Abstract
Fault rocks formed in phyllosilicate-bearing rocks formed over a wide range of environmental conditions within the Earth's crust are characterised by similar structural and microstructural features. The most striking of these are (a) P foliation, defined by the preferred alignment of phyllosilicates in a plane oblique to the direction of shear and (b) small-scale shear zones either parallel to the shear direction (Y shears) or oblique to the direction of shear but with the opposite sense of obliquity relative to the P foliation (Riedel shears, R1). The minor shear zones have the same sense of displacement as the host shear zone.
The occurrence of these and other structures in clay-rich fault gouges from exceptionally well-exposed fault zones in southeastern Spain is described. The pervasive development of these flow structures throughout large volumes of fault gouge permits fault-displacement vectors to be inferred. For the region studied the movement pictures is relatively simple and is superposed on a complex network of variably oriented fault zones.
The naturally produced fault-gouge structures are compared with fault gouges produced experimentally by shearing kaolinite-quartz mixtures between intact blocks over a wide range of experimental conditions. Good correspondence between their respective microstructural features was observed.
Finally, attention is drawn to the fact that natural clay-bearing fault gouges are the products of deformation accompanied by very low-grade retrogressive metamorphism, and that part of the micro-structure of these rocks may be ascribed to crystallization under stress. Microstructures are described that are from long-duration experimental runs, (5 months at high temperature and in the presence of water) which go some way towards simulating these effects.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Anderson, J. L., Osborne, R. H. andPalmer, D. F. (1983),Cataclastic rocks of the San Gabriel fault — An expression of deformation at deeper crustal levels in the San Andreas fault zone. Tectonophys.98, 209–251.
Angevine, C. L. Turcotte, D. L. andFurnish, M. P. (1982),Pressure solution lithification as a mechanism for the stick-slip behaviour of faults. Tectonics1, 151–160.
Armijo, R., Benkhelil, J., Bousquet, J. C., Estevez, A., Guiraud, R., Montenat, C., Pavillon, M. J., Philip, H., Sanz de Galdeano, C. andViguier, C. (1977),L'histoire tectonique recent (Tortonien à Quaternaire) de l'Arc de Gibraltar et des bordures de la mer d'Alboran. Bull. Geol. Soc. France19, (3) 575–614.
Berthe, D., Choukroune, P. andJegouzo, P. (1979),Orthogneiss, mylonite and non-coaxial deformation of granites: the example of the south Armorican shear zone. J. Struct. Geol.,1, 31–42.
Byerlee, J. O. andSummers, R. (1976),A note on the effect of fault gouge thickness on fault stability. Int. J. Rock Mech. Min. Sci.13, 35–36.
Byerlee, J. D., Mjachkin, V., Summers, R. andVoevoda, O. (1978),Structures developed in fault gouge during stable sliding and stick-slip. Tectonophys.44, 161–171.
Chester, F. M., Friedman, M. andLogan, J. M. (1985),Foliated cataclasites. Tectonophys.111, 139–146.
Elliot, D. (1976),The energy balance and deformation mechanisms of thrust sheets. Phil. Trans. R. Soc.283A, 289–312.
Engelder, T. (1974),Catalasis and the generation of fault gouge. Geol. Soc. Amer. Bull.85, 1515–1522.
Engelder, T. (1977), ‘Aspects of asperity-surface interaction during frictional sliding,” inProceedings of Conference II, Experimental studies of rock friction with application to earthquake prediction. U.S. Geol. Sury. 117–137.
Gamond, J. F. (1983),Displacement features associated with fault zones: A comparison between observed examples and experimental models. J. Struct. Geol.5, 33–45.
Hall, S. H. (1983),Post Alpine tectonic evolution of S.E. Spain and the structure of fault gouge. Ph.D Dissertation, Univ. London.
Hall, S. H. andRutter, E. H. (1986),Late orogenic faulting in S.E. Spain, to be submitted to J. Geol. Soc. London.
Hamilton, G. M., andGoodman, L. E. (1966),The stress field created by a circular sliding contact. J. Appl. Mech.33, 371–376.
House, W. M. andGray, D. R. (1982),Cataclasites along the Saltville thrust, U.S.A., and their implications for thrust sheet emplacement. J. Struct. Geol.4, 257–269.
Liechti, R. andZoback, M. D. (1979), ‘Preliminary analysis of clay gouge from a well in the San Andreas fault zone in central California,’ inProc. Conf. VIII: Analysis of actual fault zones in bedrock. U.S. Geol. Survey Open File Rep., 79-1239, 268–275.
Logan, J. M., Friedman, M., Higgs, N. G., Dengo, C. andShimamoto, T. (1979), ‘Experimental studies of simulated gouge and their application to studies of natural fault zones,’ inProc. Conf. VIII, Analysis of actual fault zones in bedrock. U.S. Geol. Survey Open File Rep. 79-1239, 305–343.
Logan, J. M., Higgs, N. G. andFriedman, M. (1981),Laboratory studies on natural gouge from the U.S. Geological Survey Dry Lake Valley No. 1 well, San Andreas fault zone. Geophys. Monogr. 24, Amer. Geophys. Union 121–134.
Moore, D. E., Summers, R. andByerlee, J. D. (1983),Strengths of clay and non-clay fault gouges at elevated temperatures and pressures. Proc. 24th U.S. Symp. Rock Mech. 489–499.
Moore, D. E. andByerlee, J. D. (1985),Deformation textures developed in heated fault gouge. EOS, Trans. Am. Geoph. Union.66, p. 1100.
Morgenstern, N. R. andTchalenko, J. S. (1967),Microscopic structures in kaolin subjected to direct shear. Geotechn.17, 309–328.
Morrow, C., Shi, L. Q. andByerlee, J. D. (1981),Permeability and strength of San Andreas fault gouge under high pressure. Geophys. Res. Lett.8, 325–328.
Platt, J. P. andVissers, R. L. M. (1980),Extensional structures in anisotropic rocks. J. Struct. Geol.2, 397–410.
Rutter, E. H. (1979),The mechanical properties of kaolinite fault ‘gouge’ at moderate confining pressure, 20°C. Int. J. Rock Mech. Min. Sci.16, 407–410.
Rutter, E. H. andWhite, S. H. (1979),The effects of water, temperature and time on the microstructural and mechanical properties of experimentally produced fault gouge. Bull. Mineral.102, 93–101.
Sanz de Galdeano, C. (1983),Los accidentes y fracturas principales de las Cordilleras Beticas. Estudios Geol.39, 157–165.
Simpson, C. andSchmid, S. (1983),An evaluation of criteria to deduce the sense of movement in sheared rocks. Geol. Soc. Am. Bull.94, 1281–1288.
Smith, D. L. andEvans, B. (1984),Diffusional crack healing in quartz. J. Geophys. Res.89, 4125–4135.
Stel, H. (1981),Crystal growth in cataclasites: diagnostic microstructures and implications. Tectonophys.78, 585–600.
Summers, R. andByerlee, J. (1977),A note on the effect of fault gouge composition on the stability of frictional sliding. Int. J. Rock Mech. Min. Sci.14, 155–160.
Tchalenko, J. S. (1970),Similarities between shear zones of different magnitudes. Geol. Soc. Am. Bull.81, 1625–1640.
Udias, A., Lopez Arroyo, A. andMezcua, J. (1976),Seismotectonic of the Azores-Alboran region. Tectonophys.31, 259–289.
Wang, C., Mao, N. andWu, F. T. (1980),Mechanical properties of clays at high pressure. J. Geophys. Res.85, 1462–1468.
White, S. H., Burrows, S. E., Carreras, J., Shaw, N. D. andHumphreys, F. J. (1980),On mylonites in ductile shear zones. J. Struct. Geol.2, 175–188.
Wu, F. T. (1978),Mineralogy and physical nature of clay gouge. Pure Appl. Geophys.116, 685–689.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Rutter, E.H., Maddock, R.H., Hall, S.H. et al. Comparative microstructures of natural and experimentally produced clay-bearing fault gouges. PAGEOPH 124, 3–30 (1986). https://doi.org/10.1007/BF00875717
Received:
Revised:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF00875717