Abstract
It is shown that a low coefficient of expansion, iron-base superalloy, IN903A, suffers severe tensile embrittlement following high temperature air exposure at 1000 °C. This embrittlement involves a transition to intergranular failure at low strains, with no reduction in yield strength, and is manifested in the room temperature to 800 °C range. In parallel with earlier observations on nickel-base superalloys, ductility is regained at 1000 °C. However, in contrast to these earlier results, air exposure enhances rather than hinders grain growth in the near surface regions, and, in addition, suppresses the occurrence of the jerky flow seen in vacuum-exposed material. Oxygen is demonstrated to be the damaging species, and it is show’n that boundaries are embrittled far ahead of any matrix internal oxidation. Small additions of boron are successful in eliminating the embrittlement, as they were in nickel-base alloys. The results of stress rupture tests are then reviewed, and it is concluded that the rapid failures which occur on air testing are a consequence of embrittled grain boundaries failing in tension, rather than the stress accelerated grain boundary oxidation mechanism previously proposed.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
H. W. Carpenter,Met. Prog., 1976, vol. 110, pp. 25–29.
D. R. Muzyka, C. R. Whitney and D. K. Schlosser,J. Met., 1975, vol. 27, pp. 11–15.
MATE Report submitted to NASA, Lewis Research Center, vol. 1, pp. 128-68, General Electric Co., Aircraft Engine Group, Evendale, OH, 1977.
D. F. Smith, E. F. Chatworthy, D. G. Tipton, and W. L. Mankins, “Superalloys 1980,”Proc. 4th Int. Conf. on Superalloys, Seven Springs, Pa., pp. 521–30, ASM, Metals Park, OH, 1980.
E. Ross, General Electric Co., Evendale, OH, unpublished research, 1968.
W. H. Chang, “Superalloys-Processing,”Proc. 2nd Int. Conf. on Superalloys, Seven Springs, Pa., Section V, AIME, 1972.
J. H. Wood, General Electric Co., Schenectady, NY, unpublished research, 1973-80.
D. A. Woodford,Int. Conf. on Engineering Aspects of Creep, Univ. of Sheffield, England, 1980,1. Mech. E., London, 1981, Paper 55.
D. A. Woodford,Metall. Trans. A, 1981, vol. 12A, pp. 299–308.
D. A. Woodford and R. H. Bricknell, “Superalloys 1980,”Proc. 4th Int. Conf. on Superalloys, Seven Springs, Pa., pp. 633–41, ASM, Metals Park, OH, 1980.
R. H. Bricknell and D. A. Woodford,Metall. Trans. A, 1981, vol. 12A, pp. 425–33.
R. H. Bricknell and D. A. Woodford, General Electric Co., Schenectady, NY,Report No. 80CRD164, 1980.
T. Yoneoka, M. Yamawaki, and M. Kanno,J. Jpn. Inst. Met., 1979, vol. 43, pp. 1144–50.
L. L. Wyman,Trans. AIME, 1934, vol. 104, pp. 205–17.
D. L. Wood,J. Met., April 1957, vol. 9, pp. 406–08.
D. L. Martin and E. R. Parker,Trans. AIME, 1943, vol. 152, pp. 269–77.
J. C. Chaston,J. Inst. Met, 1945, vol. 71, pp. 23–35.
R. H. Bricknell and D. A. Woodford, General Electric Co., Schenectady, NY, 1980,Report No. 8OCRD268.
J. S. Blakemore,Metall. Trans., 1970, vol. 1, pp. 1281–85.
D. E. Sonon and G. V. Smith,Trans. TMS-AIME, 1968, vol. 242, pp. 1527–33.
D. A. Woodford and R. H. Bricknell,Metall. Trans. A, in press.
D. A. Woodford and R. H. Bricknell,Metall. Trans. A, 1981, vol. 12A, p. 1467.
R. Barlow and P. J. Grundy,J. Mater. Sci., 1969, vol. 4, pp. 797–801.
U.K. Patent Application, GB2OO9787A, 1978.
C. J. McMahon and L. F. Coffin,Metall. Trans., 1970, vol. 1, pp. 3443–50.
G. F. Paskiet, D. H. Boone and C. P. Sullivan,J. Inst. Met., 1972, vol. 100, pp. 58–62.
C. J. McMahon,Mater. Sci. Eng., 1974, vol. 13, pp. 295–97.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Bricknell, R.H., Woodford, D.A. Grain boundary embrittlement of the iron-base superalloy IN903A. Metall Trans A 12, 1673–1680 (1981). https://doi.org/10.1007/BF02643573
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF02643573