Abstract
For optimization purposes at double face grinding with planetary kinematics, an additional development of the tools is necessary. Designing requirement-oriented tools implies deep-process knowledge. Within researches at the Institute for Machine Tools and Factory Management, an analytical simulation model was developed. Including the chip thickness into the model, it will be possible to calculate the tool wear. By the help of analytical simulations, wear-optimized process strategies and requirement-oriented tools can be developed.
Similar content being viewed by others
References
Funck A (1995) Planschleifen mit Läppkinematik. Dissertation, Technical University Berlin
Uhlmann E, Ardelt T, Daus N (1998) Kinematische Analyse von Zweischeibenmaschinen. Werkstatttechnik 88(6):273–276
Rußner C (2006) Präzisionsplanschleifen von Al2O3Keramik unter Produktionsbedingungen. Dissertation, Technische Universität Dresden
Uhlmann E, Sammler C, Hoghé T, Borsio Klein T (2006) Einsatz innovativer Schleifverfahren macht Hochleistungsbearbeitung wirtschaftlicher. Maschinenmarkt Issue 30:22–26
Oliveira JFG, Silva EJ, Guo C, Hashimoto F (2009) Industrial challenges in grinding. Ann CIRP 58:663–680
Uhlmann E, Hoghé T (2011) Hoppla – Entwicklung einer wirtschaftlichen Bearbeitungstechnologie für das Hochgeschwindigkeits- und Hochleistungsplanschleifen mit Planetenkinematik. VDI/VDE-IT, Berlin
Uhlmann E, Hoghé T (2012) Wear reduction at double face grinding with planetary kinematics. Prod Eng Res Dev 6(3):237–242
Spur G, Simpfendörfer D (1985) Simulation der Kinematik des Plan(parallel)läppens. Zeitschrift für wirtschaftlichen Fabrikbetrieb 80(7):318–324
Simpfendörfer D (1988) Entwicklung und Verifizierung eines Prozeßmodells beim Planläppen. Dissertation, Technical University Berlin
Spur G, Funck A, Engel A (1995) Problems of flatness in plane surface grinding. Trans NAMRI/SME 13:97–102
Uhlmann E, Ardelt T, Stingl P, Rußner C, Magg T, Reiser A (1999) Planschleifen mit Läppkinematik. Ind Diamanten Rdsch IDR 33(1):79–83
Uhlmann E, Ardelt T (2000) Influence of kinematics on the face grinding process on lapping machines. Ann CIRP 48(1):281–284
Uhlmann E, Ardelt T (2000) Kinematik und Prozeßverhalten beim Planschleifen mit Läppkinematik. Feinstbearbeitung technischer Oberflächen, Tagungsband zum 5. Int. IWF-Kolloquium pp 93–105
Ardelt T (2001) Einfluss der Relativbewegung auf den Prozess und das Arbeitsergebnis beim Planschleifen mit Planetenkinematik. Dissertation, Technical University Berlin
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Uhlmann, E., Hoghé, T. & Kleinschnitker, M. Grinding wheel wear prediction at double face grinding with planetary kinematics using analytic simulation. Int J Adv Manuf Technol 69, 2315–2321 (2013). https://doi.org/10.1007/s00170-013-5197-1
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00170-013-5197-1