Abstract
The effect of suspended sediment concentrations (SSC) on fluid turbulence in an annular flume was investigated. Flow speed was held constant at 0.57 m s−1, and the resulting turbulent conditions were recorded using a 3-D Acoustic Doppler Velocimeter (ADV) at height (z) of 8.5 cm above the bed. The suspended material was composed of a natural glacial clay made up of particles smaller than 6 μm. The SSC in the flume were increased from clear water to 4800 mg l−1 in nine discrete increments; temporal variations of SSC were monitored using three optical backscatter sensors (OBS) mounted in the flume wall at heights of 0.03, 0.10 and 0.20 m above the flume base. The results showed that turbulent intensity (\(\overline { {q}^{2}}/ \overline {U} ^{2}\) ) and energy dissipation rate (ɛ) did not change significantly between clear water and 200 mg l−1, but decreased by nearly 30% in the SSC range between 200 and 2400 mg l−1. Above 2400 mg l−1, no further decrease was observed. Analyses of the velocity variances over narrow frequency bands (0.2 Hz wide) from 0 to 12.5 Hz showed that most of the flow turbulent energy (~70–80%) was contained within the lower frequencies i.e. larger eddies, and that these eddies experienced the greatest decrease in energy due to turbidity. It is proposed that these patterns are the consequence of the increase in suspended sediment concentrations and of the vertical stratification of sediments for SSC >200 mg l−1.
Similar content being viewed by others
References
Amos C.L., Feeny T., Sutherland T.F. and Luternauer J.L. 1997. The stability of fine-grained sediments from the Fraser river delta. Estuar. Coast. Shelf. Sci. 45: 507–524.
Amos C.L., Grant J., Daborn G.R. and Black K. (1992). Sea Carousel – a benthic, annular flume. Estuar. Coast. Shelf Sci. 34: 557–577
Amos C.L., Sutherland T.F. and Zevenhuizen J. (1996). The stability of sublittoral, fine-grained sediments in a subarctic estuary. Sedimentoloy 43: 1–19
Amos C.L., Sutherland T.F., Cloutier D. and Patterson S. (2000). Corrasion of a remoulded cohesive bed by saltating littorinid shells. Cont. Shelf Res. 20: 1291–1315
Baker E.T. and Lavelle J.W. (1984). The effect of particle size on the light attenuation coefficient of natural suspensions. J. Geophys. Res. 89(C5): 8197–8203
Bes J.L. and Leeder M.R. (1993). Drag reduction in turbulent muddy seawater flows and some sedimentary consequences. Sedimentology 40: 1129–1137
Black K.S. and Patterson D.M. (1997). Measurement of the erosion potential of cohesive marine sediments : a review of current in situ technology. J. Mar. Environ. Eng. 4: 43–83
Cloutier D., Amos C.L., Hill P.R. and Lee K. (2002). Oil erosion in an annular flume by seawater of varying turbidities: A critical bed shear stress approach. Oil Spill Sci. Technol. Bull. 8(1): 83–93
Conner C.S. and De Visser A.M. (1992). A laboratory investigation of particle size effects on an optical backscatterance sensor. Mar. Geol. 108: 151–159
Costa M.A.V., Teixeira S.F.C.F. and Teixeira J.C.F 2000. Flow measurements in a simulated estuary bed. In 10th International Symposium on Applications of Laser Techniques to Fluid Mechanics, Lisboa 200, Paper 37.6.
Dade W.B. and A. Nowell R.M. 1991. Moving muds in the marine environment. In: Coastal Sediments 1991. Publication of the American Society of Civil Engineers : 54–71.
Downing J.P. and Beach R.A. (1989). Laboratory apparatus for calibrating optical suspended solids sensors. Mar. Geol. 86: 243–249
Droppo I.G., Lau Y.L. and Mitchell C. (2001). The effect of depositional history on contaminated bed sediments stability. Sci. Tot. Environ. 266(103): 7–13
Eaton J.K. and Fessler J.R. (1994). Preferential concentrations of particles by turbulence. Int. J. Multiphas. Flow 20: 169–209
Eisma D. 1986. Flocculation and deflocculation of suspended matter in estuaries. Neth. J. Sea Res. 20: 183–199.
Fung A. 1995. Accurate calibration measurements of flow in Lab Carousel under varying lid rotations. Contract No. 23420-5-M083/01-HAL. Halifax, N. S.
Grant W.D., Stewart R.W. and Moilliet A. (1962). Turbulence spectra from a tidal channel. J. Fluid Mech. 14: 506–527
Green M.O. and Boon J.D. (1993). The measurement of constituent concentrations in non homogenous sediment suspensions using optical backscatter sensors. Mar. Geol. 110: 73–81
Gust G. (1976). Observations on turbulent-drag reduction in a dilute suspension of clay in sea water. J. Fluid Mech. 75(1): 29–47
Gust G. and Walger E. (1976). The influence of suspended cohesive sediments on boundary-layer structure and erosive activity of turbulent sea water flow. Mar. Geol. 22: 189–206
Heathershaw A.D. and Langhorne D.N. (1988). Observations of near-bed velocity profiles and seabed roughness in tidal currents flowing over sandy gravels. Estuar. Coast. Shelf Sci. 26: 459–482
Kawanisi K. and Yokosi S. (1997a). Measurements of turbulence and suspended sediment in tidal river. J. Hydraul. Eng. 119(6): 704–724
Kawanisi K. and Yokosi S. (1997b). Characteristics of suspended sediment and turbulence in a tidal boundary layer. Cont. Shelf Res. 17(8): 859–875
Kineke G.C. and Sternberg R.W. (1992). Measurements of high concentration suspended sediments using the optical backscatterance sensor. Mar. Geol. 108: 253–258
Kline S.J., Reynolds W.C., Schraub F.A. and Runstadler P.W. (1967). The structures of turbulent boundary layers. J. Fluid Mech. 95: 741–773
Krishnappan B.G. 1993. Rotating circular flume. J. Hydraul. Eng. 119 (6): No. 3108.
LeCouturier M.N. and Amos C.L. in preparation. The characterisation of flow turbulence inside a large and a small annular flume.
Li M.Z. and Gust G. (2000). Boundary layer dynamics and drag reduction in flows of high cohesive sediment suspensions. Sedimentology 47: 71–96
Ludwig K.A. and Hanes D.M. (1990). A laboratory evaluation of optical backscatterance suspended solids exposed to sand-mud mixtures. Mar. Geol. 94: 173–179
Lumley J.L. (1969). Drag reduction by additives. Ann. Rev. Fluid Mech. 1: 367–384
Milligan T.G. and Hill P.S. (1998). A laboratory assessment of the relative importance of turbulenceparticle composition and concentration in limiting maximum floc size. J. Sea Res. 39: 227–241
Manning A.J. and Dyer K.R. (1999). A laboratory examination of floc characteristics with regard to turbulent shearing. Mar. Geol. 160(1–2): 147–170
Partheniades E., Cross R.H. and Ayora A. 1968. Further results on the deposition of cohesive sediments. In Proceedings of the Eleventh Conference on Coastal Engineering, London 723–742.
Peterson O. and Krishnappan B.G. (1994). Measurement and analysis of flow characteristics in a rotating annular flume. J. Hydraul. Res. 32(4): 483–493
Schoellhamer D.H., Cacchione D.A., Rubin D.M., Cheng R.T., Dingler J.R. and Jaffe B.E. 1997. Sediment-transport research in San Francisco Bay. In Proceedings of the U. S. Geological Survey (USGS) Sediment Workshop, February 4–7.
Sheng Y.P. and Villaret C. (1989). Modelling the effect of suspended sediment stratification on bottom exchange processes. J. Geophys. Res. 94(C10): 14,429–14,444
Soulsby R.L. and Dyer K.R. (1981). The form of the near bed velocity profile in a tidally accelerating flow. J. Geophys. Res. 86: 8067–8074
Soulsby R.L., Atkins R. and Sakfiel A.P. (1994). Observations of the turbulent structure of a suspension of sand in a tidal current. Cont. Shelf Res. 14: 429–435
Terzaghi K. and Peck R.B. (1967). Soil Mechanics in Engineering Practise. Wiley, New York, 729
Thompson C., Amos C.L., Lecouturier M. and Jones T.E.R. (2004). Flow deceleration as a method of determining drag coefficients over roughened flat beds. J. Geophys. Res. 109(C03001): 1–12
Tennekes H. and Lumley J.L. (1972). A First Course in Turbulence. MIT Press, Cambridge, 340
Toorman E.A. 2000a. Modelling of Turbulence Damping in Sediment-Laden Flow, Part 3, Drag Reduction Damping in Sediment-Laden Flow. Report No. HYD/ET/00/COSINUS/5, 15 p.
Toorman E.A. 2000b. Parameterisation of Turbulence Damping in Sediment-Laden Flow. Report No. HYD/ET/00/COSINUS/3 : 1–31.
van Leussen W. (1999). The variability of settling velocities of suspended fine-grained sediment in the Ems estuary. J. Sea Res. 41(1–2): 109–118
Voulgaris G. and Trowbridge J.H. (1998). Evaluation of the Acoustic Doppler velocimeter (ADV) for turbulence measurements. J. Atmos. Ocean. Technol. 15(1): 272–289
Widdows J., Brinsley M.D., Bowley N. and Barrett C. (1998). A benthic annular flume for in situ measurement of suspension feeding/biodeposition rates and erosion potential of intertidal cohesive sediments. Estuar. Coast. Shelf Sci. 46: 27–38
Wolanski E., Ascaeda T. and Imberger J. (1989). Mixing across a lutocline. Limnol. Oceanogr. 34: 931–938
Wood W.H., Granquist W.T. and Krieger I.M. 1955. Viscosity studies on dilute clay mineral suspensions. In Proceedings 1st-15th1952–1966 National Conference on Clays and Clay Minerals, Pergamon Press 456: 240–250.
Yang Z., Baptista A. and Darland J. (2000). Numerical modelling of flow characteristics in a rotating annular flume. Dynam. Atmos. Oceans 31: 271–294
Young R.A. (1977). Seaflume : A device for in-situ studies of threshold erosion velocity and erosional behaviour of undisturbed marine muds. Mar. Geol. 23: M11–M18
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Cloutier, D., LeCouturier, M.N., Amos, C.L. et al. The effects of suspended sediment concentration on turbulence in an annular flume. Aquat Ecol 40, 555–565 (2006). https://doi.org/10.1007/s10452-005-4810-2
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10452-005-4810-2