Abstract
Eccentric annular pipe flows represent an ideal model for investigating inhomogeneous turbulent shear flows, where conditions of turbulence production and transport vary significantly within the cross-section. Moreover recent works have proven that in geometries characterized by the presence of a narrow gap, large-scale coherent structures are present. The eccentric annular channel represents, in the opinion of the present authors, the prototype of these geometries. The aim of the present work is to verify the capability of a numerical methodology to fully reproduce the main features of the flow field in this geometry, to verify and characterize the presence of large-scale coherent structures, to examine their behavior at different Reynolds numbers and eccentricities and to analyze the anisotropy associated to these structures. The numerical approach is based upon LES, boundary fitted coordinates and a fractional step algorithm. A dynamic Sub Grid Scale (SGS) model suited for this numerical environment has been implemented and tested. An additional interest of this work is therefore in the approach employed itself, considering it as a step into the development of an effective LES methodology for flows in complex channel geometries. Agreement with previous experimental and DNS results has been found good overall for the streamwise velocity, shear stress and the rms of the velocity components. The instantaneous flow field presented large-scale coherent structures in the streamwise direction at low Reynolds numbers, while these are absent or less dominant at higher Reynolds and low eccentricity. After Reynolds averaging is performed over a long integration time the existence of secondary flows in the cross session is proven. Their shape is found to be constant over the Reynolds range surveyed, and dependent on the geometric parameters. The effect of secondary flows on anisotropy is studied over an extensive Reynolds range through invariant analysis. Additional insight on the mechanics of turbulence in this geometry is obtained.
Similar content being viewed by others
References
Kacker, S.C.: Some aspects of fully developed turbulent flow in non-circular ducts. J. Fluid Mech. 57, 583–682 (1973)
Nikitin, N.V.: Direct numerical simulation of turbulent flows in eccentric pipes. Comput. Math. Math. Phys. 46, 509–526 (2006)
Guellouz, M.S., Tavoularis, S.: The structure of turbulent flow in a rectangular channel containing a cylindrical rod—part 1: Reynolds averaged experiments. Exp. Therm. Fluid Sci. 29, 59–73 (2000)
Gosset, A., Tavoularis, S.: Laminar flow instability in a rectangular channel with a cylindrical core. Phys. Fluids. 18, 044108-1–044108-8 (2006). doi:10.1063/1.2194968
Lumley, J.L.: Stochastic Tools in Turbulence. Academic, New York (1970)
Zang, Y., Street, R.L., Koseff, J.R.: A non-staggered grid, fractional step method for time-dependent incompressible Navier–Stokes equations in curvilinear coordinates. J. Comput. Phys. 114, 1 (1994)
Pope, S.B.: Turbulent Flows. Cambridge University Press, Cambridge (2000)
Jordan, S.A.: A large eddy simulation methodology in generalized curvilinear coordinates. J. Comput. Phys. 148, 322–340 (1999)
Jordan, S.A.: Dynamic subgrid-scale modeling for large-eddy simulations in complex topologies. J. Fluids Eng. 123(3), 619–627 (2001)
Germano, M., Piomelli, U., Moin, P.: A dynamic subgrid-scale eddy viscosity model. Phys. Fluids A. 3, 1760 (1991)
Lund, T.S.: On the Use of Discrete Filters for Large Eddy Simulation. Annual Research Briefs, Stanford University (1997)
Armenio, V., Piomelli, U.: A Lagrangian mixed subgrid-scale model in generalized coordinates. Flow Turbul. Combust. 65, 51–81 (2000)
Merzari, E., Ninokata, H.: Test of LES SGS models for the flow in annular channels. In: Proceedings of ICAPP 2007, Nice, France, 13–18 May 2007
Misawa, T.: Development of a numerical experimental method for the evaluation of the thermal–hydraulic design of fuel with high conversion ratio. Ph.D. thesis, Tokyo Institute of Technology (2004)
Suzuki, T., Kawamura, N.: Consistency of finite—difference scheme in direct simulation of turbulence. Trans. JSME. 60, 578 (1994) (in Japanese)
Kogaki, T., Kobayashi, T., Taniguchi, N.: Proper finite difference schemes for simulations of incompressible turbulent flow in generalized curvilinear coordinates. Trans. JSME. B. 65–633, 1559–1567 (1999) (in Japanese)
Nouri, J.M., Umur, H., Whitelaw, J.H.: Flow of Newtonian and non-Newtonian fluids in concentric and eccentric annuli. J. Fluid Mech. 253, 617–664 (1993)
Chung, S.Y., Rhee, G.H., Sung, H.: Direct numerical simulation of turbulent concentric annular pipe flow—part 1: flow field. Int. J. Heat Fluid Flow. 23, 426–440 (2002)
Jiménez, J., Moin, P.: The minimal flow unit in near-wall turbulence. J. Fluid Mech. 225, 213–240 (1991)
Moin, P.: Direct numerical simulation: a tool in turbulence research. Annu. Rev. Fluid Mech. 30, 539–578 (1998)
Nan-Sheng, L., Xi-Yun, L.: Large eddy simulation of turbulent concentric annular channel flows. Int. J. Numer. Methods Fluids. 45, 1317–1338 (2004)
Neves, J.C., Moin, P., Moser, R.D.: Effects of convex transverse curvature on wall-bounded turbulence. Part 1. The velocity and vorticity. J. Fluid Mech. 272, 349–382 (1973)
Kasagi, N., Horiuti, K., Miyake, Y., Miyauchi, T., Nagano, Y.: Establishment of the direct numerical simulation data bases of turbulent transport phenomena (1992). Available at http://www.thtlab.t.u-tokyo.ac.jp/DNS
Jonsson, V.K., Sparrow, E.M.: Experiments on turbulent-flow phenomena in eccentric annular ducts. J. Fluid Mech. 25, 65–86 (1966)
Azouz, I., Shirazi, S.A.: Evaluation of several turbulence models for turbulent flow in concentric and eccentric annuli. J. Energy Resour. Technol. 120, 268–274 (1998)
Snyder, W.T., Goldstein, G.A.: An analysis of fully developed laminar flow in an eccentric annulus. AIChE J. 11, 462–467 (1965)
Hunt, J., Wray, A., Moin, P.: Eddies, streams and convergence zones in turbulent flows. Report CTR-S88, Center for Turbulence Research, Stanford University (1988)
Hooper, J.D., Rehme, K.: Large-scale structural effect in developed turbulent flows through closely-spaced rod arrays. J. Fluid Mech. 145, 305–337 (1984)
Meyer, L., Rehme, K.: Large-scale turbulence phenomena in compound rectangular channels. Exp. Therm. Fluid Sci. 8, 286–304 (1994)
Berkooz, G., Holmes, P., Lumley, J.L.: The proper orthogonal decomposition in the analisys of turbulent flow. Ann. Rev. Fluid Mech. 25, 539–575 (1993)
Lumley, J.L., Newman, G.R.: The return to isotropy of homogeneous turbulence. J. Fluid Mech. 82, 161–179 (1977)
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Merzari, E., Ninokata, H. Anisotropic Turbulence and Coherent Structures in Eccentric Annular Channels. Flow Turbulence Combust 82, 93–120 (2009). https://doi.org/10.1007/s10494-008-9170-2
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10494-008-9170-2