Abstract
The aim of this paper is to determine precisely under which conditions an inclined plane can be used as a rheometer, which could represent a practical and rapid technique for various types of industrial or natural viscoplastic coarse suspensions. We first examine its efficiency and relevancy for determining fluid yield stress in a straight way by measuring the deepest fluid layer able to stay on the inclined plane. We have made experiments with different materials (clay-water suspensions) whose yield stress ranged from 35 to 90 Pa, using 1 m long open rectangular channels with a slope ranging from 10 to 30° and a width ranging from 5 to 25 cm. Our procedure involved measuring the final fluid depth far from edges a long time after the end of the slow gravity-induced emptying of a dam placed upstream. The fluid yield stress was also estimated independently by fitting a Herschel-Bulkley model to simple shear rheometry data obtained within a relatively wide shear rate range. A good agreement between inclined rectangular channel tests and independent usual rheometrical tests is obtained even for aspect ratios (flow depth to channel width ratio) as large as 1 when one assumes that, when the fluid has stopped, the side and bottom wall shear stresses are equal to the fluid yield stress. These results prove the efficiency of the inclined plane test for determining yield stress when appropriate experimental precautions are taken for both tests. In addition we examine the possibility of determining the simple shear flow curve of a mud suspension from fluid depth, velocity and discharge measurements of different steady flows in a wide open channel (8 m long; 60 cm wide) equipped with a recirculating system. The results obtained from inclined plane tests are in good agreement with independent rheometrical data (with torsional geometries). However it is technically difficult to cover a wide shear rate range from the inclined plane technique since this requires a rather wide channel flow rate range.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Astarita G (1990) “Letter to the editor: The engineering yield stress”. J Rheol 34:275–277
Astarita G, Marrucci, Palumbo G (1964) Non-Newtonian gravity flow along inclined plane surfaces. Ind Eng Chem Fund 3:333–339
Barnes HA, Walters K (1985) The yield stress myth? Rheol Acta 24:323–326
Bird RB, Dai GC, Yarusso BJ (1982) The rheology and flow of viscoplastic materials. Rev Chem Eng 1:1–70
Chow VT (1959) Open-channel hydraulics. McGraw-Hill, Civil Engineering Series New York
Coleman BD, Markovitz H, Noll W (1966) Viscometric flows of non-Newtonian fluids. Springer Verlag, Berlin, p 130
Coussot P, Piau JM (1995) A large-scale field coaxial cylinder rheometer for the study of the theology of natural coarse suspensions. J Rheol 39:105–124
Coussot P (1994) Steady, laminar, flow of concentrated mud suspensions in open channel. J Hydr Res 32:535–559
Coussot P, Piau JM (1994) (b) Simple shear rheometry of concentrated dispersions and suspensions. Les Cahiers de Rhéo-logie, Groupe Français de Rhéologie XII:1–13 (in french)
Coussot P, Piau JM (1994) (a) On the behaviour of fine mud suspensions. Rheol Acta 33:175–184
Coussot P, Leonov AI, Piau JM (1993) Rheology of concentrated dispersed systems in a low molecular weight matrix. J Non-Newt Fluid Mech 46:179–217
De Kee D, Chan Man Fong CF (1993) “Letter to the editor: A true yield stress?”. J Rheol 37:775–776
De Kee D, Chhabra RP, Powley MB, Roy S (1990) Flow of viscoplastic fluids on an inclined plane: Evaluation of yield stress. Chem Eng Comm 96:229–239
Evans ID (1992) “Letter to the editor: On the nature of the yield stress”. J Rheol 36:1313–1316
Fink JH, Zimbelman JR (1986) Rheology of the Royal Gardens basalt flows Kilauea Volcano, Hawaii. Bull Volcanology 48, 87–96
Hartnett JP, Hu RYZ (1989) The yield stress — An engineering reality. J Rheol 33:671–679
Howard CDD (1963) Flow of clay-water suspensions. J Hydr Div. Proc ASCE, HY 5:89–97
Hulme G (1974) The interpretation of lava flow morphology. Geophys J Roy Astrophys Soc 39:361–383
Hunter RJ (1982) The flow behavior of coagulated colloidal suspensions. Adv Colloid Interface Sci 17:197–211
Hutton JF (1975) On using the Weissenberg Rheogoniometer to measure normal stresses in lubricating greases as examples of materials which have a yield stress. Rheol Acta 14:979–992
Johnson AM (1970) Physical processes in Geology. Freeman Cooper and Co, San Francisco, p 577
Keentok M (1982) The measurement of the yield stress of liquids. Rheol Acta 21:325–332
Liu KF, Mei CC (1989) Slow spreading of a sheet of Bingham fluid on an inclined plane. J Fluid Mech 207:505–529
Liu KF, Mei CC (1994) Roll waves on a layer of a muddy fluid flowing down a gentle slope — A Bingham model. Phys Fluids 6:2577–2590
M'Ewen MB, Pratt MI (1957) The gelation of montmorillonite. Part I: The formation of a structural framework in sols of Wyoming bentonite. Trans Faraday Soc 53:535–547
Magnin A, Piau JM (1987) Shear rheometry of fluids with a yield stress. J Non-Newt Fluid Mech 23:91–106
Magnin A, Piau JM (1990) Cone-and-plate rheometry of yield stress fluids — Study of an aqueous gel. J Non-Newt Fluid Mech 36:85–108
Major JJ, Pierson TC (1992) Debris flow rheology: experimental analysis of finegrained slurries. Water Resour Res 28:841–857
Nguyen QD, Boger DV (1983) Yield stress measurement for concentrated suspensions. J Rheol 27:321–349
Nguyen QD, Boger DV (1992) Measuring the flow properties of yield stress fluids. Ann Rev Fluid Mech 24:47–88
Paslay PR, Slibar A (1958) Flow of an incompressible viscoplastic layer on an inclined plane. Trans Soc Rheol II, pp 255–262
Phillips CJ, Davies TRH (1991) Determining rheological parameters of debris flow material. Geomorphology 4:101–110
Pierson TC (1980) Erosion and deposition by debris flows at Mt Thomas, North Canterbury, New Zealand. Earth Surf Proces 5:227–247
Pierson TC (1986) Flow behavior of channelized debris flows. Mount St Helens, Washington. In: Abrahams AD (ed) Hillslope Processes. Allen & Unwin, Boston, pp 269–296
Schurz J (1992) “Letter to the editor: A yield value in a true solution”. J Rheol 36:1319–1321
Spaans RD, Williams MC (1995) “Letter to the editor: At last, a true liquid-phase yield stress”. J Rheol 39:241–246
Uhlherr PHT, Park KH, Tiu C, Andrews JRG (1984) Yield stress fluid behaviour on an inclined plane. In: Mena B, Garcia-Rejon A, Rangel-Nagaile C (eds) Advances in Rheology. Mexico City 2:183–190
Wadge G, Lopes RMC (1991) The lobes of lava flows on Earth and Olympus Mons, Mars. Bull Volcanology 54:10–24
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Coussot, P., Boyer, S. Determination of yield stress fluid behaviour from inclined plane test. Rheola Acta 34, 534–543 (1995). https://doi.org/10.1007/BF00712314
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF00712314