Abstract
Extensive research has been carried out in recent years on the use of Fibre-Reinforced Polymer (FRP) composites in the strengthening of Reinforced Concrete (RC) structures. The piles in berthing structures need to be retrofitted to accommodate berthing of higher Dead Weight Tonnage (DWT) vessels. This paper presents the Finite element analysis, to study the behavior of retrofitted RC Pile specimens strengthened with Glass Fiber Reinforced Polymer (GFRP) composites using commercial software ANSYS. Experiments were also conducted to justify the finite element analysis results. Eight RC pile specimens were cast with same reinforcement details to study the behavior under different loading conditions. Four specimens were used as control and remaining four were retrofitted with GFRP fabric. The effect of retrofitting on RC pile specimens was studied. The load deflection and load strain plots obtained from numerical study is compared with the experimental plots. The crack patterns in the pile specimens are also presented. A parametric study is carried out to investigate the effect of various parameters on the strength of RC piles. The parameters include unconfined concrete strength, the steel ratio and the thickness of FRP.
Similar content being viewed by others
References
Fanning, P. (2001). “Nonlinear models of reinforced and post-tensioned concrete beams.” Elect. J. Struc. Engrg., Vol. 2, pp. 111–119.
Kachlakev, D., Thomas, M., and Yim, S. (2001). Finite Element modeling of reinforced concrete structures strengthened with FRP laminates, Report for Oregon Department of Ransportation, Salem.
Lau, K.T. and Zhou, L.M. (2001). “The Mechanical behavior of composite-wrapped concrete cylinders subjected to uniaxial compression load.” J. Comp. Struc., Vol. 52, pp. 189–198.
Li, G.K., Su-Seng, P.S., Helms, J.E., and Stubblefield, M.A. (2003). “Investigation into FRP repaired RC columns.” J. Comp. Struc., Vol. 62, pp. 83–89.
Monti, N.N. and Silvia S. (2001). “Design of FRP jackets for upgrading of circular bridge piers.” J. Comp. Const., ASCE, Vol. 5, No. 2, pp. 94–101.
Omar, C., Mohesen, S., and Munzer, H. (2003). “Performance of axially loaded short rectangular columns strengthened with carbon fiber-reinforced polymer wrapping.” J. Comp. Const., ASCE, Vol. 7, No.3, pp. 200–208.
Saadatmanesh, H., Ehasani, M.R., and Jin, L. (1996). “Seismic strengthening of circular bridge pier models with fiber composites.” Struc. J., ACI, Vol. 93, No. 6, pp. 639–647.
Tedesco, J.W., Stallings J.M., and El-Mihilmy, M. (1999). “Finite element method analysis of a concrete bridge repaired with fiber reinforced plastic laminates.” Compu. Struc., Vol. 72, pp. 379–407.
Vistasp, M.K. and Yanqiang, G. (1997). “Composite jacketed concrete under uniaxial compression-verification of simple design equation.” J. Mat. Civil Engrg., ASCE, Vol. 9, No. 4, pp. 185–192.
Wolanski, A.J. (2004). Flexural behavior of reinforced and prestressed concrete beams using finite element analysis, MS Thesis, Marquette University, Wisconsin, United States.
Xiao, Y. and Wu, H. (2000). “Compressive behavior of concrete confined by carbon fiber composite jackets.” J. Ma. Civil Engrg., ASCE, Vol. 12, No. 2, pp. 139–145.
Yan, Z., Pantelides, C.P., and Reaveley, L.D. (2006). “Fiber-reinforced polymer jacketed and shape-modified compression members: Iexperimental behavior.” Struc. J., ACI, Vol. 103, No. 6, pp. 885–893.2.
Yan, Z. and Pantelides, C.P. (2006). “Fiber-reinforced polymer jacketed and shape-modified compression members: II-model.” Struc. J., ACI, Vol. 103, No. 6, pp. 894–903.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Purushotham Reddy, B., Alagusundaramoorthy, P. & Sundaravadivelu, R. Retrofitting of RC piles using GFRP composites. KSCE J Civ Eng 13, 39–47 (2009). https://doi.org/10.1007/s12205-009-0039-2
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12205-009-0039-2