Abstract
Vibration energy harvesting is to transform the ambient mechanical energy to electricity. How to reduce the resonance frequency and improve the conversion efficiency is very important. In this paper, a layer-separated piezoelectric cantilever beam is proposed for the vibration energy harvester (VEH) for low-frequency and wide-bandwidth operation, which can transform the mechanical impact energy to electric energy. First, the electromechanical coupling equation is obtained by the Euler-Bernoulli beam theory. Based on the average method, the approximate analytical solution is derived and the voltage response is obtained. Furthermore, the physical prototype is fabricated, and the vibration experiment is conducted to validate the theoretical principle. The experimental results show that the maximum power of 0.445 □W of the layer-separated VEH is about 3.11 times higher than that of the non-impact harvester when the excitation acceleration is 0.2 g. The operating frequency bandwidth can be widened by increasing the stiffness of the fundamental layer and decreasing the gap distance of the system. But the increasing of operating frequency bandwidth comes at the cost of reducing peak voltage. The theoretical simulation and the experimental results demonstrate good agreement which indicates that the proposed impact-driving VEH device has advantages for low-frequency and wide-bandwidth. The high performance provides great prospect to scavenge the vibration energy in environment.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
FANG, Z. W., ZHANG, Y. W., LI, X., DING, H., and CHEN, L. Q. Integration of a nonlinear energy sink and a giant magnetostrictive energy harvester. Journal of Sound and Vibration, 391, 35–49 (2017)
ZOU, H., ZHANG, W., LI, W., WEI, K., HU, K., PENG, Z., and MENG, G. Magnetically coupled flextensional transducer for wideband vibration energy harvesting: design, modeling and experiments. Journal of Sound and Vibration, 416, 55–79 (2018)
PEREZ, M., BOISSEAU, S., GASNIER, P., WILLEMIN, J., GEISLER, M., and REBOUD, J. L. A cm scale electret-based electrostatic wind turbine for low-speed energy harvesting applications. Smart Materials and Structures, 25(4), 045015 (2016)
ZHANG, X., PONDROM, P., SESSLER, G. M., and MA, X. Ferroelectret nanogenerator with large transverse piezoelectric activity. Nano Energy, 50, 52–61 (2018)
ANTON, S. R., FARINHOLT, K. M., and ERTURK, A. Piezoelectret foam-based vibration energy harvesting. Journal of Intelligent Material Systems and Structures, 25(14), 1681–1692 (2014)
LU, Z. Q., LI, K., DING, H., and CHEN, L. Q. Nonlinear energy harvesting based on a modified snap-through mechanism. Applied Mathematics and Mechanics (English Edition), 40(1), 167–180 (2019) https://doi.org/10.1007/s10483-019-2408-9
CAO, D. X., LEADENHAM, S., and ERTURK, A. Internal resonance for nonlinear vibration energy harvesting. European Physical Journal-Special Topics, 224(14–15), 2867–2880 (2015)
CAO, D. X., GUO, X. Y., and HU, W. H. A novel low-frequency broadband piezoelectric energy harvester combined with a negative stiffness vibration isolator. Journal of Intelligent Material Systems and Structures, 30(7), 1105–1114 (2019)
ZHANG, W., YAO, Z., and YAO, M. Periodic and chaotic dynamics of composite laminated piezoelectric rectangular plate with one-to-two internal resonance. Science China-Technological Sciences, 52(3), 731–742 (2009)
ZHANG, W., WU, Q. L., and MA, W. S. Chaotic wave motions and chaotic dynamic responses of piezoelectric laminated composite rectangular thin plate under combined transverse and in-plane excitations. International Journal of Applied Mechanics, 10(10), 28 (2018)
ERTURK, A., HOFFMANN, J., and INMAN D. J. A piezomagnetoelastic structure for broadband vibration energy harvesting. Applied Physics Letters, 94(25), 254102 (2009)
SUN, S. and CAO, S. Q. Analysis of chaos behaviors of a bistable piezoelectric cantilever power generation system by the second-order Melnikov function. Acta Mechanica Sinica, 33(1), 200–207 (2017)
LAN, C., QIN, W., and DENG, W. Energy harvesting by dynamic unstability and internal resonance for piezoelectric beam. Applied Physics Letters, 107(9), 093902 (2015)
ZHOU, S., CAO, J., INMAN, D. J., LIN, J., LIU, S., and WANG, Z. Broadband tristable energy harvester: modeling and experiment verification. Applied Energy, 133, 33–39 (2014)
ZHOU, S. and ZUO, L. Nonlinear dynamic analysis of asymmetric tristable energy harvesters for enhanced energy harvesting. Communications in Nonlinear Science and Numerical Simulation, 61, 271–284 (2018)
LAI, S. K., WANG, C., and ZHANG, L. H. A nonlinear multi-stable piezomagnetoelastic harvester array for low-intensity, low-frequency, and broadband vibrations. Mechanical Systems and Signal Processing, 122, 87–102 (2019)
YUAN, T. C., YANG, J., and CHEN, L. Q. Nonlinear dynamics of a circular piezoelectric plate for vibratory energy harvesting. Communications in Nonlinear Science and Numerical Simulation, 59, 651–656 (2018)
ZHAO, L. C., ZOU, H. X., YAN, G., ZHANG, W. M., PENG, Z. K., and MENG, G. Arbitrary-directional broadband vibration energy harvesting using magnetically coupled flextensional transducers. Smart Materials and Structures, 27(9), 095010 (2018)
LIU, D., XU, Y., and LI, J. L. Probabilistic response analysis of nonlinear vibration energy harvesting system driven by Gaussian colored noise. Chaos Solitons & Fractals, 104, 806–812 (2017)
LU, Z. Q., CHEN, L. Q., BRENNAN, M. J., YANG, T., DING, H., and LIU, Z. G. Stochastic resonance in a nonlinear mechanical vibration isolation system. Journal of Sound and Vibration, 370, 221–229 (2016)
LIU, D., XU, Y., and LI, J. Randomly-disordered-periodic-induced chaos in a piezoelectric vibration energy harvester system with fractional-order physical properties. Journal of Sound and Vibration, 399, 182–196 (2017)
LU, Z. Q., DING, H., and CHEN, L. Q. Resonance response interaction without internal resonance in vibratory energy harvesting. Mechanical Systems and Signal Processing, 121, 767–776 (2019)
UMEDA, M., NAKAMURA, K., and UEHA, S. Analysis of the transformation of mechanical impact energy to electric energy using piezoelectric vibrator. Japanese Journal of Applied Physics Part 1-Regular Papers Short Notes & Review Papers, 35(5B), 3267–3273 (1996)
HALIM, M. A., KIM, D. H., and PARK, J. Y. Low frequency vibration energy harvester using stopper-engaged dynamic magnifier for increased power and wide bandwidth. Journal of Electrical Engineering & Technology, 11(3), 707–714 (2016)
HALIM, M. A. and PARK, J. Y. Piezoceramic based wideband energy harvester using impact-enhanced dynamic magnifier for low frequency vibration. Ceramics International, 41, S702–S707 (2015)
HALIM, M. A. and PARK, J. Y. Theoretical modeling and analysis of mechanical impact driven and frequency up-converted piezoelectric energy harvester for low-frequency and wide-bandwidth operation. Sensors and Actuators A: Physical, 208, 56–65 (2014)
LIU, H., LEE, C., KOBAYASHI, T., TAY, C. J., and QUAN, C. Investigation of a MEMS piezoelectric energy harvester system with a frequency-widened-bandwidth mechanism introduced by mechanical stoppers. Smart Materials and Structures, 21(3), 035005 (2012)
LI, S., CROVETTO, A., PENG, Z., ZHANG, A., HANSEN, O., WANG, M., LI, X., and WANG, F. Bi-resonant structure with piezoelectric PVDF films for energy harvesting from random vibration sources at low frequency. Sensors and Actuators A: Physical, 247, 547–554 (2016)
YUAN, T. C., YANG, J., and CHEN, L. Q. A harmonic balance approach with alternating frequency/time domain progress for piezoelectric mechanical systems. Mechanical Systems and Signal Processing, 120, 274–289 (2019)
DECHANT, E., FEDULOV, F., CHASHIN, D. V., FETISOV, L. Y., FETISOV, Y. K., and SHAMONIN M. Low-frequency, broadband vibration energy harvester using coupled oscillators and frequency up-conversion by mechanical stoppers. Smart Materials and Structures, 26(6), 065021 (2017)
LIU, S., CHENG, Q., ZHAO, D., and FENG, L. Theoretical modeling and analysis of two-degree-of-freedom piezoelectric energy harvester with stopper. Sensors and Actuators A: Physical, 245, 97–105 (2016)
ZHAO, D., LIU, S., XU, Q., SUN, W., WANG, T., and CHENG, Q. Theoretical modeling and analysis of a 2-degree-of-freedom hybrid piezoelectric-electromagnetic vibration energy harvester with a driven beam. Journal of Intelligent Material Systems and Structures, 29(11), 2465–2476 (2018)
Author information
Authors and Affiliations
Corresponding author
Additional information
Project supported by the National Natural Science Foundation of China (Nos. 11672008, 11702188, and 1832002)
Rights and permissions
Open Access This article is licensed under a Creative Commons Attribution 4.0 International License, which permits use, sharing, adaptation, distribution and reproduction in any medium or format, as long as you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons licence, and indicate if changes were made. To view a copy of this licence, visit http://creativecommons.org/licenses/by/4.0/.
About this article
Cite this article
Cao, D., Xia, W. & Hu, W. Low-frequency and broadband vibration energy harvester driven by mechanical impact based on layer-separated piezoelectric beam. Appl. Math. Mech.-Engl. Ed. 40, 1777–1790 (2019). https://doi.org/10.1007/s10483-019-2542-5
Received:
Revised:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10483-019-2542-5