Abstract
This paper outlines the basic principle of a predictive control system, and shows how this can be used for controlling temperature set-back in buildings where a heat pump is an integrated part of the heating system.
Because of the heat pump’s distinctive character, it sets special requirements for the control system to save exergy. The predictive controller satisfies these requirements, and takes, unlike traditional bang-bang control, into account the heat pump’s capability to conserve exergy.
Process knowledge in the form of a dynamic mathematical model is integrated in the controller, and an optimization algorithm finds the control trajectory that minimize the cost of exergy consumption. The Kuhn-Tucker conditions verify a strong active constraint which consists of a maximum utilization of the heat pump, and a minimum utilization of the auxiliary heater. This result can be used to simplify both the solution of the optimization problem, and the mathematical model.
Different control structures are compared regarding exergy consumption, and it is shown how these control structures influence the various exergy losses in the heating system.
A sensitivity analysis is performed, where different process parameters such as heat exchanger areas, thermal capacity of the building and part load efficiency of the compressor, are varied. It is shown how these perturbations influence the optimal control trajectory.
Keywords
These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.
This is a preview of subscription content, log in via an institution.
Buying options
Tax calculation will be finalised at checkout
Purchases are for personal use only
Learn about institutional subscriptionsPreview
Unable to display preview. Download preview PDF.
References
Balchen, J.G. and Mummé, K.I. (1988). Process Control. Structures and Applications. Van Nostrand Rein-hold Co., New York.
Benton, R. (1983). Heat Pump Setback: Computer Prediction and Field Test Verification of Energy Savings with Improved Control. ASHRAE Transactions 89:1b 1983.
Bullock, C.E. (1978). Thermostat Setback and Residen-tal Heat Pumps. ASHRAE Journal, sept. 1978.
Edgar, T.F. and Himmelblau, D.M. (1988). Optimization of Chemical Processes. McGraw-Hill Book Co., New York.
Garcia, D.M. et all (1989). Model Predictive Control: Theory and Practice-a Survey. Automatica Vol. 25 No. 3 1989.
Harsem, T.T. (1986). Temperature set-back and its influence on the operation of heat pumps. SINTEF-rapport nr. STF A86047. Trondheim (Norway).
Hayes, D.K. (1979). Real Time Identification of Parameters in Building Models. International Congress Joint Meeting with the American Section of the I.S.E.S., Atlanta, Georgia. May 1979.
Ljung, L. and Söderström, T. (1985). Theory and Practice of Recursive Identification. The MIT Press, Cambridge, Massachusetts.
Luenberger, D. G. (1984). Linear and Nonlinear Programming. Addison-Wesley Pub. Co., Reading, Massachusetts.
Morari, M. (1988). Advances in Process Control Theory. Chem. Eng. Prog. 10 (1988).
Nowotny, S. (l980). Saving of Energy in Refrigeration. International Institute of Refrigeration, Paris.
Schade, G.R. (1978). Saving of Energy by Night Setback of a Residental Heat Pump System. ASHRAE Transactions 84: 1 (1978).
Sorenson, H.W. (1985). Kaiman Filtering: Theory and Application. IEEE PRESS, New York.
Stoecker, W.F. (1975). Procedures for Simulating the Performance of Components and Systems for Energy Calculations. ASHRAE Task Group on Energy Reqvire-ments for Heating and Cooling of Buildings.
Svensson, M.C. (1990). Optimization and Identification of Heat Pumps. Ph.D. Thesis. The Norwegian Institute of Technology. To be published.
Thorbergsen, E. (1985). PROSIM, a Program System Simulating Heat Pump Plants. IIR Commission E2 Trondheim (Norway) 1985.
Villadsen, V. (1985). Reciprocating Compressors for Refrigeration and Heat Pump Application. Int. J. Refrig. Vol 8 September 1985.
Author information
Authors and Affiliations
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 1991 Springer-Verlag Berlin Heidelberg
About this paper
Cite this paper
Svensson, C. (1991). Predictive Control of a Hybrid Heating System Including a Heat Pump. In: Smith, I.E. (eds) Applications and Efficiency of Heat Pump Systems. Springer, Berlin, Heidelberg. https://doi.org/10.1007/978-3-662-30179-1_16
Download citation
DOI: https://doi.org/10.1007/978-3-662-30179-1_16
Publisher Name: Springer, Berlin, Heidelberg
Print ISBN: 978-3-662-30181-4
Online ISBN: 978-3-662-30179-1
eBook Packages: Springer Book Archive