Abstract
Measurements of pearlite growth rate and inter lamellar spacing have been made on isothermally transformed specimens of Cu-11.8 wt pct Al eutectoid alloy. Growth rates which have been calculated on the assumption that volume diffusion in the parent β phase is the rate-controlling process show excellent agreement with the measured values. Directional control of eutectoid growth by translating specimens through steep temperature gradients resulted in the formation of aligned lamellar structures, and the effect of variations in imposed velocity and temperature gradient on alignment has been examined. A comparison of the kinetics of the two modes of transformation has shown that isothermal and isovelocity pearlite growth in this alloy may be readily interrelated. Analysis of the isovelocity growth data supports the conclusion that growth is controlled by volume diffusion.
Similar content being viewed by others
References
G. F. Boiling and R. H. Richman:Met. Trans., 1970, vol. 1, p. 2095.
F. M. A. Carpay:Acta Met, 1970, vol. 18, p. 747.
J. D. Livingston:J. Mater. Sci., 1970, vol. 5, p. 951.
G. V. Raynor:Annotated Equilibrium Diagram Series, no. 4, Institute of Metals, London, 1944.
D. Brown and N. Ridley:J. Iron Steel Inst, 1966, vol. 204, p. 811.
D. Cheetham and N. Ridley:Proc. Conf. on In-Situ Composites, Vol. I, National Materials Advisory Board, p. 99, NMAB 308-1,1973.
C. S. Smith and W. E. Lindlief:AIME Trans., 1933, vol. 104, p. 69.
D. J. Mack:AIME Trans., 1948, vol. 175, p. 240.
E. P. Hier and S. M. Grymko:AIME Trans., 1949, vol. 185, p. 611.
R. Haynes:J. Inst. Metals, 1954-65, vol. 83, p. 105.
G. V. T. Ranzetta and D. F. R. West:J. Inst. Metals, 1964-64, vol. 92, p. 12.
M. K. Asundi and D. F. R. West:J. Inst. Metals, 1966, vol. 94, p. 19.
D. Cheetham and N. Ridley:J. Inst. Metals, 1971, vol. 99, p. 371.
M. Hillert:Jernkont. Ann., 1957, vol. 141, p. 757.
C. Zener:AIME Trans., 1946, vol. 167, p. 550.
J. S. Kirkaldy: in “Energetics in Metallurgical Processes IV”, W. M. Mueller, ed., Gordon and Breach, Science Publishers, 1968.
M. K. Asundi and D. R. F. West:J. Inst. Metals, 1966, vol. 94, p. 327.
J. J. Kramer, G. M. Pound, and R. F. Mehl:Acta Met., 1958, vol. 6, p. 763.
B. L. Bramfitt and A. R. Marder:Int. Met. Soc. Proc, 1968, p. 43.
F. M. A. Carpay:J. Crystal Growth, 1973, vol. 18, p. 124.
J. W. Cahn and W. C. Hagel: in “Decomposition of Austenite by Diffusional Processes”, V. F. Zackay and H. I. Aaronson, eds., p. 131, Interscience Publishers, 1962.
F. M. A. Carpay:Acta Met., 1972, vol. 20, p. 929.
F. M. A. Carpay and J. van den Boomgaard:Acta Met., 1971, vol. 19, p. 1279.
G. A. Chadwick and D. V. Edmunds: in “Chemical Metallurgy of Iron and Steel”, p. 264, Iron Steel Institute, London, 1973.
D. Cheetham and N. Ridley:J. Iron Steel Inst., in press.
J. D. Livingston:Proc. Conf. on ln-Situ Composites, Vol. I, National Materials Advisory Board, NMAB-308-1,1973.
M. Hillert: in “Mechanism of Phase Transformations in Crystalline Solids”, p. 231, Institute of Metals, London, 1969.
J. M. Shapiro and J. S. Kirkaldy:Acta Met., 1968, vol. 16, p. 579.
B. E. Sundquist:Acta Met., 1968, vol. 16, p. 1413.
F. M. A. Carpay:Scripta Met., 1973, vol. 6, p. 1019.
M. S. Wechsler:Acta Met., 1957, vol. 5, p. 150.
K. Mukherjee, D. S. Lieberman, and T. A. Read:J. Appl. Phys., 1965, vol. 36, p. 857.
Author information
Authors and Affiliations
Additional information
Formerly Graduate Student, Department of Metallurgy, University of Manchester
Rights and permissions
About this article
Cite this article
Cheetham, D., Ridley, N. The kinetics of isothermal and isovelocity pearlite growth in Cu-Al eutectoid alloy. Metall Trans 4, 2549–2556 (1973). https://doi.org/10.1007/BF02644257
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF02644257