Abstract
Solar thermal systems are one of the renewable energy systems used in the residential buildings for the heating purpose, and with these systems, the usage of non-renewable energy resources decreases. To improve the performance of solar collectors, engineers and scientists are regularly working on it. Direct absorption-based solar thermal collectors (DASTC) are kind of solar collectors in which the fluid can be heated directly (without any absorption surface). The present study deals with numerical model of direct absorption-based solar collector which can be used for residential purposes. The absorbed energy fraction, effect of the height, length of collector, and mass flow rate on the collector efficiency have been determined. The analysis shows that collector efficiency increases with the increase of mass flow rate when the height of the fluid in the collector is same and the efficiency of the collector deceases with the increase of channel length. Further, it has been observed that it is beneficial to use an optimum volume fraction of the nanoparticles in DASTC because at an optimum volume fraction, the collector achieved maximum efficiency.
Keywords
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
Abbreviations
- A :
-
Area
- C p :
-
Specific heat
- D :
-
Diameter
- f v :
-
Volume fraction
- G T :
-
Incident solar flux on the collector, 1000 W/m2
- H :
-
Height
- HTE :
-
Heat transfer equation
- h :
-
Convective heat transfer coefficient
- I :
-
Intensity
- k :
-
Thermal conductivity
- K :
-
Radiative constant
- L :
-
Length
- \( \dot{m} \) :
-
Mass flow rate
- \( p\left( {\varOmega^{{\prime }} \to \varOmega } \right) \) :
-
Phase function
- q r :
-
Radiative heat flux
- RTE :
-
Radiative transfer equation
- T :
-
Temperature
- T solar :
-
Black body temperature
- y :
-
Depth of penetration
- η :
-
Collector efficiency
- ρ :
-
Density
- Ω :
-
Solid angle
- a :
-
Absorption
- b :
-
Blackbody
- e :
-
Extinction
- λ:
-
Spectral
- s :
-
Scattering
- ∞ :
-
Ambient
- in:
-
Inlet
- out:
-
Outlet
- min:
-
Minimum
- max:
-
Maximum
References
Dincer I (2000) Renewable energy and sustainable development: a crucial review. Renew Sustain Energy Rev 4(2):157–175
Tyagi H, Phelan P, Prasher R (2009) Predicted efficiency of a low-temperature nanofluid-based direct absorption solar collector. J Sol Energy Eng 131(4):41004
Otanicar TP, Phelan PE, Prasher RS, Rosengarten G, Taylor RA (2010) Nanofluid-based direct absorption solar collector. J Renew Sustain Energy 2(3)
Taylor RA, Phelan PE, Otanicar TP, Walker CA, Nguyen M, Trimble S, Prasher R (2011) Applicability of nanofluids in high flux solar collectors. J Renew Sustain Energy 3(2):23104
Lenert A, Wang EN (2012) Optimization of nanofluid volumetric receivers for solar thermal energy conversion. Sol Energy 86(1):253–265
Chen M, He Y, Zhu J, Kim DR (2016) Enhancement of photo-thermal conversion using gold nanofluids with different particle sizes. Energy Convers Manag 112:21–30
Luo Z, Wang C, Wei W, Xiao G, Ni M (2014) Performance improvement of a nanofluid solar collector based on direct absorption collection (DAC) concepts. Int J Heat Mass Transf 75:262–271
Khullar V, Tyagi H, Hordy N, Otanicar TP, Hewakuruppu Y, Modi P, Taylor RA (2014) Harvesting solar thermal energy through nanofluid-based volumetric absorption systems. Int J Heat Mass Transf 77:377–384
Bhalla V, Tyagi H (2017) Solar energy harvesting by cobalt oxide nanoparticles, a nanofluid absorption based system. Sustain Energy Technol Assessments 1–10
Gorji TB, Ranjbar AA (2016) A numerical and experimental investigation on the performance of a low-flux direct absorption solar collector (DASC) using graphite, magnetite and silver nanofluids. Sol Energy 135:493–505
Hordy N, Rabilloud D, Meunier JL, Coulombe S (2014) High temperature and long-term stability of carbon nanotube nanofluids for direct absorption solar thermal collectors. Sol Energy 105:82–90
Sani E, Mercatelli L, Barison S, Pagura C, Agresti F, Colla L, Sansoni P (2011) Potential of carbon nanohorn-based suspensions for solar thermal collectors. Sol Energy Mater Sol Cells 95(11):2994–3000
Chen N, Ma H, Li Y, Cheng J, Zhang C, Wu D, Zhu H (2017) Complementary optical absorption and enhanced solar thermal conversion of CuO-ATO nanofluids. Sol Energy Mater Sol Cells 162(Nov 2016):83–92
Sufian MM, Khattak JZK, Yousaf S, Rana MS (2017) Safety issues associated with the use of nanoparticles in human body. Photodiagnosis Photodyn Ther 19:67–72
Drotning WD (1978) Optical properties of solar-absorbing oxide particles suspended in a molten salt heat transfer fluid. Sol Energy 20(4):313–319
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2018 Springer Nature Singapore Pte Ltd.
About this chapter
Cite this chapter
Bhalla, V., Khullar, V., Singh, H., Tyagi, H. (2018). Solar Thermal Energy: Use of Volumetric Absorption in Domestic Applications. In: Tyagi, H., Agarwal, A., Chakraborty, P., Powar, S. (eds) Applications of Solar Energy. Energy, Environment, and Sustainability. Springer, Singapore. https://doi.org/10.1007/978-981-10-7206-2_6
Download citation
DOI: https://doi.org/10.1007/978-981-10-7206-2_6
Published:
Publisher Name: Springer, Singapore
Print ISBN: 978-981-10-7205-5
Online ISBN: 978-981-10-7206-2
eBook Packages: EnergyEnergy (R0)