Abstract
The assembly of machine tool spindles results in a degree of variability in the effective stiffness of the bearings. This may result in a poor machining performance if the bearing stiffnesses are below their specified design values. Alternatively, the life of the bearings may be reduced if the bearings stiffnesses are above the design values because of excessive preload. This paper describes a method of checking the spindle assembly by making vibration measurements. From these measurements it is possible to determine which bearings (if any) are not at their design stiffness. This then allows appropriate adjustments to be made to ensure the assembled spindle is close to the design specifications.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
J. A. Brandon and K. J. H. Al-Shareef, “Optimisation strategies for machine tool spindle bearing systems: a critical review”, Transactions ASME, Journal of Engineering for Industry, 114, pp. 244–253, 1992.
D. Scott, “The effect of steel making, vacuum melting and casting techniques on the life of rolling bearings”, Vacuum, 19, pp. 167–168, 1969.
T. W. Morrison, T. Tallian, H. O. Walp and G. H. Baile, “The effect of material variables on the fatigue life of AISI 52100 steel ball bearings”, ASLE, 5, pp. 347–36, 1962.
F. M. Stansfield, “The stiffness of machine tool spindles”, MTIRA, Notes for Designers, 6, April 1968.
T. L. H. Walford, and B. J. Stone, “The measurement of the radial stiffness of rolling element bearings under oscillating conditions”, Journal of Mechanical Engineering Science, 22(4), pp. 175–181, 1980.
T. L. H. Walford and B. J. Stone, “Some stiffness and damping characteristics of angular contact bearings under oscillating conditions”, 2nd International Conference on Vibrations in Rotating Machinery, Cambridge, C274/80, pp. 157–162, 1980.
R. J. Lambert, A. Pollard and B. J. Stone, “Some characteristics of rolling element bearings under oscillating conditions (and their relevance to the design of spindle systems with high dynamic stiffness)”, MTIRA Report 6, December 1981.
B. J. Stone, “The state of the art in the measurement of the stiffness and damping of rolling element bearings”, Keynote Paper, CIRP, 31(2), pp. 529–538, 1982.
T. L. H. Walford and B. J. Stone, “The sources of damping in rolling element bearings under oscillating conditions”, Proceedings Institution of Mechanical Engineers, 197C, pp. 225–232, 1983.
P. R. Drake, A. D. Jennings and R. I. Grosvenor, “A data acquisition system for machine tool condition monitoring. Part 2. Some of the signals acquired”, Quality and Reliability Engineering International, 12, pp. 19–26, 1996.
B. J. Stone, “A CAE package for the design of spindle systems”, UPCAEDEM Conference, Ann Arbor, Michigan, pp. 196–201, August 1990.