of TMP and GCC based sheets. Nord Pulp Pap Res J 27:388–396. https://doi.org/10.3183/NPPRJ-2012-27-02-p388-396
Hubbe MA (2014) Prospects for maintaining strength of paper and paperboard products while using less forest resources: a review. BioResources 9:1634–1763
Hult EL, Iotti M, Lenes M (2010) Efficient approach to high barrier packaging using microfibrillar cellulose and shellac. Cellulose 17:575–586. https://doi.org/10.1007/s10570-010-9408-8
Isogai A, Saito T, Fukuzumi H (2011) TEMPO-oxidized cellulose nanofibers. Nanoscale 3:71–85. https://doi.org/10.1039/c0nr00583e
Lavoine N, Desloges I, Dufresne A, Bras J (2012) Microfibrillated cellulose—its barrier properties and applications in cellulosic materials: a review. Carbohydr Polym 90:735–764. https://doi.org/10.1016/j.carbpol.2012.05.026
Lavoine N, Desloges I, Khelifi B, Bras J (2014) Impact of different coating processes of microfibrillated cellulose on the mechanical and barrier properties of paper. J Mater Sci 49:2879–2893. https://doi.org/10.1007/s10853-013-7995-0
Li X, Tian J, Shen W (2010) Progress in patterned paper sizing for fabrication of paper-based microfluidic sensors. Cellulose 17:649–659. https://doi.org/10.1007/s10570-010-9401-2
Lindström T, Larsson PT (2008) Alkyl ketene dimer (AKD) sizing: a review. Nord Pulp Pap Res J 23:202–209
Lizundia E, Delgado-Aguilar M, Mutjé P et al (2016) Cu-coated cellulose nanopaper for green and low-cost electronics. Cellulose 23:1997–2010. https://doi.org/10.1007/s10570-016-0920-3
Moral A, Aguado R, Tijero A et al (2017) High-yield pulp from Brassica napus to manufacture packaging paper. BioResource 12:2792–2804
Nygårds S (2011) Nanocellulose in pigment coatings—aspects of barrier properties and printability in offset (Master’s Thesis). Linkoping University, Department of Physics, Chemistry and Biology and Innventia AB, Sweden
Saito T, Isogai A (2004) TEMPO-mediated oxidation of native cellulose. The effect of oxidation conditions on chemical and crystal structures of the water-insoluble fractions. Biomacromol 5:1983–1989. https://doi.org/10.1021/bm0497769
Shinoda R, Saito T, Okita Y, Isogai A (2012) Relationship between length and degree of polymerization of TEMPO-oxidized cellulose nanofibrils. Biomacromolecules 13:842–849
Syverud K, Stenius P (2009) Strength and barrier properties of MFC films. Cellulose 16:75–85. https://doi.org/10.1007/s10570-008-9244-2
Tarrés Q, Delgado-Aguilar M, Pèlach MA et al (2016a) Remarkable increase of paper strength by combining enzymatic cellulose nanofibers in bulk and TEMPO-oxidized nanofibers as coating. Cellulose 23:3939–3950. https://doi.org/10.1007/s10570-016-1073-0
Tarrés Q, Oliver-Ortega H, Llop M et al (2016b) Effective and simple methodology to produce nanocellulose-based aerogels for selective oil removal. Cellulose 23:3077–3088. https://doi.org/10.1007/s10570-016-1017-8
Tarrés Q, Saguer E, Pèlach MA et al (2016c) The feasibility of incorporating cellulose micro/nanofibers in papermaking processes: the relevance of enzymatic hydrolysis. Cellulose 23:1433–1445. https://doi.org/10.1007/s10570-016-0889-y
Tarrés Q, Pèlach MÀ, Alcalà M, Delgado-Aguilar M (2017) Cardboard boxes as raw material for high-performance papers through the implementation of alternative technologies: more than closing the loop. J Ind Eng Chem 54:52–58. https://doi.org/10.1016/j.jiec.2017.05.016
Vaswani S, Koskinen J, Hess DW (2005) Surface modification of paper and cellulose by plasma-assisted deposition of fluorocarbon films. Surf Coat Technol 195:121–129. https://doi.org/10.1016/j.surfcoat.2004.10.013
Zimmermann T, Bordeanu N, Strub E (2010) Properties of nanofibrillated cellulose from different raw materials and its reinforcement potential. Carbohydr Polym 79:1086–1093. https://doi.org/10.1016/j.carbpol.2009.10.045
Acknowledgments
Authors wish to acknowledge the financial support of the Spanish Economy and Competitiveness Ministry to the project CTQ2013-48090-C2-2-R, as well as CYTED for the networking support in the frame of the project P316RT0095 - Red temática NANOCELIA.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Tarrés, Q., Oliver-Ortega, H., Ferreira, P.J. et al. Towards a new generation of functional fiber-based packaging: cellulose nanofibers for improved barrier, mechanical and surface properties. Cellulose 25, 683–695 (2018). https://doi.org/10.1007/s10570-017-1572-7
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10570-017-1572-7