Skip to main content
SpringerLink
Log in

A correlation to evaluate cyclic resistance from CPT applied to a case history

  • Original Research Paper
  • Published:
Bulletin of Earthquake Engineering Aims and scope Submit manuscript

Abstract

A methodology to evaluate the undrained cyclic resistance of sandy deposits from cone penetration tests through the state parameter is applied to the case history of the village of San Carlo (Italy), where widespread liquefaction phenomena occurred during the 2012 Emilia earthquake. The mechanical behaviour of the sand retrieved in the area of San Carlo was characterised within the framework of critical state soil mechanics via a series of monotonic and cyclic triaxial tests carried out on both undisturbed and reconstituted samples. Centrifuge cone penetration tests were also performed on reconstituted models of the same material. The results of centrifuge and undrained cyclic triaxial tests were interpreted through the state parameter to calibrate a direct correlation between the cone resistance, qc and the undrained cyclic resistance ratio (CRR). CRR profiles were deduced from the CPTs performed at sites in San Carlo where liquefaction took place using the correlation calibrated herein and a liquefaction assessment was carried out. The results of the proposed method was compared to a well-known simplified approach.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Fig. 16
Fig. 17
Fig. 18
Fig. 19

Similar content being viewed by others

References

  • Baldi G, Bellotti R, Ghionna V, Jamiolkowski M, Pasqualini E (1982) Design parameters for sand from CPT. In: Proceedings of 2nd ESOPT, Amsterdam, the Netherlands

  • Baldi G, Bellotti R, Ghionna V Jamiolkowski M, Pasqualini E (1986) Interpretation of CPT’s and CPTU’s 2nd par: drained penetration of sands. In: Proceedings of the 4th international geotechnical seminar. Nanyang Technological Institute, Singapore, pp 143–156

  • Baldi G, Belloni G, Maggioni W (1988) The ISMES Geotechnical Centrifuge. In: Corté JF (ed) Centrifuge 88, Paris. Balkema, Rotterdam, pp 45–48

    Google Scholar 

  • Been K, Jefferies MG (1985) A state parameter for sands. Géotechnique 35(2):99–112

    Article  Google Scholar 

  • Been K, Crooks JHA, Becker DE, Jefferies MG (1986) The cone penetration test in sands: part I, state parameter interpretation. Géotechnique 36(2):239–249

    Article  Google Scholar 

  • Bellotti R, Bizzi G, Ghionna V (1982) Design, construction and use of a calibration chamber. In: Proceedings of the ESOPT 11, Amsterdam, vol 2, pp 439–446

  • Bigi G, Bonardi G, Catalano R, Cosentino D, Lentini F, Parotto M, Sartori RSP, Scandone P (1992) Structural model of Italy 1:500,000, CNR-GNDT, Geodinamic Project

  • Bolton MD, Gui MW, Garnier J, Corte JF, Bagge G, Laue J, Renzi R (1999) Centrifuge cone penetration tests in sand. Geotechnique 49(4):543–552

    Article  Google Scholar 

  • Caillemer BM (1975) An experimental study in the U.F. static cone calibration chamber, M.Sc. Thesis, Univ. of Florida, Gainesville

  • Calabrese L, Martelli L, Severi P (2012) Stratigrafia dell’area interessata dai fenomeni di liquefazione durante il terremoto dell’Emilia (Maggio 2012). In: Proceedings of the 31st GNGTS, November 20–22, Potenza, pp 119–125

  • Carter JP, Yeung SK (1985) Analysis of cylindrical cavity expansion in a strain weakening material. Comput Geotech 1:161–180

    Article  Google Scholar 

  • Carter JP, Booker JR, Yeung SK (1986) Cavity expansion in cohesive frictional soils. Géotechnique 36(3):349–358

    Article  Google Scholar 

  • Cetin KO, Seed RB, Kiureghian DA, Tokimastu K, Harder LF, Kayen RE, Moss RES (2004) Standard penetration test-based probabilistic and deterministic assessment of seismic soil liquefaction potential. J Geotech Geoenviron Eng 130(12):1314–1340

  • Fioravante V, Giretti D (2016) Unidirectional cyclic resistance of Ticino and Toyoura sands from centrifuge cone penetration tests. Acta Geotechnica 11(4):953–968. doi:10.1007/s11440-015-0419-3

    Article  Google Scholar 

  • Fioravante V, Jamiolkowski M, Tanizawa F, Tatsuoka F (1991) Calibration chamber tests on Toyoura sand. In: Proceeding of the 1st international symposium on calibration chamber testing ISOCCT1 Potsdam New York USA, pp 135–146

  • Fioravante V, Giretti D, Abate G, Aversa S, Boldini D, Capilleri PP, Cavallaro A, Chamlagain D, Crespellani T, Dezi F, Facciorusso J, Ghinelli A, Grasso S, Lanzo G, Madiai C, Massimino MR, Maugeri M, Pagliaroli A, Rainieri C, Tropeano G, Santucci De Magistris F, Sica S, Silvestri F, Vannucchi G (2013) Earthquake geotechnical engineering aspects of the 2012 Emilia-Romagna earthquake (Italy). In: 7th International conference on case histories in geotechnical engineering, April 29–May 4, 2013, Chicago

  • Galli P, Melloni F (1993) Nuovo catalogo nazionale dei processi di liquefazione avvenuti in occasione dei terremoti storici in Italia. Il Quaternario 6(2):271–292

    Google Scholar 

  • Ghionna V, Jamiolkowski MB (1991) A critical appraisal of calibration chamber testing of sands. In: Proceedings of the first international symposium on calibration chamber testing, Potsdam, NY, USA

  • Giretti D, Fioravante V, Martelli L (2012) Centrifuge tests to evaluate the Po river bank seismic response. In: Proceedings of the 4th international conference on geotechnical and geophysical site characterization (ISC’4), September 15–18, 2012—Porto de Galinhas, Pernambuco, Brazil, pp 1179–1187

  • Holden JC (1971) Research on performance of soil penetrometers. Country Roads Board of Victoria Internal Report CE-SK-7l-l

  • Houlsby GT, Hitchman RC (1988) Calibration tests of cone penetrometers in sand. Géotechnique 8(1):39–44

    Article  Google Scholar 

  • Idriss IM (1999) An update to the Seed-Idriss simplified procedure for evaluating liquefaction potential. Proc, Workshop New Approaches to Liquefaction Analysis, Federal Highway Administration, Washington, DC

    Google Scholar 

  • Idriss IM, Boulanger RW (2008) Soil liquefaction during earthquakes. Earthquake Engineering Research Institute. MNO-12

  • Ishihara K, Iwamoto S, Yasuda S, Takatsu H (1977) Liquefaction of anisotropically consolidated sand. In: Proceedings 9th international conference on soil mechanics and foundation engineering, Japanese Society of Soil Mechanics and Foundation Engineering, Tokyo, Japan, vol 2, pp 261–264

  • Ishihara K, Yamazaki A, Haga K (1985) Liquefaction of K0 consolidated sand under cyclic rotation of principal stress direction with lateral constraint. Soils Found 5(4):63–74

    Article  Google Scholar 

  • Jaky J (1944) The coefficient of earth pressure at rest. J Soc Hung Archit Eng 78:355–358

    Google Scholar 

  • Jefferies M, Been K (2006) Soil liquefaction. A critical state approach. Taylor and Francis, London

    Book  Google Scholar 

  • Juang CH, Jiang T, Andrus RD (2002) Assessing probability based methods for liquefaction potential evaluation. J Geotech Geoenviron Eng 128(7):580–589

  • Juang CH, Fang SY, Khor EH (2006) First-order reliability method for probabilistic liquefaction triggering analysis using CPT. J Geotech Geoenviron Eng 132(3):337–350

    Article  Google Scholar 

  • Lavecchia G, de Nardis R, Cirillo D, Brozzetti F, Boncio P (2012) The May–June 2012 Ferrara Arc earthquakes (northern Italy): structural control of the spatial evolution of the seismic sequence and of the surface pattern of coseismic fractures. Ann Geophys 55(4):533–540

    Google Scholar 

  • Li XS, Wang ZL (1998) Linear representation of steady state line for sand. J Geotech Geoenviron Eng ASCE 124(12):1215–1217

    Article  Google Scholar 

  • Moss RES (2003) CPT-based probabilistic assessment of seismic soil liquefaction initiation. Ph.D. dissertation, Univ. of California, Berkeley, CA

  • Moss RES, Seed RB, Kayen RE, Stewart JP, Der Kiureghian A, Cetin KO (2006) CPT-based probabilistic and deterministic assessment of in situ seismic soil liquefaction potential. J Geotech Geoenviron Eng ASCE 132(8):1032–1051

    Article  Google Scholar 

  • Reese JD (1975) An experimental study on the effects of saturation on the qc and fs values from cone penetration tests in the U.F. Calibration Chamber. M.Sc. Thesis, Univ. of Florida, Gainesville

  • RER and ENI-Agip (1998) Riserve idriche sotterranee della Regione Emilia-Romagna

  • Robertson PK, Wride CE (1998) Evaluating cyclic liquefaction potential using the cone penetration test. Can Geotech J 35(3):442–459

    Article  Google Scholar 

  • Salgado R, Mitchell J, Jamiolkowski M (1997) Cavity expansion and penetration resistance in sand. J Geotech Geoenviron Eng 123(4):344–354

    Article  Google Scholar 

  • Schmertmann JH (1978) Guidelines for cone penetration test, performance and design, report FHWA-TS-787-209, Federal Highway Administration, Washington, July 1978

  • Seed HB, Idriss IM (1971) Simplified procedure for evaluating soil liquefaction potential. J Soil Mech Found Div 97(9):1249–1273

    Google Scholar 

  • Seed HB, Tokimatsu K, Harder LF, Chung RM (1985) The influence of SPT procedures in soil liquefaction resistance evaluations. J Geotech Eng 111(12):1425–1445

  • Toscani G, Burrato P, Di Bucci D, Seno S, Valensise G (2009) Plio-Quaternary tectonic evolution of the northern Apennines thrust fronts (Bologna-Ferrara section, Italy): seismotectonic implications. B Soc Geol Ital (Italian Journal of Geosciences) 128:605–613. doi:10.3301/IJG.2009.128.2.605

    Google Scholar 

Download references

Acknowledgements

The Authors gratefully acknowledge the Seismic Surveys of the Emilia-Romagna Regions for having provided the results of in situ tests and the ISMGEO staff (particularly Mr. Sergio Airoldi and Dr. Andrea Saccenti) for having carried out centrifuge and laboratory tests.

Author information

Authors and Affiliations

  1. University of Ferrara, Via Saragat 1, Ferrara, Italy

    Vincenzo Fioravante

  2. University of Bergamo, Bergamo, Italy

    Daniela Giretti

  3. ISMGEO, Seriate, Bergamo, Italy

    Daniela Giretti & Vincenzo Fioravante

Authors
  1. Daniela Giretti
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. Vincenzo Fioravante
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to Vincenzo Fioravante.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Giretti, D., Fioravante, V. A correlation to evaluate cyclic resistance from CPT applied to a case history. Bull Earthquake Eng 15, 1965–1989 (2017). https://doi.org/10.1007/s10518-016-0057-7

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10518-016-0057-7

Keywords

Search

Navigation