Transforming the Built Environment Through Healthy-Design Strategies A Multidimensional Framework for Urban Plans ’ Evaluation

. According to the research grant titled “ Urban Health: good practices for health impact assessment of urban and environmental redevelopment and regeneration interventions ” and awarded by the Italian National Center for Disease prevention and Control (CCM) in 2017, this paper is aimed to describe the overall goal of the project: develop and disseminate experience-based practices among Policy Makers, based on Health Impact Assessment models, literature and case studies, mainly referred to healthy aging and equity in urban regeneration programs. The authors were involved in the development and application phases of a quali-quantitative assessment tool, capable of providing an effective and ﬂ exible support to the Local Health Agencies (LHAs) for evaluating the Urban Health strategies ’ integrations into urban plans. The ﬁ nal framework is composed by 20 criteria, aimed to assess the propensity of urban plans to promote Urban Health strategies. The criteria are divided into 7 macro-areas: the ﬁ rst one including prerequisites (0. General criteria) while the other 6 constituting the assessment tool (1. Environment; 2. Soil and subsoil; 3. Sustainability and hygiene of the built environment; 4. Urban and social development; 5. Mobility and transport; 6. Outdoor spaces). This research project could be considered a starting point to disseminate methods, tools and indicators to design and assess not merely the public spaces ’ environmental quality, but also foresee the urban plans ’ Public Health outcomes.


Research Opportunities
According to this scientific debate, the authors are part of a research group at Department of Architecture, Built environment and Construction engineering (ABC) of Politecnico di Milano still working on a research grant titled "Urban Health: good practices for health impact assessment of urban and environmental redevelopment and regeneration interventions" and awarded in 2017 by the Italian National Center for Disease prevention and Control (CCM). The overall goal of the research project CCM2017 was to develop and disseminate experience-based practices among Policy Makers, based on Health Impact Assessment models, literature and case studies, mainly referred to healthy aging and equity in urban regeneration programs.
The specific objectives of the CCM2017 project were six; the key one -the firstwas to draft and apply a quali-quantitative assessment tool, capable of providing an effective and flexible support to the LHAs for evaluating the Urban Health strategies' integrations into urban plans. Even before the research proposal, it was highlighted the lack -in the national scenario -of evaluation tools capable to support, both designers and Policy Makers, in the achievement of Public Health purposes [9].

Methodological Framework
Given these premises and according to the experience developed in 2010 by Politecnico di Milano together with the LHA of the Municipality of Milano (better known as ASL Milano, but nowadays called ATS Città Metropolitana di Milano), the current research provided a deep revision of the overall structure of the tool previously framed by solving and implementing criticalities detected by its application and given the necessity to update the methodology and the contents.
The research developed in 2010 was divided into criteria too, but with a different purpose: in 2010 the objective was to evaluate the environmental hygiene aspects of urban plans; actually, the tool presented in this paper, aims to assess the level of adherence and development of the Urban Health criteria. Furthermore, in the current tool, the criteria are weighted according to importance and therefore contribute, in a different way, to the final score.
The final goal of the research is to define a quali-quantitative assessment tool, capable of providing effective and flexible support to the LHAs for evaluating the Urban Health strategies' integrations into urban plans. For this reason, the methodological framework has been divided mainly in 3 phases organized by following the scheme of [10] namely intelligence, design and choice (Fig. 1), that can be described as follow: the intelligence phase refers to the description of the main objectives, the analysis of the previous experience and a deep investigation of the state of the art. the design phase consists in the development of the framework, its validation and the criteria weight elicitation; the choice phase deals with the final validation of the tool and its dissemination.

Intelligence Phase
Given the final objective to support LHAs in formulating suggestions to protect and promote Public Health into urban plans, considering an Urban Health approach, the research started with a deep analysis of the State of the Art. This step consisted of a literature review with special reference on Experience Based Healthy Design and Urban Planning Strategies, the analysis of existing urban-scale assessment tools and the revision of case studies of urban regeneration with health impacts on the context. The literature confirmed the suitability of the MCA in supporting decisions about complex problems since allows to structure them in hierarchical phases and levels in order to be solved by having an overall view of the big picture. In particular, problems concerning the transformation of the environment are defined as complex [6], since they are characterized by a multidimensional nature where multiple trade-offs have to be found among several aspects. It is therefore essential to evaluate their impacts and effects on the environmental quality and the social well-being in order to guarantee transparency and legitimacy of those processes whose final decision is able to affect the entire community. In this context the transparency is ensured by the adoption of clear methodologies able to guide the decision-makers in the different phases of the evaluation process [11,12].
Moreover the comparison with literature allowed to identify the most frequently used and validated assessment tools aimed to evaluate urban quality and sustainable features of urban projects and plans [Green Star Communities, Australia; Global Sustainability Assessment System (GSAS), Qatar; Comprehensive Assessment System for Built Environment Efficiency for Urban Development (CASBEE-UD), Japan; LEED Neighbourhood Development, United States; British Research Establishment Environmental Assessment Method for (BREEAM) Communities, United Kingdom; DGNB System, German Sustainable Building Council; HQE for Urban Planning Development (UPD), France]. From the analysis and comparison of the related indicators, it has been pointed out, in most of them, the absence of specific criteria directly connected to Public Health outcomes [13].

Design Phase
The previous phase led to the definition of criteria and indicators able to measure to which extent a town-planning plan is able to promote Urban Health strategies and to enhance a built environment aimed at satisfying social needs, improve people's quality of life and promote the adoption of healthy lifestyles, like Physical Activity.
Most of the criteria are a review of those defined during the previous experience [6] while others are the result of emerging needs reported by studies on Urban Health and Experience Based Healthy Design [14]. Moreover, within this context, the Multicriteria Analysis (MCA) has been considered as the most suitable methodology able to face the complexity of the decision context given by the presence of several and sometimes conflictual objectives and the co-existence of different dimensions to balance.
The framework underwent two different steps to achieve the final validation. The first moment involved the application of the multicriteria tool on existing urban plans and it has been carried on by the LHA of Bergamo, divided in two teams of professionals. Within this first step, a special attention has been given to the evaluation of the effectiveness of the tool and its objectiveness in formulating judgements. The second moment consisted in two meeting organized with the Welfare General Directorate of Lombardy Region and professionals coming from all the LHAs based in Lombardy Region, in order to have feedbacks about the tool.
Once all the feedbacks have been collected and processed, the final framework has been defined composed by 20 criteria (indicators), aimed to assess the propensity of urban plans to promote Urban Health strategies. The criteria are divided into 7 macroareas: the first one including prerequisites (0. General criteria) while the other 6 constituting the assessment tool (1. Environment; 2. Soil and subsoil; 3. Sustainability and hygiene of the built environment; 4. Urban and social development; 5. Mobility and transport; 6. Outdoor spaces).
-Based on an idea of urban quality that diverges -significantly -from the traditional quantitative type, linked to the concept of urban planning standards, the proposed criteria are qualitative and performance. Each criteria is then assessed through a performance matrix. The attribution of the judgment to the criteria consists in verifying the level of adhesion of each urban plan/project to a set of performance requirements (presence/absence of specific Urban Health strategies) described in the matrix, according to the following scheme: Strong: it represents the performance most consistent with the objectives of Urban Health, with reference to the single criterion analyzed; -Moderate: it is the intermediate level and refers to a consistent performance that can be improved; -Low: it does not consider any Urban Health strategy, limiting itself to mere compliance with sector regulations.
The individual judgments correspond to numerical values in order to elaborate summary evaluations (evaluation by areas and the final overall evaluation of the project) and explanatory graphs of analysis.
When the final set of indicators has been structured (Fig. 2), it has been possible to weight their influence in achieving the main objective.
In fact, considering the aim of evaluating the willingness of a town-planning plan to promote Urban Health, the SWING method has been selected as the most appropriate technique since explicitly incorporates the attribute ranges in the elicitation question [15]. In particular, it uses a reference scenario in which all the attributes get their worst level and the interviewee is asked to score (e.g. in the range 0-100) the scenarios in which one attribute at a time changes its status and moves to the best level. The weights are then elaborated and are proportional to the values assigned. For this phase experts of Politecnico di Milano and professionals from LHA have been involved.

Choice Phase
Once the multicriteria tool has been framed and weighted, it has been presented to a multi-disciplinary panel of experts with the role of final reviewers of the methodology applied and the contents described. Following the positive feedbacks received from the panel, the tool has been further integrated, so to better describe and explore some methodological steps. Finally, the tool was presented in public to potential  Stakeholders (urban planners, designers, Public Health experts, Policy Makers, Administrators, etc.) in order to identify any further aspects to be improved and to have an additional validation. The LHA of Bergamo, local research unit of the CCM2017 Project, tested the assessment framework in its daily activities of urban plans and projects' evaluation. This approach, common to all the Public Health operators, will be helpful to be more effective and incisive in the opinions to be expressed about urban plans and projects, with a carefulness to the design sphere that consider more strategic the performances and that exceeds compliance with regulatory requirements. At the same time, designers can receive an effective support about the application of Urban Health strategies, inherent the wording of the framework indicators. The assessment framework has therefore been validated and the dissemination phase of which manuals, papers and workshops are part, has begun.

Evaluating the Built Environment
Within this context, as it has been already described, the multicriteria framework allows to give an overall evaluation of urban plans according to the Urban Health approach by considering external and design factors. What deserve to be explored is the role of the built environment in promoting or negatively affecting the wellbeing of inhabitants. In fact, among the selected macro-areas, one is focused in analyzing the role of buildings and the design process in achieving sustainable goals.

Sustainability and Hygiene of the Built Environment
The third macro-area, titled "Sustainability and hygiene of the built environment", is the which one that involves all the indicators aimed at assessing the possible interactions (positive or negative) of urban plans on the environment in terms of sustainable development and resilience to climate change. Here both the management dimension and the design one are considered. In fact, the first criterion 09 -Solid waste collection consider all policies aimed at managing the entire waste process, from its production to its final outcome. Innovative systems of waste collection, like pneumatic networks, have direct impacts on hygiene, cleaning and sanitation actions of the city and its public spaces, whether they are close to residential dwellings [16], or closer to squares and public spaces in general. The criterion is also focused on the process of collection, transport, treatment (recovery or disposal) and also the reuse of waste materials, usually produced by human activity, in an attempt to reduce their effects on human health and the environment. The second one, 10 -Urban waste collection and disposal considers the infrastructure or sewerage network as a complex and articulated system of underground canalizations that allows the collection and conveyance of domestic, industrial and urban wastewater. This wastewater is then purified and discharged into river mouths or directly into the sea. When disposing of wastewater, a distinction must be made between black water and rainwater (or white water). In order to design sustainable living environments that respect the natural water cycle, it is important to anticipate and encourage the following strategies: a) separate sewerage (rainwater and sewage); b) rainwater reuse system after separation of first rainwater. The last criterion, 11 -Energy and reduction of emissions encourages greater awareness of consumption and sustainability regarding technological and plant engineering choices in order to improve the energy efficiency of buildings. In fact, the reduction of energy consumption leads to less local air pollution, with direct positive effects on the Public Health of the inhabitants. In addition, lower air pollution leads to lower impacts on the climate-environment, which in turn leads to further lower impacts on health. It is therefore important to reach performance certificate with high performance class or presence of further recognized environmental certification (LEED, BREAM, etc.); or adopt a balance between the following strategies: passive principles for sustainability (orientation and shape; thermal insulation and inertia; natural ventilation; shielding systems); active principles for sustainability in % above the legal minimums: (electricity and thermal energy from renewable sources, efficient plant systems).
It is important to underline how the role of humans is fundamental in achieving sustainable objectives even related to their own health, according to the Healthy Cities definition stating that urban settlements are "those urban centers that continuously creating and improving those physical and social environments, encouraging the expansion of resources and making people in conditions to support each other in performing and developing all the daily activities." [17]. All the instances discussed in this macro-area aim at improving the overall quality of life by providing strategies that could be adopted during the design phase.

Conclusions
This research project could be considered a starting point to disseminate methods, tools and indicators to design (if applied preliminarily to the project by architects and urban planners) and assess (if used from the LHAs) the public spaces' environmental quality, according to the international scenario [20], where several frameworks -mainly conscious about the urban quality assessment -are frequently used, like those one cited in the introduction. The research and application outlooks will take consistency in spreading the tool to all the LHAs, but also to the architectural and urban planning firms, in order to be applied -bilaterally -since from the early design stages.
It is necessary and crucial to evaluate the public space with qualitative frameworks and approaches, highlighting the urban context and public spaces features, experiencebased oriented to promote healthy lifestyles.
Making cities healthier means to improve those physical factors -as network of public spaces, land use mix, street design, etc. -capable to create a more healthy, safe, comfortable and attractive places. Making the urban settlements more sustainable means also take care about the built environment, both in the design process and in the building features (construction materials, active and passive solar systems, environmental orientation of buildings; etc.).
The paradigm of Public Health needs to be changed, moving from a medical model, focused on the individuals, to a social model, where the health status is the result of various socio-economic, cultural and environmental factors.
A multidisciplinary approach is crucial [18][19][20], as it enable to put together different stakeholders, like epidemiologist and Public Health experts; urban planners, designers and construction technologists; Policy Makers, to enhance a direct interaction with decision-maker; and, finally, economists or valuation experts, dealing with the project feasibility studies.