Abstract
This paper proposes a new zero-crossing point detection method for BLDCM without using the position sensor. Regarding phase current and phase back-EMF as state variables, the observer model of the phase back-EMF could be obtained from derivation of the mathematical model of BLDCM. This observation model could observe the value of the phase back-EMF real-timely, and the zero-crossing point could be directedly detected through measuring the back- EMF at high speed. But the phase back-EMF is relatively smaller at low speed, and it is possible to cause unexpected commutation. A kind of zero-crossing point detection method is proposed based on this model for low-speed control. Combining the observation model and the zero-crossing point detection method, it could realize the zero-crossing point detection of the BLDC in full speed range. The simulation and experimental results show the feasibility of this method.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
Preview
Unable to display preview. Download preview PDF.
References
An, Q., Sun, L., Liu, C., et al.: Flux Linkage Self-control Based Direct Torque Control of Brushless DC Motor. Proceedings of the CSEE 25(12), 86–92 (2010)
Ogasawara, S., Akagi, H.: An Approach to Position Sensorless Drive for Brushless dc Motors. IEEE Trans. on Industry Applications 27(5), 928–933 (1991)
Li, X., Zhu, Z., Zhao, H.: A position sensorless motion control system of Brushless DC Motor motor based on sliding mode observer. Journal of Circuits and Systems 14(2), 79–83 (2009)
Yang, G., Li, X.-F.: Research on the Detection of BLDCM Rotor Position by Checking Zero-crossing of Back-EMF. Power Electronics 4(10), 18–20 (2008)
Kim, T.-S., et al.: A New Approach to Sensorless Control Method for Brushless DC Motors. International Journal of Control, Automation, and Systems 6(4), 477–487 (2008)
Author information
Authors and Affiliations
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2011 Springer-Verlag Berlin Heidelberg
About this paper
Cite this paper
Lei, P., Beibei, W., Wei, G. (2011). A Novel Method for BLDCM Control Based on Phase Back-EMF Observation. In: Tan, H. (eds) Informatics in Control, Automation and Robotics. Lecture Notes in Electrical Engineering, vol 132. Springer, Berlin, Heidelberg. https://doi.org/10.1007/978-3-642-25899-2_13
Download citation
DOI: https://doi.org/10.1007/978-3-642-25899-2_13
Published:
Publisher Name: Springer, Berlin, Heidelberg
Print ISBN: 978-3-642-25898-5
Online ISBN: 978-3-642-25899-2
eBook Packages: EngineeringEngineering (R0)