Abstract
Acoustic emission (AE) is employed in this study to understand the failure process in fiber-reinforced cellular concrete (FRCLC) subjected to direct shear load. Synthetic polyolefin fibers are used as reinforcement in FRCLC blocks, and their influence on the shear-fracture process is investigated. AE parameters are investigated to assess the effectiveness of fibers in performance improvement of shear strength and toughness of CLC. In total, 24 CLC specimens are tested under direct shear. Effect of fiber dosage and combinations of macro and microfibers are considered as study parameters. Shear crack bridging effect of fibers during the process of shear-slip is investigated. Test results indicate that AE and shear fracture energy increase with increasing fiber dosage. It is observed that discontinuous structural synthetic fibers significantly improve the ultimate shear strength, residual strength, ductility, stiffness, and toughness of CLC. Also, the structural synthetic fibers reduced the shear crack width and shear-slip of CLC. AE parameters such as counts, energy, and 3D-crack source location are presented to illustrate the role of different fiber dosages on the direct shear response. Shear crack location was found to be consistent with the observed failure planes in the specimens. AE data analysis reveals that the number of mode II type events increased with increasing fiber dosage due to increased fiber pullout. Besides, mode I type events also increased as the failure mode changed from a single split crack to distributed cracking.
Similar content being viewed by others
References
Jones, M.R., Mccarthy, A.: Preliminary views on the potential of foamed concrete as a structural material. Mag. Concr. Res. 57(1), 21–31 (2005)
Soetens, T., Matthys, S.: Shear-stress transfer across a crack in steel-fibre-reinforced concrete”. Cem. Concr. Compos. 82, 1–13 (2017)
Gao, D., Zhang, L., Nokken, M.: Mechanical behavior of recycled coarse aggregate concrete reinforced with steel fibers under direct shear. Cem. Concr. Compos. 79, 1–8 (2017)
French, R., Maher, E., Smith, M., Stone, M., Kim, J., Krauthammer, T.: Direct shear behavior in concrete materials. Int. J. Impact Eng 108, 89–100 (2017)
Katsaga, T., Sherwood, E.G., Collins, M.P., Young, R.P.: Acoustic emission imaging of shear failure in large reinforced concrete structures. Int. J. Fract. 2007, 29–45 (2008)
Rahal, K.N., Khaleefi, A.L.: An experimental investigation of the shear-transfer strength of normal and high strength self compacting concrete. Eng. Struct. 109, 16–25 (2016)
Mhamdi, L., Asce, S.M., Schumacher, T., Linzer, M.L.: Characterization of flexural and shear cracks in reinforced concrete beams using moment tensor inversion from acoustic emission signals. J. Struct. Eng. 3, 1–9 (2015)
Trunk, B., Schober, G., Helbling, A.K., Wittmann, F.H.: Fracture mechanics parameters of autoclaved aerated concrete. Cem. Concr. Res. 29, 855–859 (1999)
Sause, M.G.R., Richler, S.: Finite element modelling of cracks as acoustic emission sources. J. Nondestruct. Eval. 34(4), 1–13 (2015)
Soulioti, D., Barkoula, N.M., Paipetis, A., Matikas, T.E., Shiotani, T., Aggelis, D.G.: Acoustic emission behavior of steel fibre reinforced concrete under bending. Constr. Build. Mater. 23(12), 3532–3536 (2009)
Hu, S., Lu, J., Xiao, F.: Evaluation of concrete fracture procedure based on acoustic emission parameters. Constr. Build. Mater. 47, 1249–1256 (2013)
Kawasaki, Y., Wasada, S., Okamoto, T., Izuno, K.: Evaluation for RC specimen damaged from rebar corrosion by acoustic emission technique. Constr. Build. Mater. 67, 1–8 (2014)
Elfergani, H.A., Pullin, R., Holford, K.M.: Damage assessment of corrosion in prestressed concrete by acoustic emission. Constr. Build. Mater. 40, 925–933 (2013)
Nor, N., Ibrahim, A., Muhamad, N., Saman, H.M.: Acoustic emission signal for fatigue crack classification on reinforced concrete beam. Constr. Build. Mater. 49, 583–590 (2013)
Aggelis, D.G., Mpalaskas, A.C., Matikas, T.E.: Investigation of different fracture modes in cement-based materials by acoustic emission. Cem. Concr. Res. 48, 1–8 (2013)
Aldahdooh, M.A.A., Bunnori, N.M.: Crack classification in reinforced concrete beams with varying thicknesses by mean of acoustic emission signal features. Constr. Build. Mater. 45, 282–288 (2013)
Aggelis, D.G., Verbruggen, S., Tsangouri, E., Tysmans, T., Van Hemelrijck, D.: Characterization of the mechanical performance of concrete beams with external reinforcement by acoustic emission and digital image correlation. Constr. Build. Mater. 47, 1037–1045 (2013)
Ohno, K., Ohtsu, M.: Crack classification in concrete based on acoustic emission. Constr. Build. Mater. 24(12), 2339–2346 (2010)
Zollo, R.F., Hays, C.D.: Engineering material properties of a fiber-reinforced cellular concrete. ACI Mater. J. 95(5), 631–635 (1998)
Rasheed, M.A., Prakash, S.S.: Experimental study on compression behavior of fiber-reinforced cellular concrete stack-bonded masonry prisms. ACI Mater. J. 115, 149–160 (2018)
Rasheed, M.A., Prakash, S.S.: Mechanical behavior of sustainable hybrid-synthetic fiber reinforced cellular light weight concrete for structural applications of masonry. Constr. Build. Mater. 98, 631–640 (2015)
Rasheed, M.A., Prakash, S.S.: Behavior of hybrid-synthetic fiber reinforced cellular lightweight concrete under uni-axial tension—experimental and analytical studies. Constr. Build. Mater. 162, 857–870 (2018)
Bhosale, A., Rasheed, M.A., Prakash, S.S., Raju, G.: A study on the efficiency of steel vs. synthetic vs. hybrid fibers on fracture behavior of concrete in flexure using acoustic emission. Constr. Build. Mater. 199, 256–268 (2018)
Rasheed, M.A., Prakash, S.S., Raju, G., Kawasaki, Y.: Fracture studies on synthetic fiber reinforced cellular concrete using acoustic emission technique. Constr. Build. Mater. 169, 100–112 (2018)
Japan Concrete Institute: Method of Test for Fracture Energy of Concrete by Use of Notched Beam (JCI-S-001-2003)
Ohtsu, M.: Recommendation of RILEM TC 212-ACD: acoustic emission and related NDE techniques for crack detection and damage evaluation in concrete: a test method for classification of active cracks in concrete structures by acoustic emission. Mater. Struct. Constr. 43(9), 1187–1189 (2010)
Acknowledgements
The authors wish to thank the Department of Science and Technology, India and duly acknowledge the financial support extended through Grant No: YSS/2015/000677, SR/S2/RJN-30/2012.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Rasheed, M.A., Prakash, S.S. & Gangadharan, R. Acoustic Emission Characterization of Hybrid Fiber Reinforced Cellular Concrete Under Direct Shear Loads. J Nondestruct Eval 38, 17 (2019). https://doi.org/10.1007/s10921-018-0556-3
Received:
Accepted:
Published:
DOI: https://doi.org/10.1007/s10921-018-0556-3