Skip to main content
Log in

Surface characterization of sol-gel derived indium tin oxide films on glass

  • Published:
Bulletin of Materials Science Aims and scope Submit manuscript

Abstract

Indium tin oxide (ITO) films containing different In : Sn atomic ratios, viz. 90 :10, 70 :30, 50 : 50, 30 :70, were deposited on two types of glass substrates by sol-gel spinning technique. XPS analysis of the films was done under as-received and after-sputtering conditions. The narrow spectra obtained for the Na1s, In3d, Sn3d and O1s have been discussed. Oxygen was found to exist in three chemical environments in as-received samples due to the existence of (i) environmental hydroxyl (-OH) group, (ii) crystalline ITO and (iii) amorphous ITO; but it was in two chemical environments, (ii) and (iii), after surface cleaning by sputtering. The presence of both tin metal and tin oxides was confirmed by the peak analysis of Sn3d. The In : Sn atomic ratio taken in the precursor sols did not change considerably in the case of developed films of low Sn content, but considerable change was observed in the films having high Sn content.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

References

Download references

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to P. K. Biswas.

Rights and permissions

Reprints and permissions

About this article

Cite this article

Biswas, P.K., De, A., Dua, L.K. et al. Surface characterization of sol-gel derived indium tin oxide films on glass. Bull Mater Sci 29, 323–330 (2006). https://doi.org/10.1007/BF02706504

Download citation

  • Received:

  • Revised:

  • Issue Date:

  • DOI: https://doi.org/10.1007/BF02706504

Keywords

Navigation