Abstract
A method has been developed to make a record of the vibration modes of a rotating circular disk, in our case a circular saw, at various rotating speeds. A picture is produced on a cathode-ray-tube display and photographed. The vibrations are measured by means of a sensor at a variable position along a radius of the saw. The signal is fed to the intensity input of the display, the oscilloscope beam being swept circularly in synchronism with the saw to derotate the pattern. Exposures are made at successively increasing sensor radius and corresponding sweep radius. The picture obtained is less detailed than a holographic picture, but the method is easy to apply, even for rotating objects with a certain skewness.
Similar content being viewed by others
References
Mote, C.C. andSzymani, R., “Principal Developments in Thin Circular Saw Vibration and Control Research,”Holtz als Roh- und Werkstoff,35,189–196 and 219–225 (1977).
Stetson, K.A., “The Use of Image Derotation in Holographic Interferometry and Speckle Photography of Rotating Objects,”Experimental Mechanics,18 (2),67–73 (Feb.1978).
MacBain, J.C., Horner, J.E., Stange, W.A. andOgg, J.S., “Vibration Analysis of a Spinning Disk Using Image-derotated Holographic Interferometry,”Experimental Mechanics,19 (1),17–22 (Jan.1979).
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Möller, E., Ringh, U. A method to observe and record vibration modes of rotating circular objects. Experimental Mechanics 22, 226–230 (1982). https://doi.org/10.1007/BF02326362
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF02326362