Models for estimating capillary rise in a heavy clay soil with a saline shallow water table

Summary

Shallow saline water tables underlie large areas of the clay soils in the Murray basin of Australia. Accurate estimation of capillary rise is important in formulating management strategies to avoid degradation of such soils. Measured capillary rise from a saline water table was compared with capillary rise estimated by three mathematical models of varying complexity and input requirement. A quasi steady state analytical model (QS-SAM), a transient state analytical model (TSAM) and a numerical model (NM) were used. An undisturbed heavy clay soil core of 0.75 m diameter and 1.4m deep was subjected to a static saline water table at 1.2 m from the surface. A wheat crop was grown on the core and the weekly capillary rise from the water table was measured. The electrical conductivity of a 1:2 soil: water extract was determined at 0.15 m depth intervals before and 21 weeks after the introduction of the saline water table. The QSSAM did not satisfactorily estimate the initial wetting of the subsoil and the estimated capillary rise was considerably lower than the measured values. Capillary rise estimated by the TSAM was reasonably close to the measured values, but the weekly rates fluctuated considerably. The NM estimated capillary rise quite satisfactorily throughout the experiment. Except near the soil surface, the electrical conductivity values estimated by the NM were close to the measured values. For estimating total capillary rise over large areas, the TSAM is preferred over the NM because of its fewer input requirements and shorter execution time.