Abstract
In this study, some of the widely used data for elevation models were compared based on hydrological parameters such as slope, aspect, flow direction, and slope length and steepness factor (LS factor). The study considers the comparison among ASTER GDEM, SRTM DEM, topographic maps, and aerial photography at 430239 predetermined tests points. Bilinear interpolation technique was used to interpolate the data at these testing points. The result shows the digital elevation model (DEM) from topographic maps has relatively higher vertical accuracy (RMSE = 5.40 m), compared to ASTER GDEM (7.10 m) and SRTM DEM (15.07 m), while comparing with digital surface model (DSM) from stereo pairs. For validation, we used 47 ground control points (GCPs) using GPS. The results show the vertical accuracy are relatively higher for DSM (RMSE = 1.11 m), followed by DEMs from topographic maps (4.10 m), ASTER GDEM (7.36 m), and SRTM DEM (12.22 m). The DSM matches closely with the result of topographic DEM in case of slope, LS factor curves, aspect, and flow direction. The result with ASTER DEM matches better than results with SRTM data in all the parameters but both of them show poor match with the results from DSM data.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
References
Deilami BR, Al-Saffar MRA, Sheikhi A, Bala MI, Arsal D (2013) Comparison of surface flows derived from different resolution DEM. Int J Eng & Technol IJET-IJENS 13(1)
Garbrecht J, Martz LW (1999) Digital elevation model issues in water resource modeling. In: Proceedings of the 19th ESRI international user conference presentation, San Diego, CA
Horning N et al (2010) Remote sensing for ecology and conservation. Oxford University Press, New York
Thomas J, Prasannakumar V, Vineetha P (2015) Suitability of spaceborne digital elevation models of different scales in topographic analysis: an example from Kerala, India. Environ Earth Sci 73:1245–1263. https://doi.org/10.1007/s12665-014-3478-0
Florinsky IV (1998) Accuracy of local topographic variables derived from digital elevation models. Int J Geogr Inf Sci 12(1):47–62. https://doi.org/10.1080/136588198242003
Wu S, Li J, Huang GH (2008) A study on DEM-derived primary topographic attributes for hydrologic applications: sensitivity to elevation data resolution. Applied Geogr 28(3):210–223. https://doi.org/10.1016/j.apgeog.2008.02.006
Vaze J, Teng J, Spencer G (2010) Impact of DEM accuracy and resolution on topographic indices. Environ Model Software 25(10):1086–1098. https://doi.org/10.1016/j.envsoft.2010.03.014
Pakoksung K, Takagi M (2016) Digital elevation models on accuracy validation and bias correction in vertical. Model Earth Syst Environ 2:11. https://doi.org/10.1007/s40808-015-0069-3
Jarvis A, Rubiano J, Nelson A, Farrow A, Mulligan M (2004) Practical use of SRTM data in the tropics: comparisons with digital elevation models generated from cartographic data. International Centre for Tropical, Agriculture (CIAT), Cali, p 32
Miliaresis GC, Paraschou CVE (2005) Vertical accuracy of the SRTM DTED level 1 of Crete. Int J Appl Earth Obs Geoinform 7:49–59
Hirt C, Filmer MS, Featherstone WE (2010) Comparison and validation of the recent freely available ASTER-GDEM ver1 SRTM ver4.1 and GEODATA DEM-9 s ver3 digital elevation models over Australia. Aust J Earth Sci 57:337–347
Kolecka N, Kozak J (2013) Assessment of the accuracy of SRTM C-and X-band high mountain elevation data: a case study of the Polish Tatra Mountains. Pure Appl Geophys. https://doi.org/10.1007/s00024-013-0695-5
Forkuor G, Maathuis B (2012) Comparison of SRTM and ASTER derived digital elevation models over two regions in Ghana: implications for hydrological and environmental modeling. In: Piacentini T (ed) Studies on environmental and applied geomorphology. InTech, Rijeka, pp 219–240
Nikolakopoulos KG, Kamaratakis EK, Chrysoulakis N (2006) SRTM vs. ASTER elevation products comparison for two regions in Crete, Greece. Int J Remote Sens 27:4819–4838
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2020 Springer Nature Singapore Pte Ltd.
About this paper
Cite this paper
Al Balasmeh, O.I.M., Karmaker, T. (2020). Accuracy Assessment of the Digital Elevation Model, Digital Terrain Model (DTM) from Aerial Stereo Pairs and Contour Maps for Hydrological Parameters. In: Ghosh, J., da Silva, I. (eds) Applications of Geomatics in Civil Engineering. Lecture Notes in Civil Engineering , vol 33. Springer, Singapore. https://doi.org/10.1007/978-981-13-7067-0_35
Download citation
DOI: https://doi.org/10.1007/978-981-13-7067-0_35
Published:
Publisher Name: Springer, Singapore
Print ISBN: 978-981-13-7066-3
Online ISBN: 978-981-13-7067-0
eBook Packages: EngineeringEngineering (R0)