Distribution of estrogenic steroids in municipal wastewater treatment plants in Tehran, Iran

Background Estrogenic steroids such as estrone (E1), 17β–estradiol (E2), estriol (E3), and 17α–ethinylestradiol (EE2) are among the most potent endocrine disrupting compounds (EDCs). Compared with North America, Europe and Japan there is no reliable information on the concentration of steroid hormones in wastewater treatment plants (WWTPs) influents and effluents in Iran. The aim of the present study was to determine the amounts of E1, E2, E3, and EE2 influents and effluents of 7 municipal WWTPs across Tehran, the capital city of Iran, in two seasons, summer and autumn, through solid-phase extraction (SPE) gas chromatography–mass spectrometry (GC–MS). Results The results showed that the concentrations of E1, E2, and EE2 in influents ranged from 6.54–18.76 ng/L, 1.02–8 ng/L and 4.18–11.76 ng/L, respectively. Also, the concentrations of E1, E2, and EE2 in effluents ranged from 1.04–4.99 ng/L, 0.5–2.20 ng/L and 0.5–2.58 ng/L, respectively. The levels of E3 were below the detection limit (0.5 ng/L). The percentage removal rate of E1, E2 and EE2 ranged between 61.76–87.25%, 50.98–82.63%, and 66.3–90.25%, respectively. Results indicated no significant correlation between hormone concentrations and seasons. Conclusions The study showed that WWTP number 7 had significant differences in influent hormone concentrations compared with others. Results only showed a significant relationship between hormones and TSS removal rate, but there was no significant relationship between hormones and COD removal rate. The removal rate of hormone in WWTP number 4 and 7 were significantly different from the others. There was no significant correlation between hormone concentrations and seasons.


Introduction
Endocrine disrupting compounds (EDCs) include several types of natural and synthetic chemicals that mimic or prevent the endocrine system in animals and human beings and disrupt the function of these glands [1]. EDCs mainly include synthetic and natural hormones and their metabolites, some personal care products and pharmaceuticals, several non-steroidal drugs, synthetic compounds that are used as flame retardants, plasticisers, and pesticides [2]. Among the different classes of endocrine disrupters, natural and synthetic estrogens, such as estrone (E1), 17 beta-estradiol (E2), estriol (E3), and 17α-ethinyl estradiol (EE2) have much stronger estrogenic effects than other EDCs [3].
The environmental concentrations of estrogens are very low; however, the presence of estrogenic compounds in the environment has become a concern, because they may interfere with the reproduction of human beings, livestock and wildlife. Concentrations below 0.1 ng/L of one estrogen are sufficient to cause significant estrogenic effects [4]. Estrogens have a stimulating effect on breast tumour growth [5] and about 95% of breast cancers are known to be hormone dependent [6]. They also cause endometrial cancer and ovarian and other hormone cancers [7].
Due to the health effects of estrogenic compounds, since municipal wastewater is the main disposal pathway for the human waste born estrogenic compounds and because of the lack of reliable information about this component at the time of this study in Iran, the present study was performed on the determination the amounts of E1, E2, E3, and EE2 in the raw sewage influent and final treated effluent of 7 municipal wastewater treatment plants across Tehran by solid-phase extraction (SPE) gas chromatography-mass spectrometry (GC-MS).

Descriptions of the wastewater treatment plants (WWTPs)
Information about the operation conditions and conventional wastewater parameters of each WWTP are summarised in Table 1. Three types of secondary plants are used in these WWTPs: suspended growth-activated sludge with extend aeration, trickling filter followed by an activated sludge tank and an anaerobic/anoxic/oxic activated sludge process (A 2 O)which removes biological phosphorus with simultaneous nitrificationdenitrification. Conventional wastewater parameters such as 5-day biochemical oxygen demand (BOD 5 ), total chemical oxygen demand (COD), total organic carbon (TOC) and total suspended solids (TSS) were analysed according to the standard methods.

Sampling and preparation of samples
Grab samples were manually collected over 6 days (22, 25 and 28 July and 22, 25 and 28 October) from the raw sewage influent and final treated effluent of 7 municipal wastewater treatment plants in Tehran by using brown glass bottles with Teflon stoppers. The samples were transferred to laboratory by a cool box at 4°C. The sewage samples (1 L) were filtered through GF/F filters (0.7 and 0.2 μm) then spiked with etiocholanolone as an internal standard. Samples extraction was performed by using a solid phase extraction system according to the established procedures presented by Zhang et al. [14].
The SPE C18 cartridges (1000 mg/12 mL-Teknokroma) were conditioned with 12 mL of methanol which was passed through the cartridges under a very low vacuum to ensure that the sorbents were soaked in methanol for 15 min to remove residual bonding agents. Then, ultrapure water was passed through the cartridges at a rate of 1-2 mL/min. Water samples were extracted at a flow rate less than 5 mL/min. The cartridges were dried under vacuum for 30 min and then the analytes were eluted into vials (20 mL) from the sorbents with 12 mL of methanol at a flow rate of 1 mL/min. The solvents were blown down to 1 mL under a gentle flow of nitrogen at less than 50°C. The extracts from SPE were transferred into 1.5 mL reaction vials. The extracts were further evaporated to dryness under a gentle nitrogen stream. The dry residues were derivatised by the addition of 80 μL of BSTFA and 20 μL of pyridine. After a reaction time of 30 min at 60-70°C, 10 μL of final extract was injected into GC/MS apparatus.

GC-MS analysis
The instrument used for GC-MS analysis was a 3800 Varian gas chromatography coupled to a Varian Saturn 2200 mass spectrometer, equipped with an HP-5 capillary column (30 m, 0.25 mm i.d., 0.25 μm film thickness). The instrumental temperatures were as follows: injector temperature 280°C; transfer line 300°C; initial oven temperature 80°C (held for 0.5 min), increased to 250°C at a rate of 20°C min −1 to 300°C at a rate of 5°C min −1 and hold at 300°C for 4 min. The inlet was operated in split on mode. The temperature of the transfer line was maintained at 290°C. Helium (99.999%) was used as a carrier gas at 1 mL min −1 (constant flow). The source and quadrupole temperatures were kept at 230 and 150ºC, respectively. The electronic beam energy of the mass spectrometer was set at 70 eV. The mass selective detector was operated in electron impact (EI) mode using selected ion monitoring (SIM). The dwell time of each ion was set at 100 ms. The GC conditions were selected to minimise the time of analysis while allowing all of the analytes to elute in acquisition groups containing a suitable number of ions for monitoring.
The detection limit for E1, E2, E3, and EE2 was 0.5 ng/L. All of the laboratory analyses on hormones were carried out in the Central and Chemistry Lab at the School of Public Health, Tehran University of Medical Sciences. Statistical analysis of the obtained results was performed according to linear regression, chisquare, Kruskal-Wallis, Tukey HSD and one-way ANOVA analysis.

Results and discussion
In current research the amounts of E1, E2, E3, and EE2 in the raw sewage influent and final treated effluent of municipal wastewater treatment plants were determined. Table 2 illustrates the descriptive statistics summary of steroid hormones.
In this study, hormone concentrations results were analysed by ANOVA test. Results showed that hormone concentrations in influents of these WWTPs significantly varied from case to case (p = 2.24 × 10 −5 ). Figure 1 illustrates hormone concentrations versus types of hormone.
The concentration of different hormones, in different WWTPs, was analysed by Tukey HSD test (Table 3).
According to Table 3 only WWTP number 7 showed a significant difference in influent hormone concentrations compared with others (P value < 0.001). WWTP number 7 serves a community with a population of 2,100,000. Its influent flow treatment rate is about15000 m 3 /h and it treats much more wastewater than the other WWTPs.
The higher steroid estrogen concentrations in the WWTP influent and effluent may be due to the differences in treatment plant catchment characteristics, including commerce-industry-domestic sewerage mix, treatment technology used, higher population density, higher birth rate, less dilution, different sampling times and other socioeconomic factors [17,26]. In this research, the percentage removal rate of E1, E2, and EE2 ranged between 61.76-87.25%, 50.98-82.63%, and 66.3-90.25%, respectively, with mean concentrations of 71.82 ± 5.41 ng/L, 68.18 ± 6.78 ng/L, and 80.43 ± 4.49 ng/L, respectively. In various WWTP, the removal rates for estrogens were reported to be 23-83% for E1, 59-100% for E2, 80-99% for E3 and 71-78% for EE2 [27]. It is almost similar to present study.
It is necessary to note that the concentration and removal percentage of estrogenic steroid obtained in different studies are not easily comparable; because the conditions of wastewater treatment plants are different and/or sometimes not clearly described. In addition, sampling strategies and analytical methods from one study to another are different [17].
The relationship between COD and TSS removal rate with hormone removal rate was examined by linear regression. Results showed only a significant relationship between hormone removal rates and TSS removal rates (R-Squared = 0.99; p = 2.2 × 10 −16 ). There was no significant relationship between hormone removal rate and COD removal rate (p = 0.585).
The relationship between hormone removal percentage and type of WWTP were examined by ANOVA test. The results showed that the relationship between some of them is significantly different (p = 0.001). The percentage removal rate of hormones in different WWTPs was analysed by Tukey HSD test. Table 4, shows the results of the Tukey HSD test. As shown in Table 4, the hormone removal rate in WWTP number 4 is significantly different from WWTP number 1 and 3. The hormone removal rate of WWTP number 7 was also significantly different from WWTP number 3 compared with other WWTPs.
As mentioned before, this study showed a significant relationship between hormone removal rates and TSS removal rates. WWTP number 4 and WWTP number 7 had the highest removal rate for TSS compared with the others (98.81 and 96.54%, respectively). Therefore, significant differences in the hormone removal rate in WWTP number 4 and WWTP number 7 may be due to their high rate of TSS removal rate. It should be mentioned that the wastewater treatment process in WWTP number 7 was trickling filter followed by activated sludge which has a long sludge retention time.
Johnson and Sumpter [17] reported sorption on an organic-rich solid phase and biodegradation are major mechanisms of estrogenic steroids removing in biological treatment.
As Auriol et al. [27] reported, the long sludge retention time has a positive effect on activated sludge system for removing estrogens.
Secondary treatment with activated sludge with longer sludge and hydraulic retention times has a very good estrogenic steroid removing rate, up to 90% [28].
The relationship between types of hormones and their removal rate were examined by Kruskal-Wallis test. The results showed a significant correlation between types of hormones and their removal rate (p < 0.05). Figure 2 shows the removal percentage of hormones versus the type of hormone.
In review on steroid estrogens, researches reported that removal rate of E1, E2, E3 and EE2 in conventional WWTPs were not equal. Because type of hormone can affected on removal percentage of hormone [13,21,27,29]. These results are in accordance with this study results.
Seasonal and temperature changes may affect the removal of estrogens from wastewater treatment plants. Usually, an increase in temperature leads to increase wastewater treatment efficiency as the metabolic rate of microorganisms in the various biological treatment plants increase. During winter, higher effluent concentrations for both natural and synthetic estrogens have been observed [30].
Shareef et al. [31] reported the concentration of E1 and E2 to be higher in winter compared with summer. They claim that it may be due to the dilution and transformation of some of these compounds during their transfer to WWTPs in the warm season [31]. The seasonal influent concentration of steroid estrogens E2, E3, and EE2 was reported by Zhou et al. [26] in the order of spring > autumn > summer > winter. However, Jin et al. [25] found a different result in a municipal sewage treatment plant in Wuhan, China, which indicated a lower influent concentration of E3 in summer than in winter. In this study, ANOVA test was used to examine the relationship between the two seasons (summer and autumn), and hormone concentrations. Results indicated that there is no significant correlation between hormone concentrations and seasons (p = 0.11). This may be due to small differences in temperature between these two seasons.  Conclusions Steroid hormones are a group of biologically active compounds that are excreted by human beings and animals. They enter the environment through sewage discharge and animal waste disposal and can affect human and wildlife health by disrupting their normal endocrine systems. In this research, the levels of E1, E2, E3 and EE2 in raw sewage influent and final treated effluent of 7 WWTPs across Tehran in two seasons (summer-autumn) were studied. The study showed that hormone concentrations in influents of these WWTPs were significantly different and WWTP number 7 had significant differences in influent hormone concentrations compared with others. This may be because it serves a community with bigger populations than other WWTPs. Results only showed a significant relationship between hormones and TSS removal rate, but there was no significant relationship between hormones and COD removal rate. Steroid hormone removal rates in WWTPs are dependent on the waste load and plant design. WWTP number 4 and 7 showed a significant removal rate for hormone, possibly because they have the highest removal rate for TSS than the others. Sorption on an organic-rich solid phase was found to be one of major mechanisms of estrogenic steroids removing in biological treatment and WWTP number 7 due to long sludge retention time (the relation between the method of wastewater treatment and the hormone concentration). The results showed a significant correlation between types of hormones and their respective removal rate. Studies on the relationship between seasons (summer and autumn) and hormone concentrations showed no significant correlation between hormone concentrations and seasons; also, the influent concentration and removal rates did not appear to be seasonally characteristic. As the effluent concentrations of steroid estrogens are high enough to cause adverse effects on the environment, current activated sludge processes should be optimised or other advanced treatment processes should be used to completely eliminate residual estrogens in WWTP effluents.
Consequently, urgent efforts are needed to determine cost-effective alternatives for the removal of these potentially harmful compounds from effluents and to establish corresponding regulations and instructions to control estrogen pollutants in Iran.