Spectroscopic characterization and crystal structures of two cathinone derivatives: N-ethyl-2-amino-1-phenylpropan-1-one (ethcathinone) hydrochloride and N-ethyl-2-amino-1-(4-chlorophenyl)propan-1-one (4-CEC) hydrochloride

Comprehensive chemical characterization for two cathinone derivatives, N-ethyl-2-amino-1-phenylpropan-1-one (ethcathinone) hydrochloride and N-ethyl-2-amino-1-(4-chlorophenyl)-propan-1-one (4-chloroethcathinone, 4-CEC) hydrochloride, in material seized by drug enforcement agencies was performed by nuclear magnetic resonance (NMR) spectroscopy, infrared spectroscopy, gas chromatography–mass spectrometry in positive electron ionization mode, liquid chromatography–mass spectrometry in positive electrospray ionization mode and X-ray crystallography. The examined samples of these two compounds proved to be very pure for ethcathinone and mixed with very small quantities of other substances for 4-CEC by NMR spectroscopy and mass spectrometry. X-ray crystallographic studies confirmed the occurrence of both compounds as racemic mixtures. These spectroscopic and crystallographic data seem very useful for their identification. Especially for 4-CEC, this is the first description on its spectroscopic characterization in a scientific context to our knowledge.

Synthetic cathinones first appeared on the European illicit drug market in 2005 and today they make up one of the largest categories of novel psychoactive substances (NPSs) as over 80 synthetic cathinone derivatives were detected via the EU Early Warning System between 2005 and 2014 [1]. Cathinone derivatives are claimed to have effects similar to those of cocaine, amphetamine or MDMA (ecstasy), but little is known about their toxicity and pharmacokinetic properties. Synthetic cathinones most often are sold as powders or tablets through physical retail shops or via the Internet labeled as 'plant feeders', 'plant food', 'research chemical', or 'bath salts'. Various products are labeled with such warnings as 'not for human consumption' or 'not tested for hazards or toxicity'. The availability of high-quality and pure synthetic cathinones has sometimes been reported as offering direct competition to low-quality and relatively more expensive established drugs. The most common administration routes include insufflation (snorting) and oral ingestion of capsules, tablets or powder wrapped in a cigarette paper (so-called 'bombing'). Rectal insertion and intravenous, subcutaneous and intramuscular injections were also reported [2][3][4].
Ethcathinone (compound 1) was one of the most common NPSs on the illegal drug market in Poland between 2012 and 2014 [5,6]. In Poland, since July 2015, ethcathinone has the status of an controlled substance. Compound 1 (ethcathinone) was subjected to pharmacological studies because it is a metabolite of diethylpropion (N,Ndiethyl-2-amino-1-phenylpropan-1-one), which proved to be more potent than its parent compound. This led to the conclusion that it is the metabolite, and not the starting diethylpropion, that causes the specific anorectic effect [7]. Compound 2 (4-chloroethcathinone, 4-CEC) had been briefly studied in terms of its potential anorectic effect [8]. Its current availability on the illegal drug market makes it probable that this compound will be taken off the register of medical drug candidates.
Samples of the compounds 1 and 2 analyzed here by spectroscopy and crystallography exclusively originated from material seized by drug enforcement agencies. They either did not contain additional substances (in case of compound 1), or were mixed with small quantities of other substances which allowed, however, mechanical separation of thick crystals (compound 2) of very good purity.
In this study, we report the spectroscopic characteristics and crystallographic structures of compounds 1 and 2. To our knowledge, such data are unavailable, especially for compound 2.

Materials and methods
Compounds 1 and 2 were provided by drug enforcement agencies either in pure form (compound 1), or as a mixture of crystals (compound 2) with less than 1% of ingredients (according to NMR data). Crystals of compound 1 suitable for crystallography were obtained by very slow evaporation of solutions used to study this compound by NMR spectroscopy. The pure compound 2 crystals were mechanically separated, recrystallized from a mixture of dichloromethane and acetone, and used in this study.
1 H NMR spectra were recorded in D 2 O or dimethyl sulfoxide (DMSO)-d 6  Separation was achieved on a BDS Hypersil C18 (150 9 2.1 mm, 5 lm) column (Thermo Scientific) maintained at 25°C. The mobile phase A was water, which contained 0.2% formic acid and 2 mM of ammonium formate, and phase B was acetonitrile with 0.2% formic acid and 2 mM of ammonium formate. The gradient program was applied. The operational parameters of the ESI source were as follows: vaporizing temperature 350°C; pressure of the nebulizing gas 40 psi; capillary potential 3500 V. Gas chromatography-mass spectrometry (GC-MS) analyses were performed using a gas chromatograph (TRACE 1300 gas chromatograph) coupled to a mass spectrometer (ISQ LT) equipped with a quadruple mass analyzer (Thermo Scientific). The injector was maintained at 280°C. Sample injection was in splitless mode. Sample component separation was conducted on an RTX-5 capillary column (30-m length, 0.25-mm inner diameter, 0.25lm film thickness; Restek, Bellefonte, PA, USA). Helium was used as a carrier gas at the flow rate of 1.0 mL/min. The temperature program consisted of three segments: the initial column temperature (75°C) was maintained for 1 min, then was increased linearly at 25°C/min up to 280°C, and maintained for 20.8 min. The mass detector was set to positive electron ionization (EI) mode, and the electron beam energy was 70 eV. The mass detector was operating in a full scan mode in the range of m/z 40-450.
The single crystal X-ray experiments were performed at room temperature. The data were collected using a SuperNova kappa diffractometer with an Atlas charge coupled device (CCD) detector and a Xcalibur diffractometer with a Sapphire3 CCD detector (Oxford Diffraction Ltd., Yarnton, England). For the integration of the collected data, the CrysAlis RED software (version 1.171.32.29; Agilent Technologies, Santa Clara, CA, USA) was used. The solving and refining procedures were similar for both compounds. The structures were solved using direct methods with the SHELXS97 software and the solutions were refined using the SHELXL-2014/7 program [16]. CCDC 1481895 (1) and 1481896 (2) contain supplementary crystallographic data for this paper. These data

Results and discussion NMR spectra
Samples of both compounds received for analysis were examined by 1 H and 13 C NMR and IR spectroscopy, and ESI-MS, which confirmed that they were cathinone derivatives. Figures 2 and 3 show NMR spectra of compounds 1 and 2, respectively. They fully confirm the predicted structures of the examined species. At the same time, they demonstrate that the examined substances are nearly pure cathinones. No other signals were detected which would imply the presence of other impurities in the examined sample of compound 1. The 1 H NMR spectrum of compound 2 showed signals at 7.95, 7.40, 5.05, 3.45, 3.16, 2.48, 2.06 and 1.18 ppm of very low intensities reflecting some undefined impurities (approximate content of impurities \1%; Fig. 3, upper panel). The N-H protons in the hydrochloride salt of compound 2 are diastereotopic (chemically inequivalent). These protons were observed as two broad singlets at d = 9.74 and 9.22 ppm but only in DMSO-d 6 solution (Fig. 3, upper panel). In D 2 O or CD 3 OD solutions, these signals were not observed (Fig. 2, upper panel). The 1 H NMR spectra of both compounds confirmed the presence of a substituted benzene ring, which was mono-substituted (compound 1) and di-substituted (para, compound 2). The methinic protons in compounds 1 and 2 appeared as quintets at 5.07 and 5.21 ppm, respectively (see below). The Nethyl side chains yielded two multiplets for methylene protons centered at 3.05 and 3.15 ppm for compound 1, and two broad multiplets (like broad singlets) centered at 2.93 and 3.05 ppm for compound 2. Terminal methyl groups yielded triplets centered at 1.27 and 1.28, for compounds 1 and 2, respectively. The 13 C NMR spectra displayed carbonyl resonance at 197.6 and 195.9 ppm for compounds 1 and 2, respectively (Figs. 2,3, lower panels, also see below). The six aromatic carbons appearing as four signals for both compounds showed greater differences because they reflect chemical

IR spectra
Only IR spectra of compound 1 were previously published [9]. The IR spectra showed strong C=O absorption bands at 1694 and 1686 cm -1 for compounds 1 and 2, respectively. The shift of the C=O absorption band for one compound relative to the other is a result of a substituent in a para position of the aromatic ring in compound 2. Spectra of both compounds showed characteristic bands associated with their salt forms. These included a broad pattern from 2300 to 3100 cm -1 corresponding to amine salt absorption bands and combination of aromatic and aliphatic C-H stretches. The main NH 2 ? stretch absorption for both compounds appeared at 2694 cm -1 . The aromatic C=C ring stretch vibrations appeared at 1597 and ca. 1590 cm -1 for compounds 1 and 2, respectively. A strong band at 839 cm -1 in the spectrum of compound 2 was characteristic for two adjacent free hydrogen atoms in an aromatic para-di-substituted ring (aromatic C-H out-of-plane bend). Two bands at 768 and 698 cm -1 in compound 1 were characteristic for an aromatic C-H out-of-plane bend of a mono-substituted benzene ring. All other absorption peaks are listed below.  Figure 4 shows the EI mass spectra of compounds 1 and 2. Figure 5 shows EI fragmentation pathways of compound 1. For compound 2, fragmentation pathways was identical (with respect to the Cl substituent). The molecular ions for Similarly, for compound 2, the same process led to the 4-chlorobenzoyl cation at m/z 139 and the next 4-chlorophenyl cation at m/z 111. These types of fragmentation are consistent with previously reported data [9,[17][18][19]. Figure 6a shows the ESI mass spectrum of compound 1 upon HPLC-MS analysis. A base peak appeared at m/z 178. 16 Figure 6b shows the ESI mass spectrum of compound 2. Base peaks appeared at m/z 212.09 and 214.09 (for isotopic 37 Cl atom). The elimination of one water molecule from the protonated molecular ion is very characteristic for cathinones, especially in the tandem mode [19]. For both described compounds, this phenomenon appeared in MS 1 spectra. In Fig. 7, we present proposed fragmentation pathways for ESI in MS 2 , MS 3 and MS 4 modes for compound 1 and compound 2 as well.

X-ray studies
Both hydrochloride salts crystallize in a monoclinic (P2 1 /c) space group. The molecular structures of both compounds are shown in Fig. 8. Packing diagrams for both compounds are shown in Fig. 9. Crystal data and structure refinement for compounds 1 and 2 are presented in Table 1. The ring systems in both compounds were planar. All distances and angles in the molecular structures were normal. Hydrogen bonds in compounds 1 and 2 are listed in Tables 2 and 3, respectively. Selected geometric parameters for compounds 1 and 2 are presented in Table 4.
Compound 1 Both compounds occurred in the examined crystals as paired enantiomers. The pairs were mutually linked by  Symmetry codes: (i) x, -y ? 1/2, z -1/2; (ii) x, -y ? 1/2, z ? 1/2; (iii) -x, -y ? 1, -z ? 1 hydrogen bonds formed with chloride ions occurring between these molecules. For compound 1, all short contacts were linked to methyl groups (in position 2, and in ethyl group) and chloride ions freely located between molecules of the compound as well as with a ketone group of oxygen atoms. Chloride ions were placed at almost equal distance from two ammonium groups from the adjacent molecules (3.131 and 3.169 Å , respectively, Fig. 9a); at the same time, hydrogen atoms C-H9 and C-H8 from two surrounding molecules formed close contacts with the same chloride ion (2.88 and 2.918 Å , respectively, Fig. 10.). Torsional angles C7C8N1C10 were identical in both enantiomers present in the elementary cell (165.77 o ).

Compound 2
Compound 2 stereoisomers occurred pairwise forming hydrogen bonds with chloride ions (Fig. 11). Torsional angles C7C8N1C10 are identical in both enantiomers (69.25°). Distances between N-HA, as well as N-HB, and chloride ion present between these molecules were 2.221 and 2.322Å , respectively.
Crystallographic structures of both compounds can be characterized by the distance between the chloride ion and the surrounding molecules of cathinone cation. In the case of compound 1, the chloride ion was surrounded by four different cationic species (Fig. 10), whereas in compound 2, this ion was surrounded by three adjacent cations (Fig. 11b). This finding is corroborated by short distances between the chloride ion and various fragments of surrounding molecules (\3Å ).

Compliance with ethical standards
Conflict of interest The authors have no financial or other relations that could lead to a conflict of interest.
Ethical approval This article does not contain any studies with human participants or animals performed by any of the authors.
Open Access This article is distributed under the terms of the Creative Commons Attribution 4.0 International License (http://crea tivecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution, and reproduction in any medium, provided you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons license, and indicate if changes were made.