Abstract
A review ofin situ stress measurements at eight regional localities in Africa south of the 15°S parallel shows that average directions of the horizontal pricipal stresses are N-S and E-W. These directions agree with principal stress orientations deduced from earthquake fault plane solutions. However, the maximum and minimum principal horizontal stresses are not consistently oriented parallel to either the N-S or E-W direction; they may vary within an individual region because of local geological structures and from region to region. At the sites within the Witwatersrand sediments (all at depths greater than 500 m) the maximum stress tends to lie NW-SE but at three of the four sites outside the Witwatersrand sediments (all at depths less than 500 m) this stress is oriented approximately N-S.
The data reported here are compared with horizontal stresses predicted for Southern Africa bySolomon, Sleep andRichardson (1975) from various plate tectonic driving force models. The agreement between orientations is fair for all sites but only the deép sites in the Witwatersrand sediments have comparable stress magnitudes.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Cahnbley, H. (1970),Grundlagenuntersuchungen über das Entspannungsbohrverfahren während des praktischen Einsatzes in grosser Tiefe. Dissertation, Technical University of Clausthal, Germany.
Gay, N. C. (1975),In-situ stress measurements in Southern Africa, Tectonophysics,29, 447–459.
Green, R. W. E. andMcGarr, A. (1972),A comparison of the focal mechanism and aftershock distribution of the Ceres, South African earthquake of September 29, 1969, Bull. Seism. Soc. Amer.62, 869–871.
Jaeger, J. C. andCook, N. G. W.,Fundamentals of Rock Mechanics (Methuen, London 1969), 513 pp.
Leeman, E. R. (1968),The determination of the complete state of stress in rock in a single borehole—Laboratory and underground measurements, Int. J. Rock Mech. Mining Sci.5, 31–56.
Maasha, N. andMolnar, P. (1972),Earthquake fault parameters and tectonics in Africa, J. Geophys. Res.77, 5731–5743.
Salamon, M. D. G., Ryder, J. A., andOrtlepp, W. D. (1964),An analogue solution for determining the elastic response of strate surrounding tabular mining excavations, J. S. Afr. Inst. Min. Metall65, 115–137.
Solomon, S. C., Sleep, N. H., andRichardson, R. N. (1975),On the forces driving plate tectonics: Inferences from absolute plate velocities and intraplate stress. Geophys. J. R. astr. Soc.42, 769–801.
Van Heerden, W. L. (1974),Additional rock stress measurements at the Ruacana Power Station, S.W.A., Rep. Counc. Sci. Ind. Res. S. Afr., no. ME 1324.
Van Heerden, W. L. andOrr, C. M. (1974),Rock stress measurements at the Ruacana Power Station, S.W.A., Rep. Counc. Sci. Ind. Res. S. Afr. no. ME 1311.
Viljoen, R. P., Viljoen, M. J., Grootenboer, J. andLongshaw, T. G. (1975),ERTS — 1 imagery: applications in geology and mineral exploration, Min. Sci. Engng.7, 132–168.
Voight, B. (1966),Beziehung zwischen grossen horizontalen spannungen im Gebirge und der Tektonik und der Abstragung, Ist. Congr. Int. Soc. Rock Mech., Lisbon, 1966, Proc.2, 51–56.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Gay, N.C. Principal horizontal stresses in Southern Africa. PAGEOPH 115, 3–10 (1977). https://doi.org/10.1007/BF01637093
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF01637093