Synthesis of multidentate ligands with amido or amino donor groups for the preparation of rhenium and technetium radiopharmaceuticals

A new method to prepare novel semi-rigid multidentate ligands containing nitrogen atom, to coordinate with rhenium and technetium, was established. The method was based on formylation of substituted anilines, followed by Mannich reaction with glycine and paraformaldehyde. The method was very promising to design ligands of various molecular structures (L1–L5) to coordinate with rhenium metal ions. The complexes were prepared through ligand exchange with the complex ReOCl3(PPh3)2, giving new complex of the structure ReOCl3L(1–5). The prepared ligands and complexes were identified by the use of UV–vis, and infrared absorption spectrometric techniques, elemental analysis, molecular weight determination by depression of freezing point. These ligands were labeled with 99mTc pertechnetate, and the labeling efficiency of the complexes was measured using a well type scintillation gamma counter equipment and obtained a good yield.


Introduction
The coordination chemistry of technetium has rapidly developed, owing to its short half-life, pure photon emission, and suitable energy of 99m Tc, make it the best choice for imaging studies [1][2][3]. The more recent introduction of b-emitting isotopes 188 Re and 186 Re in diagnostic imaging and radiotherapy boost the chemistry of rhenium as well [4][5][6][7]. A great number of chelate ligands for the encapsulation of rhenium and technetium have been prepared in the search of novel, selective, and effective agents for radiodiagnostic imaging and therapy.
Among the first of these ligands is that containing the peptide bonds of glycine and other amino acid derivatives in various molecular design, which were commonly used for imaging of the hepatobiliary system. There are three 99m Tc-HIDA (2,6-dimethylphenylcarbamoylmethyl)iminodiacetic acid) analogues which have been approved for this purpose; 99m Tc-Lidofenin, 99m Tc-Mebrofenin, 99m Tc-Disofenin, and N-(2-pyridylmethyl)iminodiacetic acid. The lipophilic properties of this compound were demonstrated in chloroform extraction studies where more than 80 % of the 99m Tcligands were extracted into the organic phase from the aqueous phase. The exact nature of the complexes is uncertain but it was proposed to contain two ligands coordinated in an octahedral configuration and bear a single negative charge [8,9]. Other type of ligands consists of small peptides of glycine and other amino acids, which have proved successful in sequestering these metals.
The present work will focus on the development of a new and simple synthetic procedure of new amino acid (glycine) chelates combined with an aniline substituted moiety through carbamoyl group for labeling with rhenium and technetium metals. Briefly, this study related to their ability to coordinate to rhenium and technetium has shown their potential of using them as new imaging probes.

Chemicals and instruments
Substituted anilines (p-aminobenzoic acid and 2-aminopyrimidine) were purchased from BDH; 4-chloro-2-nitroaniline from Merck) diphenyl amine, and phenylene diamine from Fluka. Formaldehyde and rhenium metal powder purchased from Aldrich, glycine from Riedel de Häen. Melting points were measured with electrothermal melting Point (BÜ CHI 535). UV-visible spectra were obtained with Shimadzu UV-Visible double beam scanning Spectrophotometer-260. Infrared spectrophotometric spectra were obtained Pye-Unicom-SP3-100spectrophotometer with KBr disc. Perkin Elmer CHN Elemental Analyzer was used for elemental analyses. Radioactivities were measured by using a well type scintillation gamma counter equipment (berthold MAG 312 West-Germany).
General formylation procedure A mixture of (0.030 mol) of substituted aniline and formic acid (10.0 mL) was refluxed for 8 h. Formic acid was removed by evaporation, and the residue was left over filter paper for 1 h. The residue was transferred a beaker of 100 mL, washed with 10.0 mL distilled water, and then left over watch glass to dry at room temperature.

Preparation of the complexes ReOCl 3 (PPh 3 ) 2
Rhenium metal powder (0.5 g, 2.0 mmol) was gradually treated with 9.0 mL of 35 % hydrogen peroxide in ice bath. The ice bath was replaced with water bath and the solvent was evaporated to 1-2 mL solution. The ice bath was replaced again, and then added with stirring a solution mixture of 5.0 mL concentrated hydrochloric acid and triphenyl phosphine (PPh 3 , 5.0 g, 1.0 mmol) in acetone (25.0 mL). When a yellowish green precipitate was formed. The mixture was stored to for reaching room temperature for 1 h and filtered. The precipitate was washed with 10.0 mL ethanol and dried at room temperature (2.2 g, 96 %, and mp 213°C) [18].
Preparation of the complexes ReOCl 3 L An amount of the complex ReOCl 3 (PPh 3 ) 2 (0.20 g, 0.04 mmol) was placed in 100.0 mL r.b.f, and treated with a mixture of the ligand (0.40 mmol) and 95 % ethanol (2.0 mL). The mixture was refluxed for 90 min and color changement was observed. The flask was cooled and the precipitate was filtered with filter paper and then, dried at room temperature overnight.

Radiochemical purity
For labeling, ligand solution (0.20 mg in 0.4 mL of saline solution) was mixed with freshly prepared solution of hydrated stannous chloride (containing 0.30 mg SnCl 2 Á2H 2 O in 0.20 mL of 0.2 N HCl). The resulting mixture was labeled by adding a suitable volume 2.0-5.0 mL of 99m Tc-pertechnetate (0.5-10 mCi) eluate from 99 Mo to 99m Tc generator (CIS-biointernational, France). Radiochemical labeling analysis was performed by adding a suitable volume (0.10-0.30 mL) of the above labeled preparation on the top of a column (1 9 20 cm) packed with Sephadex-25-fine (Pharmacia, Sweden). The column was eluted with normal saline solution, and (3.0 mL) fractions were collected and the radioactivity of each fraction was counted with a well type scintillation counter to obtain the labeling efficiency of each ligand.

Results and discussion
The formyl derivatives and Mannich reaction substituted anilines were prepared following the general procedures mentioned in the experimental part. They were obtained in good purity and radiolabeling yields (*70 % in general). Their physical, UV-visible, and IR absorption spectroscopic properties of the formyl derivatives (I-V) and their Mannich reaction products with glycine (L1-L5) as well as the 1:1 coordination products ReOCl3L (C1-C5), were presented in Tables 1, 2, and 3. The proposed chemical structure of the Mannich reaction products were presented in Fig. 1. These results were in good agreement with the proposed chemical structure of the products. All formyl derivatives showed two new absorption bands at 1,668-1,735 and at 2850-2750 cm -1 in the FT-IR spectra corresponding the attachment of formyl group on anilines. The first one was due to the C=O stretching, while the second one was due to the C-H aliphatic stretching. The second absorption band disappeared upon Mannich reaction substitution. k max of the UV-visible absorption spectra of the substituted anilines used as starting materials showed clear shift to higher wave    length upon substitution with the formyl group, and with methyl glycine after Mannich reaction. Generally, this shift is accompanied with increase in the value of k max of the products due to the hyperconjugation of the amine proton with benzene ring (Figs. 2, 3, 4). This new method will offer reliable procedure to design ligands of the following general structure.
This structure will contain a lipophilic part of aromatic nucleus, and the hydrophilic part which can be any other amino acids. Rhenium complexes of these complexes were prepared by ligand substitution with the rhenium complex, oxotrichloro(triphenyl phosphine)rhenium(V) [ReOCl 3 -(PPh 3 ) 2 ] with 1:1 mol ratio of the metal:ligand. Chromatography profile of the labeled ligands on a Sephadex G-25 column shows that high percentage of the radioactivity was recovered in the void volume associated with the ligand fraction (Fig. 5). It gives good indication about the efficiency of labeling these ligands with Na 99m TcO4. Future work will be directed towards the direct application of these ligands in radiopharmaceutical imaging.
Open Access This article is distributed under the terms of the Creative Commons Attribution License which permits any use, distribution, and reproduction in any medium, provided the original author(s) and the source are credited.