Skip to main content

Dual Fuel (Natural Gas Diesel) for Light-Duty Industrial Engines: A Numerical and Experimental Investigation

  • Chapter
  • First Online:
Natural Gas Engines

Abstract

This paper reviews the main results of a numerical and experimental activity, carried out on an automotive four-cylinder, common rail, 2.8 L turbocharged diesel engine, Euro IV compliant. The purpose of the project is to convert this engine, with minor hardware modifications, in order to operate in compression ignition (CI) dual-fuel (DF) mode, using natural gas (NG) as the main source of energy. The diesel injector will keep the only function to ignite the homogeneous air–NG mixture within the cylinder, injecting just a small quantity of diesel fuel. In this way, soot emissions can be almost completely eliminated, and the after-treatment system can be strongly simplified (then, its cost reduced). Other fundamental advantages in the use of NG instead of diesel are the lower emission of CO2 (provided that brake efficiency is not reduced when running on DF) and the lower concentration of nitrogen oxides (NOx). This DF engine would be particularly suitable for light-duty industrial applications (power generators, small tractors, and off-road vehicles) and boats, where the installation of an additional fuel system is not limited by tight constraints. The experimental activity is supported by a comprehensive theoretical study, carried out through CFD simulation (both 1D and 3D). The numerical models are first calibrated for the standard combustion mode and then applied to get the guidelines for the development and calibration of the physical prototype. The most relevant experimental result is obtained at 3000 rpm, BMEP = 12 bar, where the DF engine can work with just a 20% of the diesel fuel required for standard operations. The following advantages are found: (1) complete elimination of soot; (2) 26% reduction of NOx; (3) 25% reduction of CO2; (4) slight improvement of brake efficiency. The only downside is the strong increase in HC and CO concentrations, which are about ten times higher. However, this issue can be addressed installing a cost-effective oxidation catalyst.

This is a preview of subscription content, log in via an institution to check access.

Access this chapter

Chapter
USD 29.95
Price excludes VAT (USA)
  • Available as PDF
  • Read on any device
  • Instant download
  • Own it forever
eBook
USD 129.00
Price excludes VAT (USA)
  • Available as EPUB and PDF
  • Read on any device
  • Instant download
  • Own it forever
Hardcover Book
USD 169.99
Price excludes VAT (USA)
  • Durable hardcover edition
  • Dispatched in 3 to 5 business days
  • Free shipping worldwide - see info

Tax calculation will be finalised at checkout

Purchases are for personal use only

Institutional subscriptions

References

  • Abd Alla GH, Soliman HA Badr OA Abd Rabbo MF (2000) Effect of pilot fuel quantity on the performance of a dual fuel engine. Energy Convers Manag 41(6):559–572

    Google Scholar 

  • Abd Alla GH, Soliman HA, Badr OA, Abd Rabbo MF (2002) Effect of injection timing on the performance of a dual fuel engine. Energy Convers Manag 43(2):269–277

    Google Scholar 

  • Abdelaal MM, Hegab AH (2012) Combustion and emission characteristics of a natural gas-fueled diesel engine with EGR. Energy Convers Manag 64(0):301–312

    Google Scholar 

  • Amsden AA (1997) KIVA-3V: a block-structured KIVA program for engines with vertical or canted valves. Report number: LA-13313-MS. Los Alamos National Labs, NM (USA)

    Google Scholar 

  • Egusquiza JC, Braga SL, Braga CVM (2009) Performance and gaseous emissions characteristics of a natural gas/diesel dual fuel turbocharged and aftercooled engine. J Braz Soc Mech Sci Eng 31(2):142–150

    Google Scholar 

  • Gamma Technologies (2016) GT-SUITE v2016 user’s manual. Westmont, IL (USA)

    Google Scholar 

  • Golovitchev VI, Imren A (2013) Development of dual fuel combustion models for direct injected heavy duty diesel engines. In: Diesel fuels: characteristics, performances and environmental impacts. Nova Pusblisher. ISBN 978-1-62618-867-9

    Google Scholar 

  • Golovitchev VI, Nordin N, Jarnicki R, Chomiak J (2000) 3-D diesel spray simulations using a new detailed chemistry turbulent combustion model. SAE paper 2000-01-1891

    Google Scholar 

  • Gustavsson J, Golovitchev VI (2003) Spray combustion simulation based on detailed chemistry approach for diesel fuel surrogate model. SAE paper 2003-01-1848

    Google Scholar 

  • Harrod KS, Jaramillo RJ et al (2005) Inhaled diesel engine emissions reduce bacterial clearance and exacerbate lung disease to pseudomonas aeruginosa infection in vivo. Toxicol. Sci. 83(1):155–165

    Google Scholar 

  • Imran S, Emberson DR, Ihracska B, Wen DS, Crookes RJ, Korakianitis T (2014) Effect of pilot fuel quantity and type on performance and emissions of natural gas and hydrogen based combustion in a compression ignition engine. Int J Hydrog Energy 39(10):5163–5175

    Article  Google Scholar 

  • Krishnan SR, Srinivasan KK, Singh S, Bell SR, Midkiff KC, Gong W et al (2004) Strategies for reduced NOx emissions in pilot-ignited natural gas engines. J Eng Gas Turbines Power Trans ASME 126(3):665–671

    Article  Google Scholar 

  • Liao SY, Jiang DM, Cheng Q (2004) Determination of laminar burning velocities for natural gas. Fuel 83:1247–1250

    Article  Google Scholar 

  • Liu SH, Wang ZY, Ren J (2003) Development of compressed natural gas/diesel dual-fuel turbocharged compression ignition engine. Proc Inst Mech Eng D J. Automob Eng 217(D9):839–845

    Google Scholar 

  • Liu J, Yang F, Wang HW, Ouyang MG, Hao SG (2013) Effects of pilot fuel quantity on the emissions characteristics of a CNG/diesel dual fuel engine with optimized pilot injection timing. Appl Energy 110(0):201–206

    Google Scholar 

  • Lloyd AC, Cackette TA (2001) Diesel engines: environmental impact and control. J Air Waste Manag Assoc 51(6):809–847

    Article  Google Scholar 

  • Lounici MS, Loubar K, Tarabet L, Balistrou M, Niculescu DC, Tazerout M (2014) Towards improvement of natural gas–diesel dual fuel mode: an experimental investigation on performance and exhaust emissions. Energy 64:200–211

    Article  Google Scholar 

  • Lutz AE, Kee JR, Miller JA (1997) SENKIN: a Fortran program for predicting homogeneous gas phase chemical kinetics with ensitivity analysis. SANDIA National Laboratories’ document SAND87-8248

    Google Scholar 

  • Papagiannakis RG, Hountalas, DT (2003) Experimental investigation concerning the effect of natural gas percentage on performance and emissions of a DI dual fuel diesel engine. Appl Therm Eng 23(3):353–365

    Google Scholar 

  • Papagiannakis RG, Hountalas DT (2004) Combustion and exhaust emission characteristics of a dual fuel compression ignition engine operated with pilot diesel fuel and natural gas. Energy Convers Manag 45(18–19):2971–2987

    Google Scholar 

  • Papagiannakis RG, Rakopoulos CD, Hountalas DT, Rakopoulos DC (2010) Emission characteristics of high speed, dual fuel, compression ignition engine operating in a wide range of natural gas/diesel fuel proportions. Fuel 89(7):1397–1406

    Google Scholar 

  • Patterson MA, Reitz RD (1998) Modeling the effects of fuel spray characteristics on diesel engine combustion and emission. SAE 980131

    Google Scholar 

  • Reşitoğlu İA, Altinişik K, Keskin A (2015) The pollutant emissions from diesel-engine vehicles and exhaust aftertreatment systems. Clean Technol Environ Policy 17(1):15–27

    Google Scholar 

  • Rinaldini CA, Mattarelli E, Golovitchev VI (2013a) Potential of the Miller cycle on a HSDI diesel automotive engine. Appl Energy 112:102–119

    Article  Google Scholar 

  • Rinaldini CA, Mattarelli E, Golovitchev VI (2013b) CFD-3D analysis of a light duty dual fuel (diesel/natural gas) combustion engine. In: Energy precedia 00 (2013) 12647, 68th conference of the Italian thermal machines engineering association, ATI2013

    Google Scholar 

  • Singh S, Krishnan S, Srinivasan K, Midkiff K, Bell S (2004) Effect of pilot injection timing, pilot quantity and intake charge conditions on performance and emissions for an advanced low-pilot-ignited natural gas engine. Int J Eng Res 5(4):329–348

    Article  Google Scholar 

  • Wannatong K, Akarapanyavit N, Siengsanorh S, Chanchaona S (2007) Combustion and knock characteristics of natural gas diesel dual fuel engine. SAE technical paper 2007–01–2047

    Google Scholar 

  • Wei L, Geng P (2016) A review on natural gas/diesel dual fuel combustion, emissions and performance. Fuel Process Technol 142:264–278. ISSN 0378-3820

    Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Enrico Mattarelli .

Editor information

Editors and Affiliations

Rights and permissions

Reprints and permissions

Copyright information

© 2019 Springer Nature Singapore Pte Ltd.

About this chapter

Check for updates. Verify currency and authenticity via CrossMark

Cite this chapter

Mattarelli, E., Rinaldini, C.A., Savioli, T. (2019). Dual Fuel (Natural Gas Diesel) for Light-Duty Industrial Engines: A Numerical and Experimental Investigation. In: Srinivasan, K., Agarwal, A., Krishnan, S., Mulone, V. (eds) Natural Gas Engines . Energy, Environment, and Sustainability. Springer, Singapore. https://doi.org/10.1007/978-981-13-3307-1_11

Download citation

  • DOI: https://doi.org/10.1007/978-981-13-3307-1_11

  • Published:

  • Publisher Name: Springer, Singapore

  • Print ISBN: 978-981-13-3306-4

  • Online ISBN: 978-981-13-3307-1

  • eBook Packages: EnergyEnergy (R0)

Publish with us

Policies and ethics