PGE geochemistry of the Eagle Ni–Cu–(PGE) deposit, Upper Michigan: constraints on ore genesis in a dynamic magma conduit

Abstract

The Eagle Ni–Cu–(PGE) deposit is hosted in mafic–ultramafic intrusive rocks associated with the Marquette–Baraga dike swarm in northern Michigan. Sulfide mineralization formed in association with picritic magmatism in a dynamic magma conduit during the early stages in the development of the ~1.1 Ga Midcontinent Rift System. Four main types of sulfide mineralization have been recognized within the Eagle deposit: (1) disseminated sulfides in olivine-rich rocks; (2) rocks with semi-massive sulfides located both above and below the massive sulfide zone; (3) massive sulfides; and (4) sulfide veins in sedimentary country rocks. The disseminated, massive and lower semi-massive sulfide zones are typically composed of pyrrhotite, pentlandite and chalcopyrite, whereas the upper semi-massive sulfide ore zone also contains pyrrhotite, pentlandite, and chalcopyrite, but has higher cubanite content. Three distinct types of sulfide mineralization are present in the massive sulfide zone: IPGE-rich, PPGE-rich, and PGE-unfractioned. The lower and upper semi-massive sulfide zones have different PGE compositions. Samples from the lower semi-massive sulfide zone are characterized by unfractionated PGE patterns, whereas those from the upper semi-massive sulfide zone show moderate depletion in IPGE and moderate enrichment in PPGE. The mantle-normalized PGE patterns of unfractionated massive and lower semi-massive sulfides are subparallel to those of the disseminated sulfides. The results of numerical modeling using PGE concentrations recalculated to 100% sulfide (i.e., PGE tenors) and partition coefficients of PGE between sulfide liquid and magma indicate that the disseminated and unfractionated massive sulfide mineralization formed by the accumulation of primary sulfide liquids with similar R factors between 200 and 300. In contrast, the modeled R factor for the lower semi-massive sulfide zone is <100. The fractionated sulfide zones such as those of the IPGE-rich and PPGE-rich massive sulfides and the upper semi-massive sulfide zone can be explained by fractional crystallization of monosulfide solid solution from sulfide liquids. The results of numerical modeling indicate that the sulfide minerals in the upper semi-massive sulfide zone are the products of crystallization of fractionated sulfide liquids derived from a primary sulfide liquid with an R factor similar to that for the disseminated sulfide mineralization. Interestingly, the modeled parental sulfide liquid for the IPGE-rich and PPGE-rich massive sulfide zones has a higher R factor (~400) than that for the unfractionated massive sulfide mineralization. Except one sample which has unusually high IPGE and PPGE contents, all other samples from the Cu-rich sulfide veins in the footwall of the intrusion are highly depleted in IPGE and enriched in PPGE. These signatures are generally consistent with highly fractionated sulfide liquids expelled from crystallizing sulfide liquid. Collectively, our data suggest that at least four primary sulfide liquids with different R factors (<100, 200–300, ~400) were involved in the formation of the Eagle magmatic sulfide deposit. We envision that the immiscible sulfide liquids were transported from depth by multiple pulses of magma passing through the Eagle conduit system. The sulfide liquids were deposited in the widened part of the conduit system due to the decreasing velocity of magma flow. The presence of abundant olivine in some of the sulfide ore zones indicates that the ascending magma also carried olivine crystals. Sulfide saturation was attained in the parental magma due in large part to the assimilation of country rock sulfur at depth.