Abstract
Homogeneous charge compression ignition (HCCI) engines have the potential to raise the efficiency of reciprocating engines during partial load operation. However, the performance of the HCCI engine at high loads is restricted by severe knocking, which can be observed by the excessive pressure rise rate. This is due to the rapid combustion process occurring inside the cylinder, which does not follow the flame propagation that is seen in conventional engines. In this study, a low compression ratio of 9.5:1 for a gasoline engine was converted to operate in HCCI mode with the goal being to expand the stable operating region at high loads. Initially, pure n-heptane was used as the fuel at equivalence ratios of 0.30 to 0.58 with elevated intake charge temperatures of 180 and 90 °C, respectively. The n-heptane HCCI engine could reach a maximum performance at an indicated mean effective pressure (IMEP) of 0.38 MPa, which was larger than the performance found in the literature. To reach an even higher performance, a dual-fuel system was exploited. Methanol, as an anti-detonant additive, was introduced into the intake stream with various amounts of n-heptane at fixed equivalence ratios in the range of 0.42 to 0.52. It was found that the methanol addition cooled the mixture down prior to combustion and resulted in an increased coefficient of variation (COV). In order to maintain stable combustion and keep the pressure rise rate below the limit, the intake charge temperature should be increased. Introduction of 90% and 95% (vol/vol) hydrous methanol showed a similar trend but a lower thermal conversion efficiency and IMEP value. Therefore, a dual fuel HCCI engine could maintain a high thermal conversion efficiency across a wide load and enhance a 5% larger load compared to a pure n-heptane-fuelled HCCI engine. The hydrocarbon (HC) and carbon monoxide (CO) emissions were lower than 800 ppm and 0.10%, respectively. They were less at higher loads. The nitrogen oxides (NO x ) emissions were below 12 ppm and were found to increase sharply at higher loads to a maximum of 23 ppm.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Anderlohr, J. M., Piperel, A., Pires da Cruz, A., Bounaceu, R., Battin-Leclerc, F., Dagaut, P. and Montagne, X. (2009). Influence of EGR compounds on the oxidation of an HCCI-diesel surrogate. Proc. Combustion Institute, 32, 2851–2859.
Chung, J. W., Kang, J. H., Kim, N. H., Kang, W. and Kim, B. S. (2008). Effects of the fuel injection ratio on the emission and combustion performances of the partially premixed charge compression ignition combustion engine applied with the split injection medthod. Int. J. Automotive Technology 9,1, 1–8.
Lü, X., Hou, Y., Zu, L. and Huang, Z. (2006). Experimental study on the auto-ignition and combustion characteristics in the homogeneous charge compression ignition (HCCI) combustion operation with ethanol/n-heptane blend fuels by port injection. Fuel 85,17–18, 2622–2631.
Lü, X., Ji, L., Ma, J. and Huang, Z. (2007). Experimental study on the cycle-by-cycle variations of homogeneous charge compression ignition combustion using primary reference fuels and their mixtures. Proc. Institution of Mechanical Engineers, Part D, J. Automobile Engineering, 221, 859–866.
Lü, X., Ji, L., Zu, L., Hou, Y., Huang, C. and Huang, Z. (2007). Experimental study and chemical analysis of n-heptane homogeneous charge compression ignition combustion with port injection of reaction inhibitors. Combustion and Flame, 149, 261–270.
Ma, J., Lü, X., Ji, L. and Huang, Z. (2008). An experimental study of HCCI-DI combustion and emissions in a diesel engine with dual fuel. Int. J. Thermal Sciences, 47, 1235–1242.
Machrafi, H., Cavadias, S. and Amouroux, J. (2008). A parametric study on the emissions from an HCCI alternative combustion engine resulting from the autoignition of primary reference fuels. Applied Energy, 85, 755–764.
Maroteaux, F. and Noel, L. (2006). Development of a reduced n-heptane oxidation mechanism for HCCI combustion modeling. Combustion and Flame, 146,1–2, 246–267.
Mattavi, J. N. and Amann, C. A. (1980). Combustion Modeling in Reciprocating Engines. Plenum. New York.
Megaritis, A., Yap, D. and Wyszynski, M. L. (2006). Effect of water blending on bioethanol HCCI combustion with forced induction and residual gas trapping. Energy, 32, 2396–2400.
Megaritis, A., Yap, D. and Wyszynski, M. L. (2008). Effect of inlet valve timing and water blending on bioethanol HCCI combustion using forced induction and residual gas trapping. Fuel, 87, 732–739.
Miguel, T. G., Francisco José Jiménez-Espadafor, Aguilar and Tomás, S. L. (2009). Experimental study of the performances of a modified diesel engine operating in homogeneous charge compression ignition (HCCI) combustion mode versus the original diesel combustion mode. Energy 34,2, 159–171.
Miller Jothi, N. K., Nagarajan, G. and Renganaraya-nan, S. (2008). LPG fueled diesel engine using diethyl ether with exhaust gas recirculation. Int. J. Thermal Sciences, 47, 450–457.
Nwafor, O. (2002). Knock characteristics of dual-fuel combustion in diesel engines using natural gas as primary fuel. Sadhana, 27,Part 3, 375–382.
Qian, Z. and Lu, X. (2006). Characteristics of HCCI engine operation for additives, EGR, and intake charge temperature while using iso-octane as a fuel. J. Zhejiang University SCIENCE A, Suppl. II, 252–258.
Shi, L., Cui, Y., Deng, K., Peng, H. and Chen, Y. (2006). Study of low emission homogeneous charge compression ignition (HCCI) engine using combined internal and external exhaust gas recirculation (EGR). Energy, 31, 2665–2676.
Sjoberg, M. and Dec, J. E. (2007). Comparing late-cycle autoignition stability for single- and two-stage ignition fuels in HCCI engines. Proc. Combustion Institute, 31, 2895–2902.
Yamada, H., Yoshii, M. and Tezaki, A. (2005). Chemical mechanistic analysis of additive effects in homogeneous charge compression ignition of dimethyl ether. Proc. Combustion Institute, 30, 2773–2780.
Yao, M., Chen, Z., Zheng, Z., Zhang, B. and Xing, Y. (2007). Study on the controlling strategies of homogeneous charge compression ignition combustion with fuel of dimethyl ether and methanol. Combustion and Flame, 149, 261–270.
Yap, D., Karlovsky, J., Megaritis, A., Wyszynski, M. L. and Xu, H. (2005). An investigation into propane homogeneous charge compression ignition (HCCI) engine operation with residual gas trapping. Fuel, 84, 2372–2379.
Zheng, Z. and Yao, M. (2009). Charge stratification to control HCCI: Experiments and CFD modeling with n-heptane as fuel. Fuel, 88, 354–365.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Thanapiyawanit, B., Lu, J.H. Cooling effect of methanol on an n-heptane HCCI engine using a dual fuel system. Int.J Automot. Technol. 13, 1013–1021 (2012). https://doi.org/10.1007/s12239-012-0104-6
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12239-012-0104-6