Abstract
An Al-4·5Cu-10Pb alloy was processed by spray forming as well as impeller mixing followed by chill casting methods. The microstructure, mechanical properties and dry sliding wear characteristics of the alloy were evaluated. The spray formed alloy showed an equiaxed grain morphology with a uniform dispersion of lead particles in the matrix phase. In contrast a cellular-dendritic morphology of the primary phase was the characteristic feature of the alloy processed by impeller mixing and chill casting method. The spray formed alloy indicated its superior mechanical properties and low wear rate particularly at higher applied load and sliding velocity. The possible reason for this behaviour is discussed in the light of microstructure of the alloy and the nature of the worn out surfaces of the wear test specimens.
Similar content being viewed by others
References
Burbunov V G, Parshin V D and Panin V V 1973Russian Cast. Prod. 9 353
Eppich R E, Mebbers F J and Dawson R N 1971Met. Engg. Quart. 11 33
Flemings M C 1974Solidification processing (New York: McGraw-Hill) p. 266
Forrester P G 1960Metall. Rev. 5 507
Ichikawa K and Ishizuka S 1987Trans. Jap. Inst. Metals 28 145
Lavenia E J 1989Int. J. Rapid Solidification 5 47
Lun B 1957Wear 1 25
Mohan S, Agarwala V and Ray S 1989Z. Metallkunde 80 556
Mondolfo L F 1976Aluminium alloys: Structure and properties (London: Butterworth) p. 352
Ojha S N, Mandal R K and Gauthama 1994 inNovel techniques in synthesis and processing of advanced materials (eds) J Singh and S M Copley (Warrendale, Pennsylvania: TMS) p. 375
Ojha S N, Pandey O P, Tripathi B, Kumar M and Ramachandra C 199233 519
Ojha S N, Tripathi A K and Singh S N 1993Powder Met. Int. 2 65
Pathak J P, Karimi D and Tiwari S N 1993Wear 107 109
Pathak J P, Tiwari S N and Malhotra S L 1986Wear 112 341
Pathak J P and Tiwari S N 1991Trans. Indian Inst. Metals 144 341
Pathak J P and Tiwari S N 1992Wear 155 37
Pathak J P and Tiwari S N 1993India Foundry J. 14 3
Pathak J P, Torbian H and Tiwari S N 1995Cast Metals 7 201
Pratt G C 1973Inter. Metall. Rev. 18 62
Sarkar A D 1976Wear of metals (Oxford: Pergamon) p. 49
Singh S N, Mishra N S and Ojha S N 1992Steel Res. 63 12
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Pathak, J.P., Ojha, S.N. Effect of processing on microstructure and wear characteristics of an Al-4·5Cu-10Pb alloy. Bull. Mater. Sci. 18, 975–988 (1995). https://doi.org/10.1007/BF02745184
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF02745184