High pH Corrosion of Prestressing Steel in Segregated Grout

  • Luca Bertolini
  • Maddalena Carsana
Conference paper
Part of the RILEM Bookseries book series (RILEM, volume 5)


Protection of prestressing tendons in post-tensioned structures can be ensured by the injection of a grout in the duct; since contact with hardened cement paste provides the conditions for passivity of steel. If ducts are fully injected corrosion protection may be guaranteed for a very long time thanks to the alkalinity of the grout, unless incomplete filling of the duct (and thus the lack of grout in contact with steel) or to penetration of chlorides through defects of sheath or to the heads of prestress occur. Recently, however, cases were reported where severe corrosion conditions took place in correspondence of areas where the grout was segregated. This phenomenon occurred mainly in the highest parts of external prestressing tendons with polyethylene ducts, where a whitish segregated grout was found, characterized by an alkaline pH and high content of sulphate ions. The corrosion attack encountered in these areas appeared much localized and, in some case, led to the failure of prestressing tendons; however, the mechanism of this type of corrosion has not yet been clarified. In order to investigate the corrosion of prestressing strands in segregated grout, corrosion tests were made in the laboratory. The results of tests suggest a complex mechanism which induces initiation of corrosion in the interstices among wires where the availability of oxygen is low. Subsequently propagation of localised attack is favoured by a macrocell that generates between the small depassivated areas and the surrounding passive areas.


Steel Wire Corrosion Test Crevice Corrosion Corrosion Attack Corrosion Initiation 
These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.


Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.


  1. 1.
    Bertolini L., Elsener B., Pedeferri P., Polder R. (2004), Corrosion of steel in concrete - Prevention, diagnosis, repair, Wiley-VCH.Google Scholar
  2. 2.
    FIB Bulletin No. 33 (2005), Durability of post-tensioning tendons.Google Scholar
  3. 3.
    Godart B. (2001), Status of durability of post-tensioned tendons in France, in Proc. of FIB Workshop Durability of post-tensioning tendons, Ghent, 15-16 November 2001, pp. 25-42.Google Scholar
  4. 4.
    Lecinq B. (2004), Recent research in France for the improvement of cement grouting, in Proc. of 2nd Workshop on “Durability of post-tensioning tendons”, 11-12 October 2004, ETH, Zürich.Google Scholar
  5. 5.
    Pourbaix M. (1974), Atlas of electrochemical corrosion, NACE.Google Scholar
  6. 6.
    Pourbaix M. (1973), Lectures on electrochemical corrosion, Plenum Press.Google Scholar
  7. 7.
    Shreir, L.L., Jarman, R.A., Burnstein G.T. (1995), Corrosion, 3rd Edition, Butterworth-Heinemann.Google Scholar

Copyright information

© RILEM 2011

Authors and Affiliations

  • Luca Bertolini
    • 1
  • Maddalena Carsana
    • 1
  1. 1.Dipartimento di ChimicaMateriali e Ingegneria Chimica “G. Natta”, Politecnico di MilanoMilanItaly

Personalised recommendations