Skip to main content
Log in

Residual value of superphosphate for oat and barley grown on a very sandy, phosphorus leaching soil

  • Published:
Fertilizer research Aims and scope Submit manuscript

Abstract

In a field experiment in a Mediterranean climate (474 mm annual rainfall, 325 mm (69%) falling in the May to October growing season) on a deep sandy soil near Kojaneerup, south-western Australia, the residual value of superphosphate was measured relative to freshly-applied superphosphate. The grain yield of five successive crops (1988–1992) was used to measure the residual value: barley (Hordeum vulgare), barley, oat (Avena sativa), lupin (Lupinus angustifolius), and barley. There was no significant yield response to superphosphate applied to the first crop (barley, cv. Moondyne). There were no results for the second crop (barley) due to weeds or the fourth crop (lupin) due to severe wind erosion which damaged the crop. The residual value of superphosphate was measured using grain yields of the third crop (oat, cv. Mortlock) for superphosphate applied one and two years previously, and the fifth crop (barley, cv. Onslow) for superphosphate applied one, two, three and four years previously. In February 1992, before sowing the fifth crop, soil samples were collected to measure bicarbonate-extractable phosphorus (P) (soil test P) which was related to the subsequent grain yields of that crop. This relationship is the soil test P calibration used to estimate the current P status of soils when providing P fertilizer recommendations.

The residual value of superphosphate declined markedly. For the third crop (oat), it was 6% as effective as freshly-applied superphosphate one year after application, and 2% as effective two years after application. For the fifth crop (barley), relative to freshly-applied superphosphate, the residual value of superphosphate in successive years after application was 46%, 6%, 3% and 2% as effective. The soil has a very low capacity to sorb P, and P was found to leach down the soil profile. The largest yield for P applied one and two years previously in 1990, and two, three and four years previously in 1992, was 35 to 50% lower than the maximum yield for freshly-applied P.

Soil test P was very variable (coefficient of variation was 32%) and mostly less than 8µg P/g soil. The calibration relating yield (y axis) to soil test P (x axis) differed for soil treated with superphosphate one year previously compared with soil treated two, three and four years previously. The top 10 cm of soil was used for soil P testing, the standard depth. P was leached below this depth but some of the P leached below 10 cm may still have been taken up by plant roots. Consequently soil test P underestimated the P available to plants in the soil profile. The soil test P calibration therefore provided a very crude estimate of the current P status of the soil.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

References

  • Allen DG and Jeffery RC (1990) Total phosphorus. In: Methods for Analysis of Phosphorus in Western Australian Soils. Section 4.1, pp 6–8. Report of Investigation No. 37, Chemistry Centre of Western Australia

  • AOAC (1975) Official Methods of Analysis, 12th edn. Assoc Of Agric Chem, Washington DC

    Google Scholar 

  • Barrow NJ (1980) Evaluation and utilization of residual phosphorus in soils. In: Khasawneh FE, Sample EC and Kamprath EJ (eds) The Role of Phosphorus in Agriculture, Ch 13, pp 339–359. Am Soc Agron, Madison, Wisconsin, USA

    Google Scholar 

  • Barrow NJ and Campbell NA (1972) Methods of measuring residual value of fertilizers. Aust J Exp Agric Anim Husb 12: 502–510

    Google Scholar 

  • Bettaney E and Poutsma T (1962) Soils of the North Manypeaks Area, Western Australia. CSIRO Division of Soils Divisional Report 1562

  • Bolland MDA (1992a) The current and residual value of superphosphate for lupins grown in rotation with oat and wheat on a deep sandy soil. Fert Res 31: 319–329

    Google Scholar 

  • Bolland MDA (1992b) Residual value of superphosphate for wheat and lupin grain production on a uniform yellow sandplain soil. Fert Res 31: 331–340

    Google Scholar 

  • Bolland MDA, Allen DG and Gilkes RJ (1989) The influence of seasonal conditions, plant species and fertilizer type on the prediction of plant yield using the Colwell bicarbonate soil test for phosphate. Fert Res 19:143–158

    Google Scholar 

  • Bolland MDA and Barrow NJ (1991) The effect of level of application on the residual value of superphosphate on a sandy soil in south-western Australia. Fert Res 29:163–172

    Google Scholar 

  • Bolland MDA, Baker MJ and Lunt RJ (1987a) Effectiveness of superphosphate and crandallite-millisite rock phosphates on a deep, very sandy soil as assessed by plant growth and soil extractable phosphate. Aust J Exp Agric 27: 647–656

    Google Scholar 

  • Bolland MDA and Gilkes RJ (1990) Rock phosphates are not effective fertilizers in Western Australian soils: a review of one hundred years of research. Fert Res 22: 79–95

    Google Scholar 

  • Bolland MDA, Gilkes RJ and Allen DG (1988) The residual value of superphosphate and rock phosphate for lateritic soils and its evaluation using three soil phosphate tests. Fert Res 15: 253–280

    Google Scholar 

  • Bolland MDA, Gilkes RJ, Allen DG and D' Antuono MF (1987b) Residual value of superphosphate and Queensland rock phosphate for serradella and clover on very sandy soils as assessed by plant growth and bicarbonate-soluble phosphorus. Aust J Exp Agric 27: 275–282

    Google Scholar 

  • Colwell JD (1963) The estimation of the phosphorus fertilizer requirements of wheat in southern New South Wales by soil analysis. Aust J Exp Agric Anim Husb 3:190–197

    Google Scholar 

  • Colwell JD (1983) Fertilizer requirements In: CSIRO Div Soils, Adelaide (ed) Soils: An Australian Viewpoint, Ch 50, pp 795–815. CSIRO, Melbourne/Academic Press

  • Colwell JD (1985) Fertilizing programs. 1. Variability in responses of successive crops to fresh and previous applications of phosphorus fertilizer in Australia and Brazil. Fert Res 8: 21–38

    Google Scholar 

  • Cornish PS (1987) Effects of direct drilling on the phosphorus uptake and fertilizer requirements of wheat. Aust J Agric Res 38: 775–790

    Google Scholar 

  • Dahnke WC and Olson RA (1991) Soil test correlation, calibration and recommendation. In: Westerman RL (ed) Soil Testing and Plant Analysis, 3rd ed, Ch 4, pp 45–71. Soil Sci Soc Am Book Series No 3. Soil Sci Soc Am, Madison, Wisconsin, USA

    Google Scholar 

  • Eckert DJ and Johnson JW (1985) Phosphorus fertilization in notillage corn production. Agron J 77: 789–792

    Google Scholar 

  • Fixen PE and Grove JH (1991) Testing soils for phosphorus In: Westerman RL (ed) Soil Testing and Plant Analysis, 3rd ed, Ch 7, pp 141–180. Soil Sci Soc Am Book Series No 3, Soil Sci Soc Am, Madison, Wisconsin, USA

    Google Scholar 

  • Holford ICR (1989) Efficacy of different phosphate application methods in relation to the phosphate sorptivity of soils. Aust J Soil Res 27:123–133

    Google Scholar 

  • Hughes JC and Gilkes RJ (1984) The effect of chemical extraction on the estimation of rock phosphate fertilizer dissolution. Aust J Soil Res 22: 475–481

    Google Scholar 

  • Menon RG, Chien SH and Hammond LL (1990) Development and evaluation of the P i soil test for plant-available phosphorus. Commun Soil Sci Plant Anal 21:1131–1150

    Google Scholar 

  • Menon RG, Chien SH and Abd el Nabi Gadalla (1991) Comparison of Olsen and P i soil tests for evaluating phosphorus bioavailability in a calcareous soil treated with single superphosphate and partially acidulated phosphate rock. Fert Res 29:153–158

    Google Scholar 

  • Murphy J and Riley JP (1962) A modified single solution method for determination of phosphate in natural waters. Anal Chim Acta 27: 31–36

    Google Scholar 

  • Northcote KH (1979) A Factual Key for the Recognition of Australian Soils, 4th edn. Rellim Tech Public, Glenside, South Australia

    Google Scholar 

  • Olsen SR, Cole CV, Watanabe FS and Dean LA (1954) Estimation of available phosphorus in soils by extraction with sodium bicarbonate. US Dept Agric Circ No 939

  • Ozanne PG, Kirton DJ and Shaw TC (1961) The loss of phosphorus from sandy soils. Aust J Agric Res 12: 409–423

    Google Scholar 

  • Ozanne PG and Shaw TC (1967) Phosphate sorption by soils as a measure of the phosphate requirement for pasture growth. Aust J Agric Res 18: 601–612

    Google Scholar 

  • Rowland IC, Mason MG and Hamblin J (1988) Effect of lupins and wheat on the yield of subsequent wheat crops grown at several rates of applied nitrogen. Aust J Exp Agric 28: 91–97

    Google Scholar 

  • Stace HCT, Hubble GD, Brewer R, Northcote KH, Sleeman JR, Mulcahy MJ and Holsworth EG (1968) A Handbook of Australian Soils. Rellim Tech Public Glenside, South Australia

    Google Scholar 

  • Yeates JS, Deeley DM, Clarke MF and Allen DG (1984) Modifying fertilizer practices. J Agric West Aust 25(4th series): 87–91

    Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Rights and permissions

Reprints and permissions

About this article

Cite this article

Bolland, M.D.A. Residual value of superphosphate for oat and barley grown on a very sandy, phosphorus leaching soil. Fertilizer Research 38, 171–181 (1994). https://doi.org/10.1007/BF00749689

Download citation

  • Received:

  • Accepted:

  • Issue Date:

  • DOI: https://doi.org/10.1007/BF00749689

Key words

Navigation