Abstract
The aim of this paper is to investigate, using finite element analysis, a possible cause of fatigue failure due to the pick of an ice axe impacting a semi-rigid surface This simulates the pick striking a thin layer of ice covering rock. The technical ice axes used by climbers for ice wall climbing are subjected to a number of different loading situations in use. These can result in high stresses being generated. The geometry of the ice axe pick consists of a series of teeth along the bottom surface, which bite into the ice to give the mountaineer purchase when climbing. The tooth profile is such that, at the root, they would act as points of high stress concentrations in the presence of tensile stresses. However the stresses at the root of the tooth are generally compressive for most load cases. However, there have been recorded instances where an ice axe pick has failed in use due to fatigue with the crack being initiated at the root of a tooth. The requirement for a fatigue failure is a cyclic load which has at some point a tensile stress present. As part of an initial study a transient dynamic finite element analysis was carried out on the geometry of an ice axe pick striking a semi-rigid surface. The pick was assumed to strike at velocity of 9m/s at an angle to the tip of 20°. It was assumed that the pick was manufactured from steel and both elastic and plastic properties modelled. The impact surface was given the physical properties of granite and was considered to be flat. A two-dimensional analysis was carried out. Only the pick of the axe was modelled, the adze and handle ignored. It was assumed that the pick was rigidly held at the junction with the ice axe handle. To model the impact the surface was given an initial velocity and a mass of 0.7kg, which was the total mass of the ice axe. The analysis revealed that a compressive failure occurred at the tip of the ice axe pick causing the characteristic rounding of the pick tip (blunting). The stress at the root of the teeth nearest to the tip of the pick yielded in compression, which resulted in a tensile residual stress in the unloaded pick. Each successive impact would therefore result in a tensile-compressive stress cycle which is conducive to fatigue failure.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
Preview
Unable to display preview. Download preview PDF.
References
Fyffe A. and Peter, I. (1995) The handbook of climbing, Pelham Books, pp175–205 and pp215–228
Haake S.J., Blackwood, W.D., and Yoxall A. (1997) Photoelastic analysis of ice-axe impacts. Proc. SPIE The Internationals Society for Optical Engineering. 3111, pp 482–489
Hellen, T. (1999) The engineering stability of metallic climbing equipment. In: N. Messenger, W. Patterson and D. Brookes (Eds.), The Science of Climbing and Mountaineering. Human Kinetics, Chapter 15.
Peters, J.O., Boyce, B.L., Chen, X., McNancy, J.M., Hutchinson, W. and Ritchie R.O. (2002) On the application of the Kitagawa-Takahashi diagram to foreign object damage and high cycle fatigue. Engineering fracture mechanics 69, 1425–1446
Author information
Authors and Affiliations
Rights and permissions
Copyright information
© 2006 Springer Science+Business Media, LLC
About this paper
Cite this paper
Gordon, R., Franklin, K. (2006). Finite Element Simulation of Ice Axe Pick Impact on a Semi-Rigid Surface. In: The Engineering of Sport 6. Springer, New York, NY. https://doi.org/10.1007/978-0-387-46051-2_21
Download citation
DOI: https://doi.org/10.1007/978-0-387-46051-2_21
Publisher Name: Springer, New York, NY
Print ISBN: 978-0-387-34678-6
Online ISBN: 978-0-387-46051-2
eBook Packages: EngineeringEngineering (R0)