Abstract
Touchdown detection by thermal-flying height control (TFC) has been implemented to calibrate flying height (FH) of magnetic sliders for all hard disk drives. For bit patterned media (BPM) to be successful as a revolutionary technology to further increase recording areal density, it must experience the touchdown process with similar robustness as conventional continuous media. Here we numerically study the tribological impact of TFC touchdown detection on the continuous media and unplanarized BPM by three-dimensional (3D) transient finite-element models with the frictional heating and thermal-elastic-plastic materials included. Our results demonstrate that the continuous media exhibits no plastic deformation due to the TFC touchdown with an over-push as large as 2 nm, whereas the plastic strain of the BPM may reach 3 % at higher sliding velocities, and it exists over a wide range of bulge radius and disk velocity. Such plastic deformation can lead to permanent media damage and data loss. Besides, the temperature rise of the BPM (~27 K) is approximately 1.3 times of that of the continuous media (~21 K), and may have to be considered when designing a robust head-disk interface for BPM. Although planarization may improve slider’s flyability performance, our analysis shows that planarizing BPM with SiO2 deteriorates the tribological robustness of the media in particular at a high disk velocity probably due to the inhomogeneous composition and mismatch of material properties between the filling material and recording material. Hence extreme caution must be exercised when choosing a filling material.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Crone R, Dagastine RR, White LR et al (2006) van der Waals interactions between the air-bearing surface and a lubricated glass disk: a comparative study. Appl Phys Lett 88:022509. doi:10.1063/1.2164898
Grobis M, Dobisz E, Hellwig O et al (2010) Measurements of the write error rate in bit patterned magnetic recording at 100–320 Gb/in[sup 2]. Appl Phys Lett 96:052509. doi:10.1063/1.3304166
Juang J-Y, Bogy DB (2005) Controlled-flying proximity sliders for head-media spacing variation suppression in ultralow. IEEE Trans Magn 41:3052–3054
Juang J-Y, Bogy DB (2006) Nonlinear compensator design for active sliders to suppress head-disk spacing modulation in hard disk drives. IEEE/ASME Trans Mechatron 11:256–264
Juang J-Y, Bogy DB (2007) Air-bearing effects on actuated thermal pole-tip protrusion for hard disk drives. J Tribol 129:570. doi:10.1115/1.2736456
Juang J-Y, Lin K-T (2013) Touchdown of flying recording head sliders on continuous and patterned media. IEEE Trans Magn 49:2477–2482. doi:10.1109/TMAG.2013.2249054
Juang J-Y, Chen D, Bogy DB (2006) Alternate air bearing slider designs for areal density of 1 Tb/in 2. IEEE Trans Magn 42:241–246
Juang J-Y, Nakamura T, Knigge B et al (2008) Numerical and experimental analyses of nanometer-scale flying height control of magnetic head with heating element. IEEE Trans Magn 44:3679–3682. doi:10.1109/TMAG.2008.2002612
Juang J-Y, Forrest J, Huang F-Y (2011) Magnetic head protrusion profiles and wear pattern of thermal flying-height control sliders with different heater designs. IEEE Trans Magn 47:3437–3440. doi:10.1109/TMAG.2011.2147773
Lee KM, Yeo C-D, Polycarpou A (2006) Nanomechanical property and nanowear measurements for sub-10-nm thick films in magnetic storage. Exp Mech 47:107–121. doi:10.1007/s11340-006-9393-x
Li L, Bogy DB (2011) Dynamics of air bearing sliders flying on partially planarized bit patterned media in hard disk drives. Microsyst Technol 17:805–812. doi:10.1007/s00542-010-1191-9
Li L, Song W, Zhang C et al (2012) Investigation of thermo-mechanical contact between slider and bit patterned media. Microsyst Technol 18:1567–1574. doi:10.1007/s00542-012-1593-y
Mate CM, Ruiz OJ, Wang R-H et al (2012) Tribological challenges of flying recording heads over unplanarized patterned media. IEEE Trans Magn 48:4448–4451. doi:10.1109/TMAG.2012.2205226
Nunez EE, Yeo C, Katta RR, Polycarpou AA (2008) Effect of planarization on the contact behavior of patterned media. IEEE Trans Magn 44:3667–3670
Ono K, Nakagawa K (2008) Dynamic adhesion characteristics of spherical sliders colliding with stationary magnetic disks with a thin lubricant layer. Tribol Lett 31:77–89. doi:10.1007/s11249-008-9340-3
Ovcharenko A, Yang M, Chun K, Talke FE (2010) Simulation of magnetic erasure due to transient slider–disk contacts. IEEE Trans Magn 46:770–777. doi:10.1109/TMAG.2009.2035092
Su L, Hu Y, Lam EL et al (2011) Tribological and dynamic study of head disk interface at sub-1-nm clearance. IEEE Trans Magn 47:111–116
Yang Y (2004) Detailed modeling of temperature rise in giant magnetoresistive sensor during an electrostatic discharge event. J Appl Phys 95:6780. doi:10.1063/1.1652426
Zeng Q, Yang C, Ka S, Cha E (2011) An experimental and simulation study of touchdown dynamics. 47:3433–3436
Acknowledgments
This work is supported in part by the National Science Council of Taiwan under Contract NSC 101-2221-E-002-151 and NSC 102-2221-E-002-178.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Juang, JY., Wu, W. & Lin, KT. Tribological impact of touchdown detection on bit patterned media robustness. Microsyst Technol 20, 1745–1751 (2014). https://doi.org/10.1007/s00542-014-2228-2
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00542-014-2228-2